Find trusted local electricians in North Ryde

Remove oven from property at North Ryde, transport and then install same oven in East Ryde

Looking to have several additional power points installed. Newly constructed home so would hope everything is quite accessible.

I want to install a 15AMP plug inside my garage so i can run a 15AMP Tesla charger. The distance to run the cable from the switchboard to where i would want to mount the powerpoint is only a few metres. I understand this is a small job but if you can quote me for the job that would be great. No need to provide the 15A power point as i will have one for you to install.

We have changed from gas oven to electrical and would need an electrician to help us install it.

need to replace and install 3 new appliances (90cm electric cooktop, 60cm oven, and a 90cm dishwasher). Have already bought new appliances with same sizes

Replace faulty sensor light in driveway

Require 3 pendant lights to be installed above kitchen counter. 2 locations already have LeD lights which need to be replaced while 1 new connection needs to be installed. A new switch is required for all 3 lights together. Photos of room and light attached

Hi, I need a licensed electrician to inspect and replace an outdoor air conditioning isolator switch. The isolator cover is broken and wiring is exposed. The air conditioning unit appears to be tripping, possibly due to the isolator. Scope: • Inspect existing outdoor AC isolator • Replace isolator switch with new weatherproof unit • Check wiring connections • Test circuit and ensure AC runs without tripping • Provide electrical safety compliance if required Property is in North Ryde. Easy access to outdoor unit (ground level). Please quote including: • Supply of new isolator • Labour • Call out fee (if any) Must be licensed electrician. Looking to get this done ASAP. Thank you.

Two downlights need to be replaced

I’m seeking a to relocate an electrical Rheem hot water system between two houses in North Ryde that are approximately 1 km apart. Scope of work would include: Disconnection of the system Safe capping/sealing of water and electrical connections Removal and transport to the second property No reconnection required at the destination Access at both properties is straightforward.

We need our outdoor light fittings replaced on the facade of our house. I have all the new fittings purchased and ready. It’s a simple replacement job. Will take 30mins at most.

I have a smoke alarm which is not a portable one I can take down and change the battery myself. I need someone who can do this. I have a 3-step ladder, not sure if a higher one would be needed.

I need to replace a power point switch. I already have the replacement.

Hello, We are looking for a licensed NSW Electrician to diagnose and repair a faulty illuminated sign at our retail store, in Macquarie Centre. The Issue: Our vertical, illuminated "EYETESTS" sign, which is mounted on a pivoting door, has an electrical fault. The light only turns on when the door is open and goes out when the door is closed. This strongly indicates a broken, loose, or frayed wire in the cable that runs from the wall into the moving door, likely at the hinge or pivot point. The Job: The task is to find and repair the wiring fault to ensure the sign remains consistently lit, regardless of the door's position. The scope of work includes: 1. Safely isolating power to the circuit. 2. Diagnosing the exact location of the break or loose connection in the wiring. 3. Performing a durable repair. This may involve splicing the wire, re-terminating connections, or replacing a small section of the cable to ensure it can withstand the repeated motion of the door. 4. Testing the sign thoroughly by opening and closing the door multiple times to confirm the light stays on reliably. Requirements: - MUST be a fully licensed and insured NSW Electrician. This is essential for safety and compliance. - You must have your own diagnostic tools (e.g., multimeter) and electrical repair equipment. - Experience with fault-finding in commercial settings or on moving fixtures is highly desirable. Location & Timing: Location: Macquarie Centre, Cnr Herring Rd &, Waterloo Rd, North Ryde NSW 2113 (exact location will be provided once the task is assigned). When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include your call-out fee and all labour required to diagnose and repair the fault. Thank you.

Ducted air conditioner cleaning and maintenance for 3 bedroom apartment

need replacing 3 downlights. labour and material

We need an electrician to have 6 led downlights supplied and installed in our family room, there's an existing ceiling fan light already, we want the downlights to have a separate on/off switch. Our house is single story and has manhole access to roof space.

Need licensed electrician replace old downlights with current led downlights

Install a power point. Power available on the wall. There is power point on the other side of the wall. Also fix the loose cable to light point in store room.

We live in an apartment and we have about 30 downlights that are <70mm with LED drivers connected straight to the flat TPS cable. We wanted to replace the downlight LEDs and the drivers with a 70mm ones but the cutout are slightly too small (65-68mm). So the task is to enlarge the current cutout to 70-75mm and replace the LED drivers with a normal surface connector. We already have the replacement downlights and can provide the small surface connectors if preferred.