Find trusted local electricians in Ryde

My current induction cooktop has a minor crack on the side. We will buy a new induction cooktop and would like the old one to be replaced with the new one by a licensed electrician. We will be buying the exact model as the existing one so wiring should remain the same. Location is Epping.

This is for a dance studio. The lights in one of our studios is not turning and one office type light is out and needs fixing/replacing please. Our surround sound is also not working and playing through the speakers and would like this fixed too please.

We need our outdoor light fittings replaced on the facade of our house. I have all the new fittings purchased and ready. It’s a simple replacement job. Will take 30mins at most.

I need a licensed electrician to replace an existing kitchen pendant light with a new LED pendant. • Existing light already installed and working • New light is ready to go (boxed and on site) • No new wiring required – direct replacement only • Ceiling access is standard plasterboard ceiling • Standard height kitchen ceiling • LED dimmable fitting (see photo of box) Job involves: • Removing old pendant light • Installing new pendant • Ensuring secure mounting into ceiling support • Connecting wiring and testing

electrician required to troubleshoot a faulty circuit at home. The circuit is 1 of 2 light circuits that feed lights to 1st floor. The circuit never tripped and still has a small current, possible loose negative connection. There has been no recent changes to the electrical wiring at home, the circuit stopped working out of no where. All the other circuits are still working fine, and the 2 light circuits have been wired to my solar circuit to run on battery backup in case if grid failure.

We are an electrical company. we are going to be upgrading a mainswitch board. we are running 16mm single phase consumer mains and need a licenced level 2 electrician to connect at the point of attachment. Please provide your qualifications.

Supply and install 6 x additional Trina 500W panels to existing solar setup. See photo of location, details below of the current setup. 500W - Trina Solar Co Ltd - (TSM-500-NEG18R.20) Solar Panels x 28 already installed. Sofar 3 phase 20kw Inverter already installed. Sofar 40kwh battery already installed. Required an additional 6-8 panels if they fit onto side roof shown in photo Must be licensed and will required proof before installation

NEW BUILD 1ST FLOOR COLOR BOND ROOF INSTALLATION - I WILL SUPPLY ALL MATERIALS NEW INVERTER Goodwe inverter SDT G2 5KW 3 PH & 15 x Jinko 440W Tiger Neo Bold N-type Bifacial (JKM440N-54HL4R-BDV (IEC 61215-2021)) ALL TIMBER WALLS OPEN PRE GYPROCK. EASY INSTALLATION. EXPERIENCED SOLAR INSTALLER ONLY PLEASE

Need an electrician to install one power point in our family room on the wall.

Looking for someone to replace outdoor bulbs with led lights like the ones in picture. I have the lights, there are 4 of them. Currently some are light bulbs and we want them changed to the ones in the picture

New spa getting delivered Need spa PowerPoint extended from already 15amp outside PowerPoint as new spa comes with only 2.5 meter power cable Need extra 4meter extended

I need a licensed electrician to install a double power point in my apartment. The purpose is to have: • One outlet dedicated to the fridge, and • One outlet for a modem / router Currently there is only a single power point in this location, and I would like it upgraded to a double power point for safety and proper usage. The job involves replacing the existing socket and ensuring the installation is compliant with Australian electrical standards. Please quote including labour and materials. Note apartment is an old one built in 1970s.

Need a certified technician to install an RJ11/NBN wall socket for internet access. The apartment only has an old 600-series telephone terminal. There is no modern RJ11 or NBN-ready socket installed.

We need 2 ceiling fans installed. 1 x in small home office 1 x front lounge room. New ceiling fans provided. Must be a qualified electrician. Install ASAP. Thanks.

Disconnect old oven and connect a new oven. Need LICENCED ELECTRICIAN. Located in Eastwood NSW 2122. I am pretty flexible with the timing. No need disposal. Thanks

Needing an electrician to fix or replace bedroom lights they are hardwired bulbs still work however they work intermittently and flicker and then shut off it could be the driver unsure needing someone experienced

Hello, We are looking for a licensed NSW Electrician to diagnose and repair a faulty illuminated sign at our retail store, in Macquarie Centre. The Issue: Our vertical, illuminated "EYETESTS" sign, which is mounted on a pivoting door, has an electrical fault. The light only turns on when the door is open and goes out when the door is closed. This strongly indicates a broken, loose, or frayed wire in the cable that runs from the wall into the moving door, likely at the hinge or pivot point. The Job: The task is to find and repair the wiring fault to ensure the sign remains consistently lit, regardless of the door's position. The scope of work includes: 1. Safely isolating power to the circuit. 2. Diagnosing the exact location of the break or loose connection in the wiring. 3. Performing a durable repair. This may involve splicing the wire, re-terminating connections, or replacing a small section of the cable to ensure it can withstand the repeated motion of the door. 4. Testing the sign thoroughly by opening and closing the door multiple times to confirm the light stays on reliably. Requirements: - MUST be a fully licensed and insured NSW Electrician. This is essential for safety and compliance. - You must have your own diagnostic tools (e.g., multimeter) and electrical repair equipment. - Experience with fault-finding in commercial settings or on moving fixtures is highly desirable. Location & Timing: Location: Macquarie Centre, Cnr Herring Rd &, Waterloo Rd, North Ryde NSW 2113 (exact location will be provided once the task is assigned). When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include your call-out fee and all labour required to diagnose and repair the fault. Thank you.

Hi,I have four downlights in my bedroom, and one of them has stopped working. I tested the light by swapping it to another position, and it works fine, so the bulb itself isn’t the issue. I also replaced the transformer, but that didn’t fix the problem, so it’s likely something else causing it. The other three lights are working perfectly. Please provide me with a quote that includes diagnosing the issue and fixing the light, including both labour and material costs.

Need to add socket for washer and dryer. Looks like power in the Greg box on the bottom left of picture. Would need to look at that connecting to it and putting a socket beside it. Socket can be external

1) Need to install lights in the bathroom. 2) Fan is not working. Need to check