Find trusted local electricians in Brisbane

I need an electrician to install 2x DC ceiling fans with LED lights. Fans are purchased.

Electrician Required We’re looking for a electrician to complete the following work at our home Scope of Work • Supply and install 2 new downlights. • Connect and install a new oven and cooktop (appliances supplied). • Supply and install LED strip lighting. • Supply and install 4 new power points. • Install dimmer switches for 2–3 existing downlights, as we find the current lighting a little too bright. Additional Information: • The kitchen wall cabinets above the window are yet to be installed. The LED strip lighting will need to be installed underneath them • 3 of the 4 new power points are in the locations shown in the attached photo. The fourth is for the laundry underneath the house. • We live in a Queenslander, so there is easy access underneath the house to run most of the cabling. • An existing gang switch has already been installed by our previous electrician for the 2 proposed downlights. • Oven and cooktop are supplied by us. Cheers

I stall 2 PowerPoints at a cafe.

Old ceiling fan has died. I have bought a new one and need the old one replaced. It has a light and remote.

Remove pigeon nests, clean the roof area, and install pigeon proofing around the solar panels. Please temporarily cover/block the drains during cleaning to prevent debris causing blockage. It is a 2 story house, so it will be working at height approximately min 6m above ground 76m length of pigeon proof on solar panel 160m2 of roof area approximately 70m of gutters length

I need a power point popped onto this kitchen wall, It’s a rental so can’t damage the tiles but they have agreed to a power point.

Install a small wall light in kitchen

Installation will require drilling through besser block wall and running the cable in a concealed skirting duct.

Needing a licensed electrician to isolate the power to the ensuite bathroom before we commence demolition for our bathroom renovation.

Looking for a licenced electrician switch has been damaged for kitchen appliances, exposing internal wiring and components. Hoping for inclose and repair

I need a three small electrical things done. 1. 2 lantern lights attached to the front of the garage (1 to each panel). Wiring is in place and ready to go. I have the lights. 2. PowerPoint installed for garage door. Wiring is in place and ready to go. 3. Sensor light to be installed. Wiring is in place and ready to go.

Licensed Electrician – Install LED Garage Light & Replace 2 Power Points Job Description: Looking for a qualified and licensed electrician to complete a small electrical job at my home. Work required: 1. Garage LED Light Installation * Install a new 40W LED batten light, replacing an old fluorescent fitting. * Old fitting has already been removed. * Existing wiring is accessible (see photos). * New LED fitting, mounting screws and wall plugs supplied. 2. Replace 2 Existing Power Points * Replace two standard double power points with new Jackson double power points featuring USB-A and USB-C charging ports. * New power points already purchased and supplied. * Straight replacements in existing locations. Additional Information: * All new fittings and materials mentioned above are supplied. * Easy access to both locations. * Electrician to provide necessary tools, complete installation safely and test all fittings. * Must hold a current Queensland electrical contractor licence. Looking for a competitive, fixed-price quote for this straightforward job. Flexible with timing and happy to work around your availability. Photos attached.

1. Relocate Smoke Alarm: Relocate 1 x existing 240V hardwired interconnected smoke alarm by approx. 0.6m along the plaster ceiling (to allow clearance for a light fitting). 2. Install 1 x Outdoor Double Powerpoint: - Supply and install a standard weatherproof outdoor double powerpoint (IP54 or similar, see attached photo). - Location: Mount it on a nearby vertical timber deck skirting board (about 1.2m above ground level, no ladder needed). - Cable Run: Run new cable under the deck from the existing junction box (see photo) to the powerpoint (approx. 2 metres distance, using protective conduit/pipe). - Access: Requires crawling/getting under the deck to run the wire(about 1m high). - Power Feed: The existing junction box is ready under the house on a safety switch. (The whole house was rewired around 2021, and this circuit feeds from an existing upstairs powerpoint) Requirements: - Must be a licensed QLD Electrical Contractor. - Provide an invoice with contractor licence number and testing/compliance statement. - Work to commence after 9:00 AM on working days.

Need an electrician to remove a power point outlet and terminate the wires. Am expanding the door to cover where the outlet currently is

Run the wiring behind the nog on the left and run the wiring - conduit is fine along the roof line. Reroute the cable dropping from the centre of the roof. Need a qualified sparkie.

Need 1 double Power points replaced and checked by a qualified electrician.

Remove GPOs on ceiling and replace with one in-ceiling. Install wifi device to replace on ceiling and re-plaster

Licensed electrician needed today in Windsor 4030 for a ground floor apartment. The property is a short stay rental with a guest currently in residence, so this needs to be completed today and done tidily around them. The problem The light built into the ceiling fan has stopped working. The fan itself runs normally on the remote. The light does not come on. What has already been tried The wall switch has been tested in both the on and off positions, by the guest and separately by our onsite handyman. The remote has been tested with the wall switch on, which is the correct operating sequence for this unit. It is an integrated LED, so there is no replaceable globe. Our handyman removed the faceplate to look at the exposed wiring. When he moved the wiring slightly the light flickered on briefly, then went out. He could not reproduce it and stopped there as he is not licensed. That points to an internal wiring or driver fault rather than a switch, remote or globe problem. Scope of work Diagnose the fault and repair it if it can be repaired on the day. If a same day repair is not possible, we want the option to replace the ceiling fan and light unit outright in the same visit, so please come prepared to advise on that. Before doing either, send us a price for the repair and a price for supply and install of a replacement fan and light unit, and wait for our confirmation. Photos of the fault and of the completed work. Make good and test the light and fan on the remote and the wall switch before leaving. Background that may help The ceiling fan was installed by an electrician around six months ago.

Need an electrician to move two outdoor lights and one inside socket in order to accommodate an expanded door.

Need to replace two light fittings in a master bedrooms.