Book a trusted oven repair and installation expert in VIC

I already bought oven and just need to install

Job to be completed tomorrow Sunday 1st Feb. Re connect gas oven Install new kitchen sink Install new mixer tap. Hole in stone has already been cut out See pics for sink and tap

EMILIA Oven not Heating . The Grill works . Oven Light , Temp light ,Timer and Fan work

Hi I need a licensed plumber to disconnect oven and dishwasher as a preparation for kitchen works.

Main oven element needs replacing in Chef electric oven. Chef ebc5231W I can purchase an element online if necessary.

Need electrician to replace current ha d wired oven

Disconnect old and reconnect new gas oven. Please send quote

The oven stops working, the oven light comes on and the fan spins but it doesn’t heat up.

We are having two issues with our Westinghouse oven - The spark on the gas hot plates are not working on any of the jobs - The power is tripping when the oven warms up above 220 degrees

Tisira oven TOC969E Turned off randomly while baking now has no power, wont turn back on. Have tried resetting at switchboard with no luck

Need a licensed electrician to replace a 60 cm built-in oven. • Remove old oven, Fagor 60 cm • Install and hardwire new oven, Bosch Series 4 HBA534BB3A • Existing separate oven fuse at switchboard • Single storey brick home • Like-for-like replacement Must provide Certificate of Electrical Safety / Compliance.

Blanco Oven needing service or repair. Grill works but oven settings does not. Also needs seal replaced.

Upgrade Cermaic Switchboard, install new circuit for new electric oven, including associated works. More details on request.

I need to have an old 60cm Blanco oven removed and a new oven (Bosch, same size) installed

I need a registered electrician to install a new freestanding electric oven at a residential property in Sunbury. Details: New oven: Technika freestanding electric oven, 54cm wide Old wall oven has already been removed Existing oven wiring is present but is approximately 3 metres away from the new oven location The cable will likely need to be re-routed under the wooden floor and brought up behind the new oven Scope of work: Inspect existing oven circuit and wiring Re-route existing cable to the new oven position Connect and install the freestanding oven Test and confirm safe operation Issue required electrical compliance / certificate This is installation only. Any required upgrades beyond the existing circuit must be discussed and approved before proceeding. I have provided clear photos of: Switchboard Existing wiring New oven Property is residential with good access. Please include: Confirmation you are a registered/licensed electrician What is included in your price

Have a smeg double oven which is ~10 years old. Has been working well until the last 24 hours. Turned off knobs the other night but oven would not turn off until power to it switched off at electrical switch. Now when turned on does not heat up

Install new induction cooktop and electric oven (existing gas units already removed). Create a roof vent for the rangehood. Some electrical work may be required for the induction cooktop. Appliances supplied. Single-storey house, Ringwood North VIC. Licensed electrician preferred. Timing flexible. I’m an architect and well aware of the scope of work. Please avoid submitting unrealistic offers. Thank you for your understanding.

My Smeg oven is no longer an emitting heat the grill works fine but the fan force options do not. I believe it needs a replaced element.

Oven is turning on and heating to warm but not to hot. Grill is working fine.

The oven heat is not evenly distributing