Find trusted local electricians in Donvale

Electrical Safety check for Certificate of Compliance.

Dead easy job for person with right skill set. I need someone to change an external 'safety light' fitting. The fitting is a Crompton Australian sourced acrylic ball type light fitting mounted on a rigid upright pole. (see photos) The fitting received a very light knock from a vehicle which fractured the collar fitting on the fitting itself. There was/is no damage to the wiring and the globe actually still works. Only the dome (connector lugs) were damaged. I have the identical original (spare) unit on hand as pictured, so I know it is a one for one exchange. Basically just remove the collar and replace the wiring into the new base. The previous installer did use a light amount of silicone sealant around the base collar, otherwise it would be very much a handyman job other than working with 240 volts. This should be a dead easy job for anyone who has the appropriate skills. Pole is only 5 foot high, so no aerial work. Area around pole is 100% clear as shown in picture and easy to work in. I understand fully that my asking quote may have to be slightly reviewed on site, if the job proves to have any complications. I am a 100% reasonable AirTasker home owner. There should not be any such problems of course. (as I see it)

The switch is pushed in and the power point can't be used

Part of our house power plugs are not working. Some of the switches form meter keep on tripping. Tried turning off few appliances but still not working.

Existing, damaged ceiling light fitting to be replaced with new Temple & Webster flush mount ceiling light

I need a pendant installed in kitchen by an electrician

Sensor not working and light just flashes intermittently. whole unit will need to be replaced with the new one pictured

Need 2 globes changed, one was replaced but won’t work. Also need two switches replaced, have bought the replacements.

Need a new stove and rangehood installed. I can get the old one taken out and removed before you arrive to do the job.

I bought this lamp off Amazon US without thinking about the wiring. I need someone to help me make it work here - this may be as simple as changing the US plug to AU (note that I have tried to use an adaptor and it doesn’t work, so maybe there’s more to it - please tell me if so). The lamp is hollow and the wire tracks up the middle of it, so removing it shouldn’t be too difficult https://www.amazon.com/gp/aw/d/B001BZHNSA?psc=1&ref=ppx_pop_mob_b_asin_title

I need a light bulb holder installed in the ceiling, the electrical wiring already exists. There is easy access to the ceiling area.

Need a comparative electrical quote: 1) Service Call -Covers driving time, vehicle costs, admin time and electrical certificate of compliance (if applicable). 2) Entry - Replace pendant light to downlight (customer supplied) 3) Piano/living room - Replace pendant light to downlight and install additional downlight (customer supplied downlights) 4) Kitchen - Replace 2x downlights into 2x pendant lights (customer supplied) - Screw back switch 5) Dining room - Delete 1x pendant and install 4x downlights (customer supplied) 6) Master Bedroom -Replace pendant light to oyster light (customer supplied) -Replace wall lights (customer supplied) 7) Bathroom -Install 4 heat tastic light (customer supplied)

Electrical work around the house. Need it done by Friday 26th - can do any day this week. Please note all cables and power points will be provided by me. 1. Chase CAT6 cable in ceiling from wireless router to network data cabinet - approximately. 2M. Flat roof, cavity in ceiling - plaster. 2. Chase electrical wire in wall - option to either connect to existing power outlet on the other side of the wall or another outlet 2M to the right hand side. Plaster wall. 3. Relocate power outlet for speaker - double brick wall. 4. Run network cable to ceiling 5. Connect wireless doorbell to power - 12V. There is existing 12V power on the other side of this wall powering the gate open/closer so if it is possible to piggy back off this. 6. Chase power for Speaker. Can either come from eave or from the existing power on the bottom left of the brick wall. 7. Chase power to behind TV. Double Brick wall. 8. Chase power to behind TV. Double Brick wall. 9. Install outdoor powerpoint. 10. Install outdoor powerpoint.

UPGRADING POWER TRANSMISSION LINES TO HIGHER VOLTAGE change to a new box and switch box.

We have got a small room with 4 dimmable ceiling LED lights. 2 out of 4 lights have stopped working. 1 of the 2 lights which don't work turns ON by itself randomly but it doesn't switch ON most of the times. Attaching the pic of the room ceiling and the brand of LED lights which are installed. Need an electrician to check the wiring and replace the 2, if required.

Need a qualified electrician to disconnect a hard wired external control box and replace with a power point.

Need two wall lamp installed - Due date: Needs to be done on Wednesday, June 28, 2023

We installed a new electrical switchboard for the whole house a few weeks ago and since then the electrical oven will turn on, but then power off after 1-2 minutes. Not sure why. Would like someone to fix the oven, I assume it's an electrical issue of some kind. - Due date: Flexible

LED slim wall light already purchased for direct replacement of existing unit - Due date: Needs to be done on Tuesday, 11 April 2023

Bosch oven with microwave model HT5HB84K The start/play button is not working - Due date: Before Friday, 24 March 2023