Find an experienced handyman in Chirnside Park

Looking for someone to help with removal and replacement of bathroom taps as well as removal of existing (2 drain) kitchen sink and replacement with new (single drain) basin sink. Taps and Sink provided. Very likely plumbing under sink will need to be redone to accomodate one drain as opposed to two. Quote to include all labor, sealant, pvc parts.

Repair window wood rot base make water tight and sealed

Damaged section of wall to be repaired as pictured. 1x chunk of wall damaged.

undertake repairs to dilapidated brick piers in subfloor of a residential dwelling

Escea TFS1000 wood fireplace install. Have standard flue kit. Flashing on roof, peno and peno seal and flue needed to be installed. Attached are photos of roof above where fireplace is to be installed. Solar panels might need shuffling over (can be done by me) No certificate required as minimum clearances aren’t exactly adhered to.

I need 3 bathroom mirrors removed and new ones re hung should be pretty easy job might need a Dimond drill bit happy for them then stuck to the wall I am pretty sure the old ones are just liquid nails on

Mary go round (carousel )stopped working.and it’s vinyl need repair.

The hinge where the toilet seat is raised and lowered from has displaced an cracked - in not sure if it needs replacing or can be fixed.

I’d like a quote to install 2 floating shelves and pegboards in garage

We have squeaky floors in a bedroom and a hallway. Access to the underside is straightforward from the garage and subfloor storage area, but it will require crawling to reach the bottom. I’ve noticed that plastic and timber stoppers have been used in other areas of the house and seem to work well, but I’m not sure if that’s the best solution for these floors. I’m open to suggestions. I’m flexible and willing to negotiate pay if there are any challenges. Looking for someone with experience in floor repairs to handle this job.

I need someone to help me with the instalation of engineered board on a 3x3 room and a hall, I already got the material

The mailbox was brick and was for both units on the block. Unfortunately most of them were shattered and may not be salvagable. We're looking at having it rebuilt from scratch for both units to look as similar as the original one. First picture was of it before it exploded and then the second picture is... Well... Yeah. We do not have spare bricks and we are happy for the bricks to not match 100%, just to look similar enough.

The lift mechanism in the Horn Sewing Cabinet does not move up and down easily and needs attention with a possibility of replacing the lift mechanism. The lift mechanism is not cheap and I am in the process of sourcing the item. Screen shot 2 shows the small lift mechanism on the right hand side

There is a normal sink in the kitchen so we need that be un the mount.

Hi, The screws on the fix plate keep coming off. If the existing one can be fixed, that would be great otherwise I was thinking to replace it with the sliding door closer as shown in picture 3.

Need a cabinet maker/chippie or alike to repair or replace Kaboodle corner cabinet hinges on 2 corner cabinets. Constantly going loose/sagging even with constant tightening and the main hinges on one corner cabinet have completely come off

Need a home multifunction gym machine assembled. It’s a centra home gym it can be viewed at big w marketplace to have an idea about task.

Repair and fix timber , seal around the bath tray and paint after fix

Hey there, I’m looking for someone to remove this extended hearth and replace it with a smaller one. I will provide the updated hearth

Install 2 ceiling fans/light units (will be purchased and provided separately) in two seperate rooms, inplace of the existing ceiling lamp. Low ceiling height, no access issues.