Find trusted local electricians in Balmoral QLD

The heat pump is on the opposite side of the house, hence the 20m. It is 17kW and requires 20amp cabling.

I need a fluorescent light and a sensor light replaced in our garage. I have the lights. No wiring required

* Install 4 bedroom wall sconces: * 2 bedside sconces operating together * 2 fireplace sconces operating together * Install and commission wireless RF controls, likely Havit HV9262/HV9273 or an equivalent reputable Australian-approved system * Take permanent power from the existing GPO while keeping the GPO operational * Supply required cable, connectors, accessible enclosures, mounting hardware and minor consumables * Wire and commission the external electric gate * Wire and connect the video intercom, including gate-release operation * Conduit for the gate and intercom has already been installed * Test all works and provide electrical compliance documentation

I would prefer to agree on a day rate, rather than price each item separately. 1. Install four bedroom wall sconces There are: * 2 bedside wall sconces * 2 wall sconces beside the fireplace The lights are to operate as two groups: * Switch 1 controls both bedside sconces * Switch 2 controls both fireplace sconces There is an existing GPO on the wall that may be suitable as the permanent power supply. The GPO must remain operational. I am considering a wireless RF control system, potentially: * 3 × Havit HV9273 receivers * 1 × Havit HV9262 two-gang battery-free wireless switch Each bedside sconce may require its own receiver because the fittings are physically separated. Both bedside receivers would be paired to the same switch button. The two fireplace sconces would operate together from the second button. I am happy for the electrician to recommend a better reputable Australian-approved solution. 2. Wire the external electric gate I need the external gate wiring completed. The conduit has already been installed. Work may include: * Inspecting and testing the existing conduit * Pulling the required power and control cables * Connecting power to the gate motor/controller * Connecting any photocells, safety devices, keypads or push buttons * Testing and commissioning the gate The gate equipment is already installed or will be available on site. Please advise what cable and protection will be required after inspecting the system. 3. Wire and connect the intercom I also need the external gate intercom wired and connected. The conduit has already been installed between the relevant locations. Work may include: * Pulling the intercom, data or control cable * Connecting the external intercom station * Connecting the internal monitor or controller * Connecting the intercom to the gate-release input * Testing audio, video and gate-opening functions * Basic commissioning and setup

Needing help with my solar energy system asap as half the power is out Based in Balmoral

I need compressor for air conditioner for a kia rio hatchback 2014

My gas heater is not working and there is no hot water and shower is cold. The cooking gas is on and working. We need to check the ignition or thermostat or water heater to assess and fix the problem.

Issue with electrical work with new oven/stove Currently short circuiting house power Need someone to assist Not sure of cost - please make offer Thank you

We added and moved plug points, removed ceiling fans and added footlights. There are also some picture hooks that have been removed. We need the areas patched and painted please.

I want two power points for my cameras. There’s lights next to it and power nearby.

About 4m max of electrical trench and conduit required. Connect to existing conduit and draw wire on either side. No electrical connections required.

Stripped screw from front door light fitting is needing to be removed in order to change light bulb in fitting. There are two screws holding the fitting in place. Screw on left is perfect and easily removed. Screw on right is stripped (near bald) and is the job.

Install plug point to halogen down light wiring to allow flex plug led to be installed - hourly rate. 62 in total - led lights provided by owner.

Without exception, you must have an ABN to do this job and it can only be done on Sat 5th April. Please don't quote if you can't meet both requirements - thank you. 1. Installation onto ceiling and syncing to base unit of supplied smoke alarm. 2. Removal of ceiling fan in bedroom and installation of supplied ceiling fan/light https://www.bunnings.com.au/arlec-120cm-white-matte-aer-4-blade-dc-ceiling-fan-with-led-light_p0299146?srsltid=AfmBOooyUWMd9QP7QTZL75aWnAAEehoGyXfIa_Hx7jpYRRmoGnpQArfX. Dispose offsite the old ceiling fan and switch.

Additional power points needed. There is a power board behind tv and we need one more power board near floor under tv. Same power board as in picture.

Need electrician to repair an electrical wire (for pool light) that accidentally got cut through while hedge was being cut back

We have a bar fridge that needs to be connected to mains power under kitchen island - currently struggling to manoeuvre power cord through space due to how dishwasher unit is connected. See pics. Needs to be plugged in other side to dishwasher, so requiring some sort of device/wizardry to make it happen.

Hello, I’m looking for someone to disconnect the un necessary wires at the back of my tv. I’m unsure of why they are there and would like them gone. For an easy seamless finish. Then I will get the holes patched up - Due date: Flexible

Isolate circuit (as necessary). Install a replacement ceiling fan into the existing aperture in the ceiling and connect to existing cable. Test functionality and commission. Check junction boxes for 4 deck lights making sure connections are good. Replace 4 bulbs (customer supplied). Provide additional water protection. For locating and verifying a fault. Inspect and Replace LED Driver [SNYPLUTO50DV] DRIVER LED DC 50W 12V 24VCONSTANT VOLTAGE Inspect Driver (customer can provide). Isolate power, remove existing and replace with new. Reconnect power and test. Replace transformer/driver for letterbox light - Customer to Provide. Details - Prasa Power Supply - Model - AEO[1]2812. Test pool pump and cabling for intermittent fault. - Due date: Flexible

1. Install new external flood light and run cable to exisiting external power outlet (exactly where to install instructions will be provided onsite). The following materials provided onsite, https://www.ebay.com.au/itm/123934869095?var=424718676083 https://www.ebay.com.au/itm/185044314976 https://www.ebay.com.au/itm/204195236157 Tasker to bring/provide - ladder (or use ours) - drill kit - screws and plugs (for bricks) - screw in outdoor cable tie mounts so the cable run is anchored along the wall neat and tidy (eg https://www.amazon.com.au/Mounts-Viaky-Self-Locking-Adhesive-Backed-Anchor/dp/B07L4CX58B/ref=asc_df_B07L4CX58B/?tag=googleshopdsk-22&linkCode=df0&hvadid=341772724309&hvpos=&hvnetw=g&hvrand=2183449175192174629&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9112658&hvtargid=pla-1046243032472&th=1) - labour 2. Replace 1 x internal standard double power outlet in kitchen. (exactly where to install instructions will be provided onsite) Tasker to bring/provide - all materials (ie new standard double power outlet and anything needed to fit it) and tools - labour Due date: Needs to be done on Tuesday, 30 May 2023 before 2pm (will update here if flexible to do sooner or later)