Find an experienced handyman in Heathmont

I need a new sliding door installed, other small jobs - putting on new internal door handles, putting up new curtain rails and blinds.

Cockatoos have chewed off the plastic trims on two upper story aluminum windows and pecked at the rubber seal beneath the window. I would like the following tasks done 1. Replace the trims around three sides of the window - approx. 8m of surfmist trim 2. Repair/replace the rubber seal beneath the window - approx. 4m 3. Put up some wire or bird spikes to prevent them landing on the sill - approx. 4m See images, can send some more if you need

Door has cracked open after accidentally trying to open it against locked door. Needs to be fixed or if it cant be fixed, replaced like for like. Door is 2340 x 820 x35

Cut 30cm diameter hole in 4mm glass window for cat door (supplied, see pix).

We are wishing to install a cat flap into one of our exterior glass doors. We've been advised that we'll likely require a new glass pane with the door pre-fitted. Current glass pane dimensions are 54cm (W) x 172cm (H)

We recently moved in and have been unable to get our Illusion Gas fireplace to work despite trying to ignite it by following the tutorials online There doesn't appear to be any gas flow (given that we cannot smell anything when trying to ignite) Manufacturer: Illusion Model: Ultimate Gas Log Fire Model 62 / 32

plain hollow door install to bedroom including door nob . I need it done promptly and properly.......tomorrow

Current drill ozito not strong enough to drill the holes. Need someone to come with tools to do the job

Need someone to repair small plaster damage and reattach a toilet roll holder to bathroom wall. The toilet roll holder fell off and took some plaster with it. Another toilet roll holder is starting to get loose, and so hopefully can be secured to the wall too

My dining room's sliding door was working fine until yesterday. I think something's broken (possibly the roller, but I don't know) that since this morning it's very heavy to open and close. It's still able to open and close it, but it's very difficult to. I need someone that can help to fix it so that it can open and close normally again. Note: it's the right door from the picture.

Disconnect, remove, and dispose of existing gas heater in fireplace, leaving an empty fireplace

Replace rotting fascia boards, window, broken doors in old 1960s brick veneer house

We are needing a glazier to install our cat door into a glass panel We already have the cat door and can confirm it is suitable for glass Installation info: https://hakunapets.com.au/pages/super-tough-pet-door-information-page

I need to replace roller blinds at my investment property in Heathmont. Need to replace block out blinds with dual day and night blinds. I can provide the blinds from Spotlight or Bunnings. Need to replace 1 blind in master bedroom and two blinds in the living room. Remove and dispose old blinds.

Install outdoor GPO I will supply GPO Will need to run cable see picture it is open behind the metal sheet stud work and plaster board

Fix small hole(caused by oversized screw) in the wall to fit hand towel rail

I need a standard shower screen from Bunnings installed onto a newly installed base and also removal of old frameless shower screen

There are 2 sets of timber sliding doors ( 2 doorways with 2 doors each) in the living areas that are old and hard to slide. There is a lot of resistance when sliding them. they are hanging on rails that are concealed by a timber pelmet, of which I cannot clearly see any screws or nails. repair the sliding doors to the original smooth sliding state. remove pelmet if required but it must be put back, restored to original state (minus any painting required).

Need to replace screen door mesh

We have a new ceiling fan we need to have installed. It has a wifi-enabled controller that needs to be installed with it. We have an existing ceiling fan so the wiring is already in place. We have a second ceiling fan of the same brand that we would like to install another wifi enabled controller into