Find trusted local electricians in West Melbourne

Licensed Electrician Needed – Supply Line Reconnection + Mains & Meter Box Replacement (Altona) Single‑storey tiled‑roof home in Altona. Today the overhead supply line detached at the fascia‑mounted junction box. Powercor attended, isolated supply and issued a fault notice. They identified issues with: • Point of attachment • Private cable from POA to meter box • Meter box condition • Consumer mains from meter box to switchboard Scope of work: • Replace consumer mains from point of attachment back to meter box • Replace meter box (Powercor recommended abolishment/replacement due to condition) • Re-run mains from meter box to new, compliant switchboard • Verify earthing/bonding (note: earth stake has been recently upgraded) • Handle liaison with Powercor for reconnection once works are complete Property details: • Single‑storey brick veneer, tiled roof • Overhead supply • Controlled load + single rate meter (happy to retain these) • Clear access to fascia and meter location Please include in your quote/message: • Whether you manage the abolishment + reconnection paperwork with Powercor • Estimated timeline for works + reconnection • Any assumptions about cable route, meter type, or roof access • REC + A‑Grade licence details • Whether you foresee any additional compliance work beyond mains + meter box Photos of the point of attachment and Powercor fault sheet available. Seeking someone experienced with service upgrades and distributor connections.

Install 2 light outside of a weatherboard house

Inside unit to be placed above a window on the ground floor. Outside unit to go either above the hot water tank or on top of the garage (pictures attached).

Need help for a quick safety check and switch on two Gas Water Heaters. Both units are at the same location. Model in photo. Needs to be done urgently.

I’m looking for a experienced tradie to: • Go into the ceiling space • Install a new power point in the ceiling for a projector • Install and mount a Hisense projector using a ceiling mount (mount supplied) • Connect and test to confirm it’s working properly Details: • Location: Point Cook • Double storey house • Ceiling access available • Projector and mount will be provided • You will need your own tools and ladder I need this done as early as possible. Please quote including labour and any additional materials required (cabling, fixings, etc.). Let me know your availability.

Need a qualified electrician. Need led to strip lighting for floating steps. Need some electrical provisions for spotlights to be added post land scraping Need 3 wall lights installed at the front. Junction boxes already installed around property so power is available to be wired from there. Must supply lighting for steps and spotlights. We will provide lighting for the building walls.

Air bed double needs a hole repaired Need to find hole and repair it Photo of bed with no hole the one that needs repaired slightly bigger bed

I am looking for someone to change over some existing power points, light switches, install 1 new power point and cutoff some smoke detectors. I will supply all materials so you only need to quote for labour. In total it is Change over 14 power points Install 1 x new power point change over 5 x light switches Install 3 smoke detectors and breaker to existing cabling. Connect 1 x LED Mirror and install switch for it. Change over 1 x Light fitting Powerpoints Change over Change over 14 power points in existing locations. This is just remove the old powerpoint and put the new one on. I will supply the specific powerpoint Install 1 new power point. This is in the bathroom. There is currently a powerpoint higher on the wall in the LED Mirror Cabinet. The power point to be installed is directly below this. Distance is 1m. I put in a draw wire when we had the plaster off. Light switches Change over light switch locations. 2 x single 2 x double 1 x 4 switches LED Mirror The mirror is already hung on the wall. Will need a switch installed next to current powerpoint. Smoke Detectors new cabling was installed for smoke detectors which I have a certificate for. Needs smoke detectors fitted off and a breaker installed in switchboard. Light Fitting Change over 1 light fitting. A certificate is a must have. Please only bid if you are a registered electrician. Money will not be released until the certificate is provided as I have had to chase people for months in the past.

My LG split system air conditioner showing error code CH44. After checking the outdoor unit, I found a broken wire. I’m assuming it may be related to a thermostat sensor issue, need a qualified technician to repair. Thanks

Need 2 pendant lights installed in our kitchen and dining area. Pendant lights and bulbs provided. NEED DONE TODAY THANK YOU

need a power point and connection for electric cooktop in the kitchen of a new house from the main line .

Require cable to be ran from an exiting outdoor light to 4 locations on a patio so down-lights can be connected on ceiling is installed. Existing light doesn’t need to be reinstalled.

I need a PowerPoint and to install tv bracket and a 55 inch TV on my wall. Single story home and I want the power point behind the TV.

I would like to enquire about installing a new power point for the entertainment unit.

Metal part in medical chair has broken due to wear and tear over time.

Need to change the light and fix the dimmable to connect with the wires

Replace the two smoke alarms with existing ones due to current ones being expired. I am happy to supple the 2 smoke alarms.

Install 5 set of double power sockets, 1 set of triple power sockets on existing internal garage walls. 1- Supply and install 5 sets of double power sockets, 1 set of triple power sockets. Surface-mounted on existing internal garage walls, locations to be confirmed on site with owner. 2- Power sockets are to comply to Australian standard. Intended for home study use like laptops, study lights, computer monitor, printer). 3- Check if existing power circuit already has RCD protection at the switchboard or not. 4- Small garage size 5.5m x 2.85m. Socket are internal only and will garage is part of home, it is not exposed to weather. So using surface-mounting fittings is OK. 5- Test, label, and certify all new outlets with certificate. 6- If answer to 3 is "no", then provide optional quote: Ensure the circuit supplying the new outlets is protected by an RCD .

Qualified electrician needed to replace light switch with already purchased replacement.

Installation of 2 ceiling lights