Find trusted water heater repairs and installation experts near you

We have an independent switch/circuit breaker for the hot water heater. For the past few months, this switch has automatically tripped randomly and cut off the hot water heater's power. Though the switch becomes warm, sometimes hot when it tripped, it could always be switched on again, but would or would not trip again after some time (usually 10 min to a few hours). I didn't observe any repetitive patterns about when it trips, but it often happens during evening peak hours (6~9pm) and less often during daytime. All the other switches have no issues. The hot water heater is only 2~3 years old with ~3.6kw power consumption at max. The switch capacity is 6kw which should be fine. This is the highest power consumption appliance at our home and we rarely use multiple appliances at the same time. Attached are the pictures of the switch box and the hot water heater, both easily accessible. Make sure you bring the appropriate tools to diagnose the issues according to the symptoms I described above.

We're looking for a licensed plumber or qualified tradesperson to relocate our 50L electric hot water heater from its current location under the kitchen bench to the balcony, which is directly adjacent to the kitchen (approx. 1-2m away through an external wall). See pictures attached for reference. Scope of work includes: Disconnecting the existing 50L electric hot water system Drilling through the external wall (if required) to run plumbing and electrical connections Reinstalling the unit securely on the balcony floor Reconnecting plumbing and electrical Ensuring the system is operational and compliant with relevant standards Clean-up and disposal of any waste Access & Notes: Balcony is covered and sheltered Requirements: Must be a qualified/licensed plumber and/or electrician Experience with hot water system relocations Bring own tools and any materials required for reconnection

Pressure relief valve on Rheem everhot 315 needs replacing

I need to install a hot water unit in 2 container homes. Supply and install a heat pump system

I have a small hot water system connected to a shower that we don't use. I would like to get the heater removed.

Plumber removed the connection for solar water heater a while back. Just looking at getting this system removed from the roof to free up space.

My mum has no hot water thinking the pilot light out

Request a quote for the supply and installation of a Rheem 170 L gas water heater, model No 347170 in Port Melbourne. As shown in the photo, the water heater is raised, 530mm from the ground. All attachments are fed from below the water heater.

Please fix the temperature of water heating system.

I need someone to bring new 80L hot water heater install it in the unit and remove oldone

I have the part already, need an experienced person to replace pressure relief valve on my gas water heater as its leaking.

I had my hot water heater replaced recently with this https://www.samedayhotwaterservice.com.au/product/rheem-stainless-steel-80-litre-hot-water-system/?gad_source=1&gad_campaignid=17613708470&gclid=Cj0KCQjwyIPDBhDBARIsAHJyyVhhPaId09ffQ6ACr80L9LZZA9X07VymvcEmnsxiEFNso2Q7tQLXy9gaAkYDEALw_wcB and the tech installed it set to a fairly low temperature, which he said he was required to do. I have the manual and a little key thing that he left for me (pictured) but I can't for the life of me figure out how to adjust the temp, and the manual only says to get an electrician to do it. Just looking for someone who knows their way around a unit to bump it up for me! I work from home so during the day is best. Unit is easily accessible in a hall cupboard.

I have an aquamax 340 gas water heater, and has been working fine. I had to move it up 30cm for some backyard work so the connections were altered. I got a plumber to do it for me. However right after the work has been done, the water pressure dropped massively. Plumber used fittings of same width as before, and the heater company saying it’s a plumbing issue.

Remove 2 old water heaters and 1 washing machine

Need sparky tomorrow morning at 8am to supply and install external power for apricus all in one heat pump and run conduit approximately 4m to sub board

Inspect a hot water heater to determine if it needs to be replaced or it should be fixed. It is currently not working. The power supply has recently been tested a few months ago, when a number of internal cables were replaced. If it needs either, to then provide a quote for the repair or replacement. It is an Aquamax 80L - of unknown age, looks in good condition. When I rang the company on the sticker they said likely > 10 years old and may be better to just replace.

Update circuit breaker and connect electrical hot water heater to existing power

The toilet is leaking water, also the hot water heater is leaking

Need entire solar water heater system removed. Panels, plumbing and everything thats connected to it. Thanks.

I’d like to request a repair or troubleshooting quotation for our gas/solar hybrid water heater system. (Fault Codes Red Light Flashing Plus Continuous Beeping: Panel Sensor Lead Fault / Disconnected) https://resources.chromagen.com.au/images/SHW/downloads/installation/CA-IN-S014_KanittiController-LR.pdf At the moment, only the gas booster works fine. The current setup includes: Chromagen 200L Storage Tank Solar-heated water from roof panels Rheem Continuous Flow Gas Booster (Model: Rheem 874T26NF-A) Kanitti Solar Controller – currently blinking red Could you please provide an estimate for inspection and potential repair? Fixing the cable issue etc