Find trusted local electricians in Kellyville

IXL installations *2 Ok reply

JOB DETAILS - Replace 18 existing downlights with Philips hue smart lights (already purchased). - install Eufy Security Floodlight in back garden. Job will involve moving existing outdoor wiring to other side of the gutter (picture attached for reference). Eufy security floodlight already purchased. Pictures attached for reference. Any questions, let me know

We are seeking a fully licensed and reliable electrician to carry out an inspection and replacement of a faulty wall-mounted switch panel located in the laundry room of a residential property in Parklea, NSW. The switch panel controls the light, exhaust fan, and ceiling heater. The current unit is no longer functioning as intended and requires a licensed electrician to inspect and replace it to ensure the system is operating safely and complies with NSW electrical standards. Scope of Work: • Attend site at the Parklea property. • Inspect the existing wall switch panel (light, fan, heater control). • Supply and install a new replacement switch if required. • Test the installation to ensure safe and proper operation. • Provide a Certificate of Compliance for Electrical Work (CCEW) upon completion. Important: • This job requires a licensed electrician. • No photos are available, so an on-site inspection is essential before replacement. • If I am satisfied with the quality, reliability, and professionalism of your work, you will be considered for ongoing subcontracted electrical work for my business across future projects.

Fix or swap the electric power control switch in the laundry room, the button for lighting and heating don’t work properly

I need to install two new downlights in the ceiling, but the existing power points are too far to reach. I’m looking for someone experienced in accessing ceilings who can connect both lights in the same room. The lights will be about 2 metres apart.

I'm looking for an experienced and licensed data cabler or electrician to install two Ethernet cables in my home. Current Setup: I recently upgraded to NBN Fibre to the Premises (FTTP). As part of the upgrade, the modem was relocated from Bedroom 4 to Bedroom 1. Previously, my TV in the living room had a working Ethernet connection, but that was lost when the modem was moved. What I Need: Run one Ethernet cable from the modem in Bedroom 1 to Bedroom 4. This may restore the Ethernet connection to the living room via the existing cabling. If the above doesn’t restore connectivity to the TV, then run a second Ethernet cable directly from Bedroom 1 to the TV in the living room. Looking for advice on the most efficient and cost-effective way to restore Ethernet connectivity to the TV. Please provide a quote for the job, including: 1.only Labour and 2. Labour + Cabling and any required wall plates etc

I need to replace two old smoke alarms. One of them was beeping, so I removed it. It appears to be outdated, and I would like to replace both units. I haven’t purchased the new alarms yet, as I’m unsure which models would best fit. Could you please provide a quote for: 1. Labour only (if I supply the smoke alarms) 2.Labour + supply of suitable smoke alarms (including supply and installation) Let me know if you need any additional details to assist with the quote.

Put led strips as shown in the attached diagram. Need controller for each area. Supply and install full. Rgb preferred but single colour good quality neon tube also okay. Phone connectivity required. Approx 100m I think.

I am looking for electrician who can install 10 downlight for my single storey house. These lights are addition led lights which I am installing in my living room g room. Lights will be supplied. Secondly, I need to install wifi module for my air conditioner - daikin wifi module will be supplied.

Need to fix a non electric bidet

3 switches need to be replaced or repaired. Looking for quotations.

Need to install electric fireplace with gyprock frame built. Fireplace to be installed under the TV with casing built around the fireplace and TV

2018 Toyota Prius on slow mode

I need 1 new power point installed on a wall to plug in an electric fireplace Next 2 images show adjoining wall with currently installed power point for reference.

Solar Panels not performing properly. One electrician said some of the wiring needs to be replaced

Need someone to replace a switch. The current switch is a push switch which is not working. Fine to get it replaced by a regular switch instead of push.

To have a light weight pendant hung the pendant weights approx 7kg it can be hooked up to the current downlights so that when downlights come on pendant comes on with them I have added a photo of before it was gyprocked and after it will be hung next to air con vent my home is a double storey home

LED light is flashing， LED driver may be required replacement by new one.

Need to install & mount TV on the Garage wall

I have purchased 3 AC ceiling fans with lights and need them installed.