Find an experienced handyman in Cherrybrook

Driveway needs to be repaired & reinforced on one corner

Need a gyprocker to sand, patch and paint around the ceiling vent area. The plaster around the diffuser is uneven and still visible from previous works, so it needs to be made good and repainted to match the ceiling.

Need 6 curtain rod brackets to be screwed securely into hollow wall using 18 screws and 2 rods placed on these brackets. Brackets, screws and plugs for hollow wall were supplied with the 2 curtain rods. The rods are each approximately 3 metres long.

I have a frameless shower screen that needs fitting. 900x900mm

Hi, looking for someone experienced to assemble garden shed on my backyard I need Full install shed with anchor shed to the slab

Looking for an experienced handyman or plasterer to repair multiple areas of gyprock wall damage caused during a recent conduit installation. What I need: * Inspect and assess full extent of damage * Repair and patch all affected areas * Reinforce weak sections if needed * Sand and leave ready for painting (painting not required unless discussed)

Gyprock done on both side of the wall please the photos and some patch work as well

Build timber frame wall approx 3m wide * 2.5 meter high Install gyprock/plasterboard both side about 9 cm thick and insulation in between . Set and sand joints ready for paint . Wall is internal under roof . Please include labour and materials, must have experience with framing and gyprock

need to replace lift chords

Replace damaged ceiling. Replace ceiling, sand, undercoat and repaint. 3m x 2.65m The whole ceiling needs replacing because it’s warped from water damage

Pressure washer will not turn on.

Hi, I’m looking for a reliable handyman or locksmith for a small job at my home in Cherrybrook. Scope of work: - Replace front entrance door lock (mortise type) - Replace back entrance door lock (mortise type) - Replace 7x interior timber door locks Labour only – I will supply all materials. Important: • Experience with mortise locks is required • Must have own tools • Looking for good workmanship and attention to detail Location: Cherrybrook Flexible with timing (ideally next week) Please include your experience and availability in your offer. Thanks!

Need to remove existing light fittings with new chandelier

Refer image attached. Task include - 1. place dryer on the wall. Either using curent brackets(refer images) or usong new bravkrts that came with dryer 2. Fit the gas heater (refer images)

My wardrobe’s sliding mirrored door is broken and need to be fixed

I need all the walls to have a flat rendered finish And the floor screed done ready for tiles.

We have 16 x internal doors that need to be hung in our house. All doors will be available on-site, painted and ready. For each door, the hinges and door handles will need to be fitted, and the door frame will also need to have the plate installed. We will supply the door handle kits for this. Doors are solid shaker style doors: 8 x 2040mm(h) x 770mm(wide) x 35mm(d) 8 x 2040mm(h) x 720mm(w) x 35mm(d) Link for extra door information: https://kelsodoors.com.au/products/shaker-2p-internal-door?variant=45682613747874 Doors to be installed: 4 x bedroom 2 x bathroom 2 x double door built-in wardrobes (in 2 of the bedrooms) 1 x toilet 1 x linen closet 1 x laundry 1 x storage cupboard 1 x study 1 x internal door to garage

Get up on ladder and drill 2 small holes on wooden roof eave to install a security camera. I can supply the ladder, drill etc.

1. Remove and collapse existing garden shed (size 3*1.5 approx) to suit bulk waste collection 2. Install new Gardenshed from easyshed (size 3*2m approx)

Need to replace the old garden shed with installaing a new on. Please see the photo attached. Kind regards, Jay