Hire a trusted stove installation and repair service in Melbourne

Install new gas stove top. Plumbed already with gas line to location. Line is currently capped after removing old hob. Just needing to reconnect new one

Stove pilot doesn’t stay on

The spark that lights the gas stove stays stuck for a long time after turning it on

Install new gas stove, connect new gas line, cut out out of bench for installing, plus install a new range hood for stove

Need existing Smeg ceramic top electric stove disconnected and a new induction stovetop installed. This will need to happen over two visits as I need to know the size of the cutout before I can purchase new stovetop.

I’m in Moonee Ponds and I need a new oven/stove connected and the old one disposed of by a qualified electrician.

Gas stove disconnection and capping as well as kitchen tap and wastewater capping to enable safe demolition. Apartment. OC approved. Needs to be done by certified plumber. Reposted as didn’t include kitchen tap before. Could be today or tomorrow. Thanks

Replace existing electric cooktop with induction

I live in Brunswick East and need someone to have a look at whether it's feasible to install an induction stove. I think would require pulling the oven out to check the cutout size, and then putting it back in, as we can't change the cutout size of the bench (it's stone), and having a look at our switchboard as I assume we'll need an upgrade to accommodate any new stove. I'm aware we need to get the gas on our current stove capped before proceeding with any install, but I just wanted to check it was even possible before we line up the plumber! Summary: - Assessing current stove cutout size - Switchboard capability - Any compliance measurements (e.g. stove to rangehood, stove to splashback) we might need to consider

Install the wiring for Swedish sauna stove small

I have an electric 4 burner stove top and needs to be replaced with 4 burner gas top. Gas line is available underneath. Plumber will need to get gas fitting pipe approx 1.5 mtrs to connect the burner to gas outlet. The cut out is fit to size and the gas burner should slot it (already checked)

One of the burners doesn’t hold the flame when turning on the knob. I want someone to investigate and repair the issue. The ignition starts but it doesn’t hold the flame when the knob is released

We have a stove that keeps clicking regardless of whether it’s switched on or off. It is not igniting properly. We are keeping it switched off at the power in the meantime. We have done regular troubleshooting steps and ensured there is no moisture. Only one burner is affected and the rest is fine.

Stove making a clicking sound before the ignition lights up. Every time it makes the clicking sound I turn the switch off and the gas stove is on but the electricity is off.

Removal of old and installation of new Westinghouse Gas Stovetop.

The gas ignition doesn't switch off, keeps clicking after burners are lit. Also one hob is only pumping out very little gas.

Gas stove top is powered by electric ignition, stove top makes clicking noice when power is on but stove off.

Location - in the city Task to be done - Change all 6 light bulbs into the new trasnformer type light bulb - at the studio area Replace induction cooktop - I have bought the stove top with very similar size, replace the induction cooktop with the new Change one of the light on the rangehood. Please keep within my budget.

plug in the stove, it causes the circuit breaker to trip, not sure if the problem is with the stove or the plug

- lights up with a match but doesn’t stay ignited - inner circle of the flame doesn’t light up - "breathing" or hissing sound - uneven gas distribution I have cleaned the burner hole multiple times with toothpick