Find experienced insulation contractors in Outer East Melbourne

Part of a ceiling has collapsed and has been removed. Now need the remaining plasterboard/cornices/insulation to be taken down, so that the entire ceiling can be replaced. The approx size of the area is 300cm x 390 cm.

Needing ceiling insulation to be installed - approximately 140m2. Insulation batts (Earthwool R6.0 mostly 580mm wide and some 380mm wide) have already been purchased. Varying widths between ceiling joists & beams as home built back in the 70's. All bar a couple of downlights are IC-4. Home is on a sloped property, so is mostly single story however one corner is double story. Ceramic roof tiles. Old insultation has been removed. Someone is generally home on Mondays and Wednesdays if an in-person quote is preferred. Please reach out if more information is needed.

I need roof insulation removal and installed, insulation will be provided.

We are looking for an experienced and licensed insulation installer to install insulation R5 under subfloor in our home located at 6 Samuel Street, Ringwood. Project Details: • Type of property: Single-storey residential house • Area to insulate: Approx. 140 sqm • Current condition: Existing insulation may be old or insufficient • Scope of work: • Inspect current ceiling insulation • Remove old insulation (if necessary) • Supply and install new ceiling insulation

Install insulation to 4 x skylight shafts and 1 external garage wall. 2 walls of each skylight are R2.5 ceiling batts (130mm) and 2 walls of each skylight are R2.5 wall batts (90mm) External garage wall is R 2.5 wall batts (90mm). All material is provided.

I have had the following installed throughout the roof, except for one area that is roughly 8m2 R2.5 Glasswood Batts to the perimeter of the ceiling cavity prior to the R4 Batt install for maximum thermal coverage R4 Glasswool Batts to the tiled ceiling area of the House The attached pictures show R2.5 to the perimeter (in red) and the R4 (green) for the rest of the house. There is one area remaining to do above a bedroom with a steep roof. Could be accessed via roof or tiles

Strapping needs to be attached to woodwork to hold up previously fitted insulation. There is easy access. Area approx 8x8 metres. Plastic strapping will be supplied.

a duplex 75sqm brick house, tin roof with wooden flooring

To install insulation bats to a ceiling approximately 200square meters

To put Back lining boards on pergola ceiling and insulation as well

We need all the insulation removed from the roof and have the whole area vacuumed. Area is roughly 100 m².

We have bought quilt insulation however we have not been able to get it installed Space is very restrictive in old house with trussed timber cut roof

Hello, I would like to have my garage worked on to make it a bit nicer to be in. Interior cladding, insulation, cutouts for outlets, epoxy flooring etc for a 4.5x6m garage in Sassafras.

Need worker to remove ceiling and insulation

Remove all old insulation and replace with new.

I have started installing underfloor insulation but have run out of time and motivation. I have the bats ready to go I just need someone in install them for me. Weekends only. Thank you.

New living room and kitchen needs insulation installed in roof and walls

Would like someone to install 300 square mettre of underfloor installation

We need ceiling insulation to be installed in the ceiling of our house. Half of the house has been done. On the drawing its the green shaded area. This just needs to be checked. The other half of the house shaded in purple needs to be finished. About one third of this has been done. There are a few bags of insulation in the ceiling but probably not to complete. You'll need to provide the rest of the insulation. R5 batts is what has been used. Please provide indication of price to do this work.