Find a local timber flooring profesional in NSW

We have had our floor sander cancel today and everything is ready to go but need this done now otherwise have to do the job ourselves

I have a tinny I’m doing up for my father and need a timber ply floor cut and shaped There is cut outs for liftable hatches and the boat tapers I will supply all material

I’m renovating my kitchen and need new floor boards - there is measurements in the photos

Need to sand and oil garage roller and two gates timber slates

Would like to change the deck colour and repaint

I have one very small burn mark (approximately 10–15 mm) on a timber-look floorboard. Looking for someone experienced in cosmetic timber/laminate/hybrid floor repairs to remove/fill the damaged area, professionally colour-match the existing flooring and recreate the grain/finish so the repair is as unnoticeable as possible. Spot repair preferred — I do not want the entire floor sanded or a board replaced unless absolutely necessary. Please only make an offer if you have experience with this type of cosmetic floor repair. Photos attached. Ideally, please send an example of a similar repair you've completed.

I have burn marks on my timber flooring.There are about 4-5 spots, the largest around 2cm across, located near my dining table. Looking for someone experienced in timber floor repair to assess the damage and advise on the best fix ,whether that's sanding and spot-refinishing, using a filler/burn-in repair kit, or replacing the affected board(s). Photos of the damage are attached.

I’m looking for an experienced timber floor sanding/polishing or timber repair specialist to review detailed photos of a timber staircase and provide an indicative quote for the repairs required. There are 16 timber stairs in total. I will provide photos showing the current condition and marks/scratching on the individual treads. I would like you to provide a detailed scope of works and indicative quotation, including: - which individual stair treads you believe require repair; - what damage/marks you are proposing to repair on each affected tread; - which marks appear to be general surface wear/scuffing that you would not ordinarily repair; - the recommended repair method for each affected tread; - whether sanding, filling, staining, recoating or other treatment is required; - how many treads require treatment in total; - whether unaffected/adjoining treads also need treatment and, if so, why; - the number/type of coats or finishes you recommend; - estimated labour and materials; and - the total indicative cost of the recommended works. I understand that an exact assessment may require physical inspection, so the quotation can clearly state that it is indicative and based solely on the photographs provided. I am looking for your independent professional opinion on what work you would recommend if you were engaged to repair the staircase in its current condition. No physical repair work is required at this stage. Please respond if you have relevant experience with timber floor sanding, polishing, restoration or timber stair repairs.

I recently had a hot water leak in the laundry that spilled into the adjoining kitchen / hall area. At the time, all visible water was removed and professional dehumidifiers /dryers were used, so I believed everything had dried properly. I was then away overseas and have just returned to find that sections of the floating timber flooring have started to buckle/lift and gaps have appeared between some boards. Approximately 5-6 boards are affected. They also had a heavy piece of furniture pushing pressure onto it which may have contributed to the uneven expansion / shrinkage. The floors were already older / not in perfect condition, so I’m not looking to replace the entire floor. I’m hoping to salvage and repair the existing boards wherever possible. I’m looking for an experienced timber flooring specialist who can assess the affected area, including checking the timber and underneath for residual / trapped moisture. I understand the repair may need to be completed in two stages: initially lifting / removing the affected boards so the area underneath can be properly inspected and, if necessary, allowed to dry completely; then returning once moisture levels are appropriate to relay / reseat and repair the existing flooring. Ideally you will have a moisture meter and experience with water-damaged floating timber floors. The priority is making sure everything underneath is properly dry before the floor is closed back up, while preserving as much of the existing flooring as possible. I have availability this tomorrow (Sunday). Thank you

I have ripped up all of the old carpet from four rooms but need someone to remove all of the staples around the edge of the rooms and clean the floors so they are ready to be oiled

Replace a broken timber on my deck. Supply and install. No need to stain or lacquer. Timber is around 1.2m long

Approx. 27 m long × 2.5 m high (approx. 67.5 m²), one visible side. Scope: • Thoroughly clean and prepare timber • Sand weathered/rough areas and provide an even finish • Apply two coats of supplied exterior Merbau timber stain/oil, following manufacturer instructions • Protect paving, plants, pool glass and adjacent surfaces from dust/stain • Include all labour, drop sheets, masking and cleanup etc Materials and equipment supplied including hand sander, stain and applicator. Please quote based on experience with Merbau/timber screening and advise estimated duration. Photos attached.

Multiple small gaps in floorboards , need small gaps filled with wood coloured gap filler. House is on piers- easy access. Easy job- I can’t do it as I’ve just had surgery.

The handrail has already been mostly prepared. I just need someone with the right tools and attention to detail to carry out the final sanding so it's smooth and ready for staining or clear coating.

Repair these chips in the timber floor for a commercial office move out

Fixing floor scratches on floor

Engineered timber flooring installation for 2x3 room. Room is new. The following will be supplied 1. Click lock floorboards 2. Underlay 3. Skirting No painting needed.

Raised brick foundation house has gaps around the perimeter of the house allowing access underneath. Horizontal timber decking installed to cover any access (from dog) under. Approx 25meters

We removed a cupboard in our hallway and the timber floor underneath needs to be sanded and polished to match the rest of the hallway. The area is very small: 59cm x 117cm

Description: I’m looking for an experienced decking professional to supply and install a new deck in both my front and rear small courtyards. Scope of works: * Total decking area approximately 18–19 m² * Supply and install a basic, good-quality decking material (open to recommendations) * Construct a neat, level, professional finish * Remove and dispose of any waste upon completion Requirements: * Proven experience building residential decks * Please provide photos of previous decking projects or a portfolio of similar work * Must have appropriate tools and experience * Preference will be given to experienced tradespeople with strong Airtasker reviews Please include in your quote: * Estimated timeframe * Earliest availability I’m looking for a quality finish at a competitive price.