Find trusted local electricians in Kensington NSW

Some of the switches in my apartment are broken and some are hard push.

My old oven, a Miele H6400BM, needs to be disconnected from its hardwired power supply, and my new oven a Miele H7240 needs to be connected to same supply. Requires a qualified electrician. Pictures attached showing old and new connections.

Looking for a licensed electrician to inspect and repair a bathroom light that intermittently fails to turn on. The issue is isolated to this light — no other appliances on the circuit are affected. Suspected faulty switch, loose wiring, or a short. Need someone to: • Diagnose the fault • Advise on the cause • Fix the issue (replace parts if needed) Located in Kensington, Sydney. Flexible with timing, but the sooner the better. Please include call-out fees and hourly rates in your offer. Ideally looking for someone who can provide a rough best-case and worst-case price range upfront.

Power in one section of house keeps cutting out. Circuit breaker in the switchboard flicks down, suspected issue is overload due to multiple appliances (inc electric blanket) plugged in. Currently have surge protector powerboard but will need to install SPD on circuit breaker.

We have a washing machine and a heat pump dryer stacked. It is on the opposite end of the laundry sink where the waste is. We currently run a waste hose extension across the wall to the sink -- but the washing machine does not appear to have enough head and it is leaking/not draining properly. We are hoping to get someone to help fix this and, if possible, install the waste hose for the heat pump dryer. Thanks!

Need testing and tagging done by fully qualified electrician for max 10 portable kitchen appliances and leads used for events and markets.

Need to remove old existing lights and replace and install with new light fittings. Total 6 lights to be replaced

Qualified electrician to run one cable from an appliance up the wall to the electrical outlet The distance is not more than 1 m very close, but you need to run the cable up the wall so it doesn’t run on the floor

looking for qualified electrician to replace a cooktop. i alredy have the replacement cooktop at home, its the same size as the previous one. Just need an installation.

We are looking for a skilled, licensed, and insured electrician to install 1 new electrical outlet into our bedroom wall near a power point that's on the same wall. We are on the 2nd floor of an apartment building. This will also likely include any necessary drilling, wiring, and wall repairs. Thanks!

Van Electrical Setup & Wiring Assistance Job Title:Auto Electrician Needed – Wiring & Setup for Van Electrical System Job Description: I’ve got a complete 12V electrical system that was taken off a motorhome, and I need help wiring and installing it in my van. Most of the components (battery system, Redarc charger, BMPro charger, fuse box, and RV Electronics monitor) are already there – it just needs proper wiring and setup. I also want to add more electrical components, including: ✅ USB & 12V outlets to charge phone & laptop ✅ LED lighting setup inside the van ✅ A DC output for a fridge What Needs to Be Done: - Wire and connect the existing battery system, charger, and fuse box. - Ensure solar panel connection is ready to charge the batteries. - Install and wire USB charging ports, LED lights, and a fridge outlet. - Double-check connections, fuses, and safety for a reliable system. Requirements: 🔧 Experience with 12V auto electrics(motorhomes, vans, caravans, etc.). 🔧 Must bring own tools (multimeter, crimpers, soldering gear, etc.). 🔧 Understanding of Redarc, BMPro, and RV Electronics systems is a plus! 📍 Location:Kensington 🕒 Flexible timing – looking to get this done ASAP. 💰 Open to offers – let me know your price! If you’ve got the skills and experience, send me a message with your quote and availability! 🚐⚡

Resolve Daikin split system indoor unit not draining (assumed the issue) condensation/water build up. The unit also intermittently makes small ticking noise when on low fan. Indoor unit is Cora CTXM25RVMA System installed 5 years ago Can be flexible in times, ideally before Thursday 5pm

Replace old power point (3) and light switch (3) covers. Total six replacements needed and provided by you. Advice required on replacing light fitting and general wiring needed. Licensed electrician required.

Moving house and need to remove 2xceiling fans and install original light fittings

Hi, I need to install 12 standard solar panels ( 19.7KG, 163 cm*99cm) and the inverter. Skillion roof (colourbond) as shown in the photo. Panels were disassembled from another house, the existing fixtures are available as well as some new side clamps. Task 1: Install the panels to the roof, and mount the inverter on the wall connect all the wires I have some wire, 16 AWG ( about 10-13 AMP). 2 pin, 5 meters， 22 AWG (7 -8 AMP), 2pin, 20 meters. If different wire etc is needed, please consider the cost in the quote. Task 2: (if you are an electrician) Connect it to the utility grid.

Electrician for handyman to fix these cables to the wall

11 Ceiling Light Fittings to be replaced (10 are old Alabaster Oyster light) one is standard light globe bayonet) 9 are being replaced with Hue Enrave S (6 are attached to concrete ceiling, 3 to dropped ceiling\plasterboard ceiling if got term right) The remaining two lights are Ledvance Orbis Ultra Slim. Additional tasks looking to have done include: 1. Moving one light switch about 5-10cm to the right. This switch is in brick wall. 2. Install double power point onto kick board, there is a cable behind kickboard already from when kitchen renovated but couldn’t be installed at time as floors were being done. (Double power point already purchased. 3. Replace 6 light switches that have yellowed with identical new ones (already purchased)

-heating light in bathroom not working only 1 year old -light switch and fan control in the living room falling apart... need a new one -Outside light not working, need a new light installed -Bedroom fan/light not working (no remote) but wanted to set up a control from the wall... if not possible than dismantle and removal of old fan.

I have currently electric boiler 125l and it’s too small to keep enough hot water so I wanna install continuous flow gas heater- yes there is gas installation on the property.

I have 6 vertical blinds that just need help reconnecting with the electrical remote. Not pairing correctly.