Find experienced local fencing contractors in NSW

Latch on garden gate needs to be replaced. I have bought new latch so its just the labour

W'e're looking for an experienced handyman/carpenter to relocate a garden gate. * Remove existing gate and fence section from current position (photo) * Re-install the same gate a short distance away (see photo of plan) * Re-hang and level the gate so it swings and latches properly * Re-install or adjust hinges/latch as needed * If required: install new fence section and/or set posts in new position (happy to cover cost of concrete and materials)

Looking for someone to attach our garden gate. The fencing people attached the hinges to the hollow post without a timber sleeve or anything for the screws to grip into. The screws came loose in the wind over time until the gate fell off. You will need to provide the wood.

Build a basic fence around my veggie garden to prevent deers and wild life eating the produce

Take down garden fence, place at bottom of laneway, and remove steel posts. 6 or 7 panels. Move <100 yards down the laneway. Place neatly on the grass verge for council pickup. Steel post can be cut at bottom/ground level by grinding off.

There is currently minimal privacy from the neighbor behind my swimming pool – please refer to image “Current view - front.PNG” I would like to erect Metal Décor screens to act as a privacy screen in this section – please refer to image “Metal Decor screens image.PNG” The height of the screens will be 1.8 metres and I will obtain sufficient panels to cover the section which is approximately 12.5 metres long – please refer to image “Metal Decor screens specifications.PNG”. Ideally these screens would be fixed to new support posts established next to the existing fence (please see gap in image “Current view - side.PNG”) and the posts layered in height to provide that the screens do not slant down ie that are level.

Hi there we need a 1.8 metre high roughly 30m long wooden fence put up around our back garden we live up in frenches forest. Wondered if anyone can help out?

installation for garden fence, it is about 15meters long.

Need to dismantle as needed to replace two fence posts and reinstall gate and dismantled fence. See photos

We need a garden gate installed on the side of our house. We have the gate, fence posts and fence posts. Please see links below. The entrance to the side is 1340 mm at the widest (red line in photo) and tapers off to 900 mm where the concrete ends (green line). The posts can go into concrete. I'll purchase the brackets, hinges and door latch before the task begins. Location is Quakers hill, can do on weekends or weekdays. Gate - https://www.bunnings.com.au/specrite-1833-x-900mm-pre-oiled-merbau-horizontal-slat-gate_p8500232 Fence posts - https://www.bunnings.com.au/88-x-88mm-1-8m-f7-h4-kd-treated-pine-premium-post_p8423171?store=7384&gclsrc=aw.ds&gad_source=1&gad_campaignid=21122993677&gbraid=0AAAAADtbEB8l5-caJ3YTaGYnxB6bPr9HZ&gclid=Cj0KCQiA5abIBhCaARIsAM3-zFUyP9FTy1uY3BZP-dXKJ5B_CnwMGRIB8BeTKU1ZzeuUCprAX-gBu2EaArTpEALw_wcB

The garden gate latch has been difficult to close and on a recent windy day swung back and forth, hitting the gate stay out of the post. I need the gate stay repaired, install a new gate latch and the repairs made good. I have paint samples as required.

Build and install Windsor pine white fence in the front and back garden. 27 linear metres in total. 1 metre high. The locations are both on retaining walls. The front garden is 16.5 linear metres plus gate. The back garden is 10.5 linear metres, no gate. Materials to be supplied. The cost can be excluding the materials to be determined.

Garden fence has slipped out of line and one panel has fallen down. Needs to be repaired

We need large garden pots moved to allow access to replace the side fence

Wanted help in setting up a trellis on this frame. The length is around 6mts and there will be 5 horizontal rows. Would need two more rows of wire so the total rows will be 7. The ends need to have the turnbuckle for tension.

Hi, we are looking to get an iron fence in our front garden (currently brick wall) to match our neighbours. The wall is c5m in length and we are located in Newtown. I have attached some pictures of our wall and the neighbours fence and wondered if you could confirm whether this is something you can assist with and whether you can provide a rough quote based on the information provided or if you want to come out to see the house.

Get and install two side gates between house and side fences

Install 2x 1.8m high x 0.9m wide timber gates side by side on side of house. I will supply gates, gate latch, gate hinges , posts and screws for you to install.

Install 2x 1.8m high x 0.9m wide timber gates side by side on side of house. I will supply gates, gate latch, gate hinges and screws for you to install. You provide and install posts and bolts/anchors for posts

Hi there, We have just rendered and painted our external wall and had to remove our garden gate in the process. We have restored the gate and now want to reinstall. The brackets are very old so we may need to buy new hardware and a lockable latch. We are away and have Airbnb guests coming Sunday. We would love for you to go and look at the gate to see what hardware is needed, then go to Bunnings to purchase, the come back to install. We will of course pay for the required hardware. Would love for you to install tomorrow :-)

See photos. Existing Timber Gate and Posts require relocation from existing position/location to just in front of the gas meter which is located approx 1-1.3m away. No new door is needed just relocation of the existing door. You will need to either re-use or create a new frame and post on either side of the gate.

Large dog house to be built in hill top nsw 2575

Build a dog fence with a gate. Probably 2 metres by 2 metres. Shouldnt be a big job. Only needs two sides to be built not a full square

I am looking to get catnets installed in my backyard. The total linear length of the fences on two sides is roughly around 15m. Looking for estimates including material. The photo of the right side fence is before and now (with trees).

Relocation of gate approx 5 metres away

Relocation of double gates

I need to erect temporary timber or other fencing to prevent my dog from getting out and escaping my yard, it’s simple DIY stuff - Bunnings timber or mental sheets or fence and screw in to my current timber fence or may need to drill into a stone and screw in some areas. Secondary will be some fencing around hedging, this may need in ground pole or so to secure the fence Need someone to supply all material and utilise to complete the full job

I need someone who can provide a fence and also style the fence for the dogs

I need fence to protect dog. one side 280cm and need a gate and othersidee 8ft completely covered no gate

Fix pool fence/dog fence in yard. Will need to be attached to timber on one end and brickwork on the other end

My fence that’s about 22 feet it’s your typical metal fence that you see. It needs to get bolted shut on two sites of the gate and maybe a plank of wood to cover up one section. Willing to negotiate price

Hi I am looking for something easy and cheap to put in place down the side of my house to keep my 2 small dogs through the day , can any one help me I don't want it put into the ground needs to go towards brick work or fence line. I have a wooden one up atm but its falling apart.i want something like that but stronger and need to be able to push open

t-post and wire dog mesh fencing for property on bush with some hilly terrain

We require a dog fence for our rental property in federal. The fence needs to be 92metres approx around the perimeter of the house. A height of 90cm-1m will be sufficient and will need a basic entry gate, simple and galvanised steel vs coloured preferred to be cost effective. Previously the dog has had an old goat wire fence and it’s worked well. You will need to supply the materials and we are hoping to get it done as soon as possible. I have a video of the perimeter I can send through. Thanks!

Looking for someone to put something up to stop dog escaping through a small gap Needing something permanent Happy to pay for materials

The rental we are in has mesh (wire) laid over a gap near the fence around the perimeter of the house (approx 8- 10 metres to secure). It is not secured down along the outer edge and is starting to curl up and lift in places. The wire is very sharp and dangerous for our dogs and it looks unfinished/messy. We are not sure what the best option would be so open to suggestions - we were thinking maybe some raised planter boxes (example pic as last one) to cover or some treated timber edging that matches the fence.

1. Fix/replace existing pool fence to make it compliant 2. Provide pool compliance certificate 3. Remove any rubbish/material aftet the job is done

We are looking to block our dog from accessing carpeted areas of the house. We need two timber dog gates which would be hinged from a wall and latched on the other side to a timber stair case post. The two openings are approx 860 wide and 915 wide. The gates would be shorter than the stair handrail. I'd estimate we need them approx 800mm high. p.s. we have tried the adjustable aluminium baby gates before and they damaged the wall. We're looking for something longer lasting, better looking and more integrated with the stair balustrade.

I need 1 panel replaced on colorbond fence

I will need to have a wire barrier installed underneath the house, to keep the dogs from getting out. I have two metal gates which might be good option, they will need to cut to size. It will need to be secured to the piers.

The old timber fence was burnt down, so I’d like to replace it with a new Colorbond fence. Please rebuild the retaining wall and all the posts to make everything sturdy again. The fence length is 6.2 metres and the height is 1.8 metres

My colorbond fence door has come off the wall because the post got detatched from the wall. Have a look at the pictures and let me know if you can drill new holes to fix it? Thanks

Repair Colorbond fence 3m section damaged due to wind.

Colorbond side gate not closing anymore due to side fence pushing side poles holding gate Side poles concreted into ground.

Colour bond fence installation 35m I have materials

I require a Tasker to supply and professionally install two Colorbond steel gates and one matching fence panel at my residential property. 1. Driveway Gate (Double Swing): Type: Colorbond Double Swing Gate (Manual operation). Approximate Opening Width: 3.5m to be confirmed Approximate Height: 1.8 meters (Standard). Includes: Gate panels, required heavy-duty posts, hinges, and a secure lockable D-latch or similar. 2. Side Gate and Fence Section: Type: Colorbond Single Pedestrian Gate (Manual). Approximate Opening Width: 1.2m Additional Fencing: One matching Colorbond fence panel (approx. 2.4m long) to fill the remaining gap. Includes: Gate panel, fence panel, posts, hinges, and a lockable latch. Important Requirements: Posts must be correctly set in concrete footings for stability. The Tasker must confirm the total width and material list before starting. Would like the colourbond colour to be Monument "Black"

One fence panel needs fixing

Supply and install colorbond gate at 740W x1150H, with new latch, hinge and 1 x 50mm wall post. Boral brown color and old style sheets.

The sheet of colourbond has come away from the frame and need it either fixed or replaced asap . Happy to negotiate

Will need to carefully remove existing post footings which were cemented in after the Travertine tiles and brick fence behind (see red arrows in picture attached on posts to replace) - may need small jack hammer or hammer drill. Then install both new posts and re-attach fence.

I have a matrix fence extension and the legs for assembly. I need someone to attach it to the fence top. Length is only 2400mm

The Colorbond side gate needs to be narrowed or replaced as it does not close properly. The existing gate is 180 x 88 cm. It needs to be slightly narrower so it can close. The new gate needs to be lockable. The colour needs to match the fence.

Remove 2 broken colorbond cladding panels and replace with new ones. I can supply material or reimburse cost of materials + labour. Each panel is around 2metres or so and is the light cladding ones not the heavier colorbond steel that surround them.

Replace two colorobond panels , approx 4m across.

Fix gap between fence frame and sheeting and straighten gate. Rate: $128.50 (including GST)

Colorbond fence post(s) have corroded out. Either repair/replacement needed. Colorbond sheets and rails look ok.

3 panels have been blown out of my Colorbond fence and need to be put back in. Fee negotiable

Side gate 1.8 high 1.2 wide Fence to wall 1280

My colorbond fence has been fitted with a dodgey lock . I need someone to come out today , remove the old one and fit a new secure one asap please

Hi I have a side access gate made of colourbond 2m high by about 1m wide. The latch has come away and needs to be re fitted ( with rivets I expect)