Find gutter repair professionals in Cairns

Gutter and brackets were previously dislodged. Brackets have been reinstalled at the same level (next to old holes) using countersink screws (see attached). The gutter may not sit flush due to the screws. Can possibly use pop rivets instead, though it has sat in the bracket base with existing countersink screws. Two joined older-style gutters need to be reattached and aligned so they sit flush with both the fascia and the base of the gutter brackets. The gutters and brackets were previously dislodged, and all brackets have now been reinstalled at the same level (next to the original holes) using Buildex M4.8 x 30mm countersunk screws (see attached photo). It’s possible the screws may be slightly affecting how the gutter seats in the bracket base; however, I’ve previously had the gutter sitting perfectly flush with both the fascia and bracket base using these same countersunk screws. After adjusting one bracket slightly, it no longer sits flush. Pop rivets could potentially be used instead of the countersunk screws if that provides a better fit. The task requires someone experienced with gutter alignment and adjustment to ensure both joined sections sit evenly and flush along the fascia line and bracket base. All materials (gutters, screws) are already on site. You’ll need to: • Bring your own ladder, drill, and levelling tools • Check and adjust alignment and fall if needed • Ensure gutters sit flush with fascia and bracket base • Use safe working practices when working at single-storey height • Clean up any offcuts or debris after completion I can assist with the job (holding, aligning, passing tools, etc.) to make things easier and faster. Important: • Tasker must have their own public liability insurance • Tasker must use their own safety equipment suitable for single-storey roof height • Property owner does not provide insurance cover for contractors Length of gutter: approximately 10–12 metres total] Access: Easy — flat ground, single-storey

I have a single concrete driveway and am wanting the curb to the right of the driveway Cut out to replaced with a a concrete lip /start of driveway. Basically sick of driving up curb onto grass.

low set queenslander needs 3 gutter barge board repairs. Mostly boards are in good repair, just in 3 of corners the gutter has leaked and the timber board behind has rotted. Help available to remove gutter if needed. Materials supplied. Painting not required.