Find trusted local electricians in SA

Replace battens supply install new downlight with additional cutouts around 40. Currently each has are 1 batten with hallway 2 battens. 4 beds, kitchen living, dining and veranda.- single storey house

I would like to add a few electric points to the house and change the electric switch boards

Fix this power point and replace with a double one

We are currently doing a kitchen removal to install a new one and need the electrical cooktop disconnected for removal

Replace old electric oven and dishwasher. Plus fixing garden lights not working or replacing all garden bed lights.

Looking for replace 2x pendant light

I need three bar lights removed and a pendant light installed to the roof of a studio room

Have issues with trailer electrics had to replace the socket now brake lights stay on have an emergency brake controller not sure which wires go where

Outdoor tap leaking, indoor tap leaking. Kitchen mixer tap needs replacing. Downlight needs changing.

Easy job just need a screwdriver I can teach you if you don't know how to do it I couldn't go to the location that's why Go to Bunnings buy a switch Go to location Turn off main switch Unscrew and screw Turn on main switch job done easy money

House roof has a small leak in it, but it is under a solar panel. Im assuming when it rains hard , there could be a build up of leaves possibly , holding water back, or could be a cracked tile.. Need someone to remove solar panel, and simply seal leak up... i can be there to help ( if needed) , but injury prevents me being on a roof. Access is next to gutter, so not high up top of roof

Need a single light switch replaced and a double power point, hardware will need to be included

I’m after an electrician to replace an old IXL 3in1 light/fan. The IXL has been purchased already. I anticipate it’ll be a simple changeover. https://www.bunnings.com.au/ixl-tastic-triumph-3-in-1-bathroom-heat-fan-light_p4442496 See photos (heat gloves have been removed). Cheers.

I would like 4 power points installed 2 in the outdoor entertaining area and 2 in the carport.

Have two old smoke alarms that are hardwired and need full replacement. Also have a light switch in the bathroom that needs to be looked at.

Electricians:- Need Downlighting and few extra points (5-6), need to replace some lamps , need to put 4 fans. Plumber :- Need to replace Toilet pots (2 washroom) and need to fix water flow in shower in one washroom ( which is very low).

I’m looking for a qualified and experienced electrician to install a pendant light in a residential property. The task involves removing the existing downlight fixture and installing a new pendant light, ensuring it is securely fitted, correctly aligned, and safely connected. Scope of Work: * Remove existing downlight * Install new pendant light * Adjust/drop rod or suspension to desired length (if required) * Ensure proper electrical connection and safety compliance * Test the light to confirm it is working correctly * Clean up work area after installation Requirements: * Licensed electrician (essential) * Experience with pendant/chandelier installations * Own tools and equipment * Attention to detail (important for positioning and aesthetics) Additional Notes: * Ceiling height: 2.7m Location: Riverlea Park 5120

The pendant light fitting in my garage has come loose and fallen to its entire length. I’d like the fitting either made safe and reattached to its position or replaced with a simple bright globe.

Re-mount one power point & light switch in a new ensuite bathroom, and replace one light switch in a bedroom which is flickering, and on a dimmer. It’s an old switch and was installed upside down.

We have 9 wall sockets not working in Kitchen and surrounding, which all connects to one breaker on the switchboard. Changed the circuit breaker, and 4 wall sockets that were looking like could be problematic but no improvement. Initial warning before those wall sockets fully stopped working, when we start 2-3 items it was dimming the lights that were connected to that socket. It never tripped any circuit breaker or RCD on the switchboard, directly stopped working those sockets, lastly started the dishwasher, which socket also I changed,