Find trusted local electricians in Castle Hill NSW

Remove 3 flood light ring cameras and one ring door bell (see photos attached) and reinstall 1 flood light camera onto existing wiring at another house two minutes away. Castle Hill location.

Certified Electrician required for wiring top LV side of the the panel. 1. All breakers need to be wired as shown in the drawing. 2. Incoming wires to the MCB need to be terminated inside the termination box. 3. Termination box to be mounted outside the main DB panel. See drawing for detail

Putting down lights in theatre

Someone broke into house we are moving into and pulled the light fitting...resulting is wires hanging down from ceiling

Looking for a local electrician to replace a ceiling light as below photo. The handyman said something may have burnt out inside so electrical work may be required. Also, seeking help to replace the 4 power points as bleow photo. Please let us know your availability. materials and labor cost with the quote. Thanks.

I have Honda Generator, that havent been used since i brought. Need to service it. If want someone to come onsite and service it. there is plenty of space and power etc to help service.

1) replace broken b22 batten holder . 2) Install 3 tracklights to replace exiting dome lights 3) Install IXL and new switches in 2 bathrooms

Need to replace a few switches that are faulty/cracked or loose on wall

Hyundai accent will not drive , a mechanic came out and said it was mechanically fine and needs an auto electrician to look at the problem. Please if somone could help out

Received a quote (see below) and would like a double opinion/ second quote. Quote: Decommission exisiting Overhead Service Cables. Supply and install Overhead Service Cables. Supply and install Point of Attachment. Replace the 3-phase consumer mains - point of attachment to the switchboard Supply and install new 63A 3-phase consumer mains. Install new 80A service protection - upgrade meter wiring and main earthing system Install new 63A 3-phase main switch at the main switchboard Upgrade the existing switchboard - while upgrading the consumer mains. Remove asbestos meter panel, old fuses, etc. and supply a new compliant switchboard panel. Remove existing fuse protection and associated cabling Reinstall existing electricity meters (no allowance for meter upgrades) Upgrade the switchboard to include a new sub-board/enclosure to house new equipment Install individual RCD (safety switch) protection for all lighting and power circuits Install individual RCD protection to all subcircuits to comply with current standards Please Note: RCD safety switch protection to all power & lighting protects people from an electric shock. No Allowance to repair any circuit if RCD is installed & a fault is found. Submit all relevant paperwork to Endeavour Energy. Include all applicable supply authority fees

We’re looking for a licensed electrician to inspect and repair a large LED mirror in Castle Hill NSW 2154. The mirror measures 2200 mm x 1200 mm x 100 mm and has three-way LED lighting with dimmable touch controls. The LED lights do not work when the button is pressed.

Hi there, I need a qualified air conditioning technician or electrician to diagnose and repair my ActronAir Classic ducted system.The indoor fan is running perfectly, but the system is only blowing cool room air when set to Heating mode.Outdoor Unit Model: ActronAir CRA130S (13kW Single Phase)The Symptom: When heating is turned on, the indoor fan works, but it doesn't get warm. I suspect the outdoor compressor is not kicking in, or there is an issue with the soft starter/run capacitor which is a common fault on this model.Access: The outdoor unit is easily accessible on ground level.Please quote for the initial diagnostic visit and minor component replacement (if it just needs a standard capacitor). If it requires a new soft starter or a more complex part, we can discuss the additional cost on-site.Must be fully licensed (ARC Tick / Electrical License). Thank you!

Light at the top of the fridge is starting to leak. Model - Samsung RT32K5035WW/SA Need someone qualified to have a look and tell me why? Also, it would be great to have some assistance setting up new NBN router and trouble-shooting any problems. This would need to be after 3:30pm. Thankyou!

This job is for electrician work to be completed tomorrow Monday. Replace 4 x exhaust fans 1 x outdoor light replacement in retaining wall 4 x outdoor sensor lights 2 x fix 2 down lights with a fuse problem, they flicker and then don’t work. 1 x fan light, similar to the usage above, flickers and the bulb blows quickly 2 x disconnect 2 down lights, going to plaster them over New light fittings supplied by us.

I need additional 6-8 plug points on the outside of my brick house. We have power source on the other side of the wall or close by. In addition also want 2 tube light replaced.

from switch to the garage, it is about 8m, I would like to install in the middle of the garage, it might be another 2-3 m long

I need to get some gyprock work done around my house. Work includes: 1. Patching all electricians cutouts (around 25) 2. Patching all carpenters cutouts (2 total) 3. Fixing one corner of a wall (photo attached) 4. Fixing existing gyprock on two walls. (Photos attached) All quotes must include sanding as well, no painting required as I will repaint the entire house.

Looking for a licensed electrician in Castle Hill, NSW to complete the following work: * Remove existing light fittings and install 4 new LED oyster lights in 4 bedrooms. * Remove existing kitchen lights and install 3 new pendant lights. * Remove the existing porch light and install 1 new bunker light. * Remove existing exhaust fans and install 2 new exhaust fans (laundry and ensuite). Please provide a fixed labour quote. I can supply the new light fittings and exhaust fans if required. Looking to have the work completed as soon as possible. Thank you.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Westfield Castle Towers, to inspect and secure a loose downlight. The Issue: One of the recessed ceiling downlights located directly above our main customer display table has come loose and is sagging out of its ceiling cutout. While the light still functions, it is partially detached. The Job: The task is to safely access and re-secure the downlight so it is flush with the ceiling. The scope of work includes: 1. Safely accessing the ceiling above our central display island (an appropriate ladder/steps will be required). 2. Inspecting the downlight and the surrounding plasterboard. 3. Re-securing the fitting into the ceiling (adjusting or replacing the spring clips, or reinforcing the plasterboard edge if it has deteriorated). 4. Testing the light to confirm it is secure, flush, and working correctly. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools and a suitable ladder to work safely above our display table. - Ability to work cleanly and professionally in a retail environment. Location & Timing: Location: Level 2, 6-14 Castle St, Castle Hill NSW 2154 When: URGENT - As this is located above a high-traffic customer area, we need this resolved as soon as possible. Please state your earliest availability in your offer. Please provide a quote for the complete job. Thank you.

Replace 5 existing light fittings with oyster lights: 3 in the bedrooms and 2 in the bathrooms. I have already purchased the oyster lights and will supply them.