Find an experienced handyman in Bayview NSW

2 people preferable Lay approx 110 sq m R5.0 ceiling insulation (we purchase) in our attic. There is no pre-existing insulation. The attic has easy access via a large opening with drop down ladder. The attic has lighting, relatively clean, and allows some standing. Approx half the attic has screwed down chipboard 20mm panels for access and storage. The chipboard will need to be lifted and replaced after insulation is installed. Stored items need to be moved around for access.

My VW bonnet has been scratched and paint chipped off parts of the bonnet. Need to repair

Windows x 2 previously covered to darken a media room, we now need them for light, there are two long windows as per images. Cut plasterboard and reframe thx.

6 months ago I started a project to turn BMW 2003 F 800st from a fairing bike to a naked bike. I had asked the parts I tried to add carbon parts for the tank but this is a fail and need someone who can fix the tank problem with carbon or welded metal and connect extras to lights so I can enjoy the bike. I am in norther beaches so order someone close by - can negotiate on labor hourly fee - I’ll pay for parts

Multiple air jets need replacing

Need the throttle fixed the cable

Sunroof installation for a unit balcony. Polycarbonate fixed sunroof. Approximate dimensions 3m by 1-2m. Balcony shape is slightly angled, narrow at each end and wider in the middle. To be attached to 6 steel beams running from the building roof to over the edge of the balcony. Balcony is on the 3rd floor. Assistance needed with purchasing polycarbonate panels with varying measurements. Sealant required at joins to prevent water dripping. Installer may require harness and should be aware of permits for working at height. No rust treatment or significant cleaning needed on steel beams. Installer to inspect balcony prior to installation for better understanding of the job, which should take a couple of hours, and to assess permit requirements.

I have a Scandia fireplace that needs to be installed at home. I would like someone to fit and install.

Looking for handyman to install a pull handle on new kitchen cabinet door. Only one handle to install.

To fix a glass door and to put bolts on the other 2 doors opening out to the pool.

Need a rotten window frame replaced

Remove 2 metal frames and doors and install 2 new frames and doors

I need a flagpole base fixed into a brick wall. - 4 screws. I have the screws and plugs. Drill needed and step ladder. About 3 meters above ground

Install new piece of gyprock in bathroom ceiling and finish off so it is ready to be painted. There isnt any cornice, just edged to tile wall. Needs to have two lights and one sunlight cut out. Total area is approx 1.5m x 1.95m

Need to fix wall next to vanity and around IXL (ceiling).

Hi there, We have a balcony rail that we need the wires installed between the posts. We have all the materials required.

Need part of wall (250x1000mm) and around IXL Gyprock repair.

Outdoor blind needs hanging and holders don't line up with my beams so needs a piece of wood attached to beams and the blind attached .blind is 170cm

Two blinds need mending. The rail at the bottom has become detached, the sticky panel needs replacing.

repair/rebuild 1m sq dry wall