Find local power point installers in Ryde

Looking to have several additional power points installed. Newly constructed home so would hope everything is quite accessible.

We are having some modifications done in our Kitchen to install a small cutlery drawer above our microwave oven (as a separate Airtasker Task). However, for that task to go ahead, we need to ensure the Power Point to our Microwave Oven does not clash with the new drawer to be installed. The current Power Point is in the top left hand corner of the enclosure, we require it to be moved downwards by about 100 to 150mm. I think the Power Outlet is surface mounted to the back of the enclosure, and from what I can tell, the power cable comes into it from the cabinet wall on the left hand side, which is the sink enclosure.

Hi, I need to install a ceiling power point for a projector in my Meriton apartment. 0 Access: Use the nearest downlight opening for wire fishing. 0 Power: Constant power (main line) is required, not a switched light circuit. 0 Compliance: Certificate of Compliance is required. Please let me know if you can do this and provide a rough quote. I have attached photos of the spot.

Looking for a licensed electrician to install a single power point (GPO) that I will provide into a kitchen island. Installation details: run cabling from the nearest wall power point, through a timber floor over concrete to the island. Property is a Strata apartment (Owners Corporation may require approvals). I need the electrician (or a carpenter if required) to advise on the best installation options, whether floor cutting or underfloor routing is feasible, and to advise on and arrange any necessary strata/owner approvals and permits. Please include supply of a certificate of electrical safety/compliance on completion. Access to kitchen and building entry will be provided; please advise if you need any specific information or strata documentation before quoting.

I need more power outlets at 2 different locations. I have checked stuffs with stud locator and both locations are free from any obstacles. The details are below. 1. Kitchen Cabinet: I need 1 x power outlet (2 x outlets in single body) in the kitchen cabinet. It shares a wall with NBN cabinet behind the wall and there's a power outlet in there. The wall is gyprock. 2. Kitchen Wall I need 2 x power outlets (4 x outlets in a single body or 2 x separate bodies) near the light switch. We can connect to power in the light switch or to the power outlet on the same wall in the same alignment but 1-1.2m below. The wall is gyprock. Please check out photos and let me know if you have questions.

The existing power point (white plastic rectangle sockets) need to be taken off and the wires covered so that it is safe for the skirting boards to be installed. Want the covers removed so it’s easier for the carpentry to make a small hole for the power points to be poked back through rather than cutting out a large rectangle piece for the existing power points. There are three rooms - approx 3 power points each room. Location Gladesville Can be done today, friday or Sat

One of the power point is not working (can’t plug in the socket). Would like to repair it or install a new one. Please advise the work and fee.

Hi, I have a double power point in my kitchen that is broken. Looking for a licensed electrician to replace it with a new double GPO. I am located in Epping (near Rawson St). Preferably looking for Alan T. if available! Thanks.

I need an electrician to replace our outdoor light with a new floodlight. Then install a single power point cover to existing wires under kitchen sink. Floodlight and cover provided.

Already done for quote for cabling of electrical works.

I need to install 1/2 extra powerpoints in my garage.

Need an electrician to install one power point in our family room on the wall.

New spa getting delivered Need spa PowerPoint extended from already 15amp outside PowerPoint as new spa comes with only 2.5 meter power cable Need extra 4meter extended

I need a licensed electrician to install a double power point in my apartment. The purpose is to have: • One outlet dedicated to the fridge, and • One outlet for a modem / router Currently there is only a single power point in this location, and I would like it upgraded to a double power point for safety and proper usage. The job involves replacing the existing socket and ensuring the installation is compliant with Australian electrical standards. Please quote including labour and materials. Note apartment is an old one built in 1970s.

I need to replace a power point switch. I already have the replacement.

Need attendance to confirm job can be done & free quote once confirmed. Ceiling fan will be purchased after that time. The job is in 5th floor apartment in Ryde / Meadowbank area. If vehicle is lower than 2.1mtrs in height visitor parking is available.

I have removed a Gyprock wall which had power inside. That power ran to 3 power points and one light switch. I want to cut the cables back to the wall. They are coming out of and reinstate the switches).

Install lights in in a 2 bedroom unit - 6 in total. Replace powerpoint and switch plates - approx 15

A power point needs to be replaced

power point socket is faulty