Find an experienced flooring expert in QLD

Install hybrid flooring, no scotia trim as new skirting being installed.

Help lay vinyl flooring in 4 bedrooms, will also need to assist with carpet removal

Required new sheet vinyl flooring installed in a 3m x 2m laundry. There is no waste hole in the centre of the floor. I have removed the laundry tub and washing machine. There is an internal hot water system, hence a few extra corners to get around. I have the new vinyl sheeting on hand. Just looking for an Install.

Flooring 4x3 approximately in cupboard

I want some one install hybrid flooring in my garage. Size: 5.1x3.2 I have material, skirting, L trim.

Lay flooring in a new room, I have already purchased the flooring. No need to do skirting boards either as I will do this myself.

we need two planks from our engineered timber flooring replaced. We have pet damage and the wood has darkened. Small and simple job. Timber provided just need to pull up and relay . Please see attached photos

Approx 82 square metres. Carpet and underlay removed in all areas except lounge and hallway where underlay is stuck due to high traffic and kitchen with vinyl approx 25sqm out of the 82sqm. Wanted sand and solvent based gloss finish Need quote in Acacia Ridge. Thanks

Vinyl plank flooring to be laid (already purchased) and glued in living room, kitchen, dining, hallway and office. Approx 50m2. Previous flooring has already be ripped up. No floor plan but happy to roughy draw the area if needed.

Need someone to securely install four clear plastic patio covers and ensure they can roll up and down smoothly. Covers supplied. Must bring own tools. When: ASAP.

Hi, I've run out of time so am looking for someone more experienced than me to help lay and cut hybrid flooring for one bedroom. The underlay is down. Please have your own saw as I've only got a hand saw and a multi tool.

Need a professional to Lay/Install 30 m² of Hybrid Flooring. Lounge room and small hall. (photo shows the room, but of course it will be completely cleared on the day.) Tuesday, June 2

Help me lay vinyl planks on my floors very small house only doing kitchen living and dining

Must have experience in vinyl sheet flooring installation. I will provide vinyl sheeting and no need for any floor preparation or removal. Just want it lay on top and sealant on edges. Room is approximately 2.27x1.83. This week any day is flexible and early or late start all ok though if you could advise date.

Hi 110m2 hybrid flooring 4.5mm for installation.

Qualified floorboard installer needed for a ensuite (includes a walk in wardrobe). All materials will need to be included. -Floorboards -Underlay -Scotia -Door transition strip. Can organise a day for a quote/consultation and then set up a day for it to be completed. The room will need to be completed to a similar color to the rest of the rooms. Hoping to have one day for consult and day two for work and completion.

I have 9 sq m of hardwood flooring that needs to be laid over new sub floor. It's 12mm tongue and groove hardwood. I have the new boards. I'm after a professional carpenter/ flooring installer. You will need your own secret nailer. If you can sand and Seal too please let me know. Existing is poly matte finish.

Roughly 15-20 m2 out door area of new built. Wanting composite decking done. The asked price is not actual. Will negotiate and come to agreement upon discussion. The dirt in photos will be removed and the ground will be graded. Looking for someone to install the frame and composite decking.

Lounge room and kitchen needed floating floor boards laid materials supplied ready to go.

Install vinyl plank flooring in toilet. Approx 1 meter sq. Exact measurement is 1.8 metres by 90 cms. Remove old linoleum tiles.

I need the wooden floors in three smaller rooms (around 3x3m), a small hallway (about 2x1m), and stairs to be either carpeted or sanded and polished. Please provide quotes for both options. Thank you.

I have moved into a property that has badly damaged polished wood flooring and Lino . I am wanting laminate flooring installed or possible fix of existing flooring. I can buy flooring if I know how much I need.

4 bedroom house in Auchenflower, require timber floor repolish

We are looking for an experienced deck builder/carpenter to construct a front deck attached to our tiny home. Scope of works Build a front deck approximately 8.4m x 3m Construct a skillion roof over the deck, with the roof pitched away from the tiny home to maximise our view of the surrounding trees. Timber framing with quality workmanship suitable for long-term outdoor use. Install decking boards (happy to discuss timber vs composite options depending on price and recommendations). Include posts and roof structure. Leave space for future outdoor furniture and entertaining. We are looking for someone who: Is a qualified carpenter or experienced deck builder. Can provide examples/photos of previous deck projects. Is reliable with good communication. Can provide a written quote and estimated timeframe. Is happy to inspect the site before quoting if required. We are time sensitive and we understand it might not work in this timeframe with ordering of supplies and labour. My husband is a handyman and is willing to give a had to reduce time and cost. $10k for material we roughly know so how much is for your labour to help with this project. Location Sunshine Coast Hinterland, QLD. Notes We already have concept ideas and measurements but are open to practical suggestions that improve the design or reduce costs without compromising quality. Please include: Your availability. Estimated timeframe. Whether you are licensed and insured. Photos of similar work you have completed. Looking forward to hearing from you!

I am needing a refresh sand and polish of my beauty salon wooden flooding.

Polish timber floor in hallway and 3 rooms

- sand back and polish the floors of a Queenslander which recently had the carpet removed. 3 beds, kitchen and living room

Sand and polish hardwood floors – approx. 70m² Residential. Looking for an experienced floor sander/polisher to sand and polish hardwood timber floors in a house. Job details: • Approx. 70m² of hardwood flooring • Sand back existing floors • Apply polish/coating finish • Must supply own equipment and materials • Must have experience with timber floor sanding and polishing • Looking for a neat, professional finish Please include in your offer: • Your experience • What coating/finish you recommend • How many coats are included • Estimated time to complete the job • Availability Photos can be provided if required.

I need a Handyman with prior experience with Wooden Floor Sanding/Polishing. I will hire the Sanding machine and supply all materials. The work can be done on or after 10/06/2026.

Timber floor sand and stain to approx 90 sqm of upstairs internal area (refer to the attached plan. Dining area not included) Fill timber and nail holes.

Need to sand and polish the floor in 4 bedrooms

Looking for an experienced floor sander/polisher for approximately 74sqm of narrow hardwood floors in Beenleigh. Areas include kitchen, dining, lounge, hallway and 3 bedrooms. Looking for rough sand, nail hole fill, fine sand and polyurethane finish (preferably matte/water-based). Flexible on timing.

I need to get my Queenslander balcony sand & oiled

I decking Polish front side back side

floors in house are damaged and need to be ground back and polished to a satin finish

Wooden floor sanding polishing 3 bedroom house 150sqm approximately.

Sand polish timber deck and railing

I'm seeking a detailed quote for professional installation of flooring (to be supplied by me) at our home: Whites Road, Landsborough QLD 4550. Areas to cover: Lounge room Living room Entrance and hallway (Refer to attached plan marked in red; exact measurements pending.) A free on-site measure would be ideal to confirm square footage—our total building is ~345 m², so these areas may be 170–180 m². Please provide a breakdown including: Labor costs (per m² or total) Timeline for completion Required materials (e.g., underlay, adhesives, trims) Any prep work (e.g., subfloor leveling, old flooring removal) Thanks! Chris

I need an experienced flooring professional for a two-stage job in my kitchen in Aspley (QLD). Stage 1 – URGENT (before 17 Feb): • Remove existing cork flooring and cement sheet underlay • Deal with nails/staples properly • Leave timber boards clean and ready for kitchen renovation This part must be done before 17 February. Stage 2 – After kitchen renovation: • Sand and polish the timber floor • Match the finish to the rest of the house (appears gloss, but to be confirmed) • Open to professional advice on finish type to ensure a good match Area size: Approx. 2.4m x 2.4m What I’m looking for: • Experience with older timber floors • Own tools and sanding equipment • Ability to match existing floor finishes • Clean, professional workmanship Kitchen renovation is underway — sanding/polishing will be scheduled once installation is complete.

I want to polish and varnish my current stair treads. Want them to look brighter, similar to oak color. I've taken all out, twelve in total, dimensions of each are: 900 x 235 x 45 There are some nails and staples due to the carpet I removed. Two of the stairs are partly broken, I attach some pictures so you can see. I have the existing parts and the balustrade if needed. I can bring all the stairs to your place. Thanks

Refinish approx 16m2 of timber flooring. Peroxide markings. Only 2m2 have the drip markings I foolishly let 6% peroxide drip on the floor.

Timber floor repair / sand and refinish small damaged patch I need someone experienced in timber floor repair to inspect and fix a small damaged/discoloured patch on polished timber flooring near the skirting board. The area has surface wear / sanding marks / finish removed, so I need someone who can: assess the damage properly advise whether it needs spot sanding and colour matching re-stain / recoat / refinish the affected section so it blends with the surrounding floor as closely as possible

Looking for someone to sand back and refinish my outdoor timber bench seat, then seal it with a durable natural matte finish. Bench seat is removable and can be taken away to complete off site. I would like pickup and return included. Size Approx 3.0m long x 0.4m wide. Finish required Natural matte, low sheen. Prefer the most durable option for outdoor use. Happy to follow your recommendation, but I am leaning toward a quality exterior decking oil in a natural matte finish for longevity and easy maintenance. Scope of work: - Transport off site - Sand back to an even finish (top and edges, tidy up the ends, bottom if needed) - Prep and clean properly before coating - Apply stain if needed to even out colour, otherwise, clear natural is fine - Apply exterior grade protective finish in natural matte (2 to 3 coats as required, coat all faces including: top, edges, and ends and bottom if recommended) - Return Please include in your offer • Total price including materials and pickup and return • Product system you will use (brand and type if possible) • Estimated turnaround time • Photos of similar outdoor timber refinishing work Timing Flexible, ideally within 7 to 14 days.

Approx 26,60sqm of decking needs to be sanded down and refinished at my place. Divided in 2 different areas (front and back balconies). Easy access, floor level, timber in fair condition, no damage. Please send me an estimate or quote. Needs to be done before end of Jan 2026 but as soon as possible really. Cheers.

We need a floor sanded and refinished in Wynnum - about 14m2

This is just for 1 average sized bedroom. Summary of the jobs that need to be done: 1. Disassembly (partial) of bed and moved to another room - I will help with this 2. Removal and disposal of carpet and crap underneath, I can also help with this 3. Sanding and refinishing the floorboards and finding the correct stain and varnish to match the floorboards around the rest of the house. I will of course pay for the varnish and any materials needed for this. I also have random orbital sander if this helps. The part that I really need help with is refinishing the floorboards after the carpet is removed, and making sure the new varnish perfectly matches the other floorboards in the house.

Full sand and stain required for our original hard wooden floorboards. We have renovated our house and kitchen floor had vinyl so there’s glue and marks to be removed. Cabinets and kitchen will be complete by end of May, so 10th June start date would be good. Realise in person quote will be required prior to starting job.

Kitchen is being renovated and section of floor needs to be removed and replaced to suit new design. We have the material ready to go - Due date: Before Thursday, 29 February 2024

We need carpets ripped up and the floorboards underneath sanded and polished in 3 bedrooms, hallway and loungeroom - Due date: Needs to be done on Wednesday, 7 June 2023

hardwoord floor sanding and sealing