Find an experienced fireplace installation professional in SA

Stone cladding from ceiling to floor - existing fireplace to be removed. I already have the sandstone. About 5sq m?

Require the gas line to be disconnected from a gas heater so I can remove the heater. The gas line will need to be closed off. Heater is already uninstalled just connected. Quick job.

False wall built for an electric fireplace to be installed. Need all the framing, cladding, etc done ready for the fireplace. Can have my own electrician do the electrical work if needed

Gas line run in roof to gas fire place

We removed an old oil heater from fire place.now we want to turn it to wood fireplace.

Looking for a plumber to install fireplace - nectre wood fire

I have a new 42 inch smart tv and wall mount that needs to be installed above my fireplace. The wall is solid brick-so a drill with a masonry drill bit is required. Will need you to hook up and tune the smart TV (have purchased a tv antenna cable) so it’s all set and ready to watch.

I bought an electric fire place and would like to install it. Would need to cut the gyproc to put it . There is frame already inside to cater it and there is electric feed to hard wire it. Will need the coc.

We have a fireplace screen that needs a bit of tlc. The main screen needs to be welded back on the frame, and the whole thing needs a scrub (to remove rust and re-spray paint).

Install a fire place flue and remove existing flue

I need someone to clean the chimney on our combustion heater

Install wood fireplaces, inbuilt and freestanding

Replace a old fire place for a new fire place

Gyprock was cut out of wall where the fireplace was installed (this photo was prior to unit being installed). Original piece of gyrock has been cut and put back into wall, just need plasterer and painter to repair the cut,

Remove the old flue and install a new flue in its place. Install flashings etc to make it water tight.

Paint the wooden surround to my fireplace in white

Looking at buying a wood fireplace from bunnings that requires installation by someone licensed.

Existing fireplace - needs re-installation (we removed it to renovate the room. It is stand-alone, no electrical and we have a tin roof.

Install a fireplace hearth. Existing fireplace is bare bricks. Will supply slate hearth from Stonecraft SA

We have an electric wall mounted fireplace with 18.4cm depth and require a mantle to be built around it for better presentation. Would like the fireplace to sit flush with the front of the mantle. Example in picture.