Find trusted local electricians in Mornington Peninsula

2009-built 2-storey townhouse Remove the 2 existing failed hardwired smoke alarms Install 2 x supplied FirePro FP240B hardwired smoke alarms — one upstairs hallway (replacing existing), one downstairs hallway Run interconnect wiring between both units Test both alarms on completion Issue Certificate of Compliance for Electrical Work (CCEW)

Dryer spinning but not heating

To move a power point about 40 cm. To add a point for a bathroom heater.

There is a faulty Redback inverter that needs to be replaced with a Sungrow 5kw inverter. Stock in the house

I need a licensed electrician to do the following tasks for me: 1) Relocate the meter box to the right hand side of the window as shown in the picture. Please note an asbestos removalist is removing the whole ceiling and there will be open access there. 2) Move the light 200mm upward (I'm opening a door there) 3) There is a wall power outlet on the inner side of the wall, I need it to be moved leftwards 1meters.

Wanting to change over all my light switches and GPO's in a 2 storey house. currently have old puma switches. want to change over to hagar silhouette with push buttons ( not led). please just quote on labour for a day. we can discuss purchase of switches later. there are approx 45 switches and gpo's.

Need a power point inserted to plug in a dryer in the laundry There looks as though there is an electric cable in the top part of the cupboard, but not in the bottom. We are looking to put the dryer at the bottom

Install a ground floor split system air conditioner.* Do not need to supply the unit - unit is on the premises - just needs to be unboxed and installed. *Please note - you must be fully licensed and insured and be able to issue an ESV Certificate of Electrical Safety (COES) and a VBA Plumbing Compliance Certificate on completion.

I have bought new ceiling fans to replace two existing fans in our bedrooms and I’d like to register electrician who can install the new units for me

I have a couple of lights that have stopped working.

I’d like an outdoor electrical outlet installed on the outside of our house. I’m not too fussed exactly where and I’d like it to have two outlets and minimum.

1. the dryer keeps turning off 2. the light in the bedroom is not working 3. the bathroom heat lamp Have guests checking in today so would like it done asap by an electrician

We need assistance connecting a gas oven to our electrical -Attached is an image of the wiring diagram for the oven (10 amp plug) -Main switch board of the house is full, require an individual switch installed -10 amp switch install, baseplate already in wall with no power connected , alternatively happy for it to be hard wired, whatever is easier. -kitchen back directly into laundry with easy roof cavity access directly behind the oven.

I need a licensed electrician to replace an outdoor 240V pedestal/bollard light in Mount Eliza today. The existing stainless steel pedestal light is to be removed & a new pedestal light fitting to be installed (like-for-like replacement). The wiring is already in place at the base. Scope of works: • Disconnect & remove old pedestal fitting • Install & secure new pedestal light • Connect to existing 240V wiring • Ensure weatherproof sealing • Test & confirm working correctly • Leave area tidy This is located in the garden beside a path (easy access). Must be: • Fully licensed electrician • Able to complete the job today Location: Mount Eliza

Annual Compliance check, One is beeping that needs replacing

i need 3x deta smart light switches changed to 3x normal deta switches. smart switches are playing up. i have purchased new switches. location - sandhurst 3977 vic

Have a new light switch and power switch just need new ones fitted changing colour

Our house is being demolished but I want to save the pendants. Can go anytime before Wednesday night.

Needing an electrician. Experienced and qualified . Needing 2 cords thread through the wall behind our wall mounted tv. We already have cords thread through but my husband has changed the sound system and added his Xbox so need those cords in the wall also. Ideally would love to get done today 1.2.26

I took about a vintage doll and accidentally pulled some of the wires out of the circuit. It was functioning prior to this so I know it works. Pretty sure where most of them go but it’s not my field obviously. Happy to drop off/pickup from anywhere around Melbourne