Find trusted local electricians in Croydon VIC

I have a 17kw heatpump ready to be installed next to the filtration system, to heat the pool. The task involves connecting the water flow including a bypass line, and, wiring as required to the power box at 15m via under the floor.

Down lights stopped working in room … some other lights in house not been working for some time , need fixing too .

I need a licensed electrician to install around 50 new downlights in my single-storey home. There are also a few existing downlights (see attached photo). Access to the roof is through a manhole inside, and the roof is tiled. Please include in your quote: Installation of approx. 50 new downlights (let me know if you can supply them or if I need to provide). Labour and materials (if you supply).

Mains powered smoke alarm faulty. Needs replacing. Hallway is high and requires a ladder.

Install 3 down lights add 2 power points remove fluorescent light

I need 3 new powerpoints and 8-10 light connections for outdoor lighting on walls.

Looking to have licensed electrician to fit off 5 power points and install 2 power points in bathroom for led mirrors, more work to be considered afterwards

I require one Mitsubishi split system air conditioner to be deep cleaned, including any gas refill if required. Additionally, I need repair service for a Homemaker split-type heat pump (wall-mounted room air conditioner), which is currently not functioning — no lights or power connection are detected when attempting to start it.

Need done ASAP. We need a GPO removed and the cable extended and terminated into new oven

PowerPoint needed in a bedroom Might need additional one in second bedroom if not too difficult but happy to discuss further for this

replace light fitting with IXL 3in1 heat vent light

We have seven new ceiling light fixtures to replace old light fixtures. The old fixtures include batten and hanging pendants. The new light fixtures include ceiling mounted and two handing pendants.

Three light fittings were removed from the ceilings which will need to be repatched

Qualified technician needed to replace 5 pieces smoke alarm, ceiling mounted. To issue certification after job is done. We have the smoke alarm already .

Some power points can't be used and will trigger outage if been used. including light switch and power socket

(updated) I need a licensed electrician to install seven (7) power sockets and two (2) switches, 2 or 5 ceiling lamps, and connect all the existing wiring in my workspace shed. All materials (sockets, switches, cables if needed) will be provided separately. The insulation and framework are already in place. The wiring is pre-installed but needs proper connection and safety checks. A standard 2.5mm wire has been installed for power sockets and 1.0mm for lights, both fully visible in the shed. Additionally, the job requires digging the ground and laying underground wire from the garage switchboard (Switchboard No. 3) to the shed. Based on the attached ground plan, Path No. 2 is most likely the correct route to follow. The estimated cable length required is approximately 29 metres. Please include in your quote the labour for trenching, running the cable, and installing the most appropriate switchboard in the shed. Must ensure the entire installation is compliant with Australian electrical standards. I’d like a quote upfront for the labour cost before proceeding. Attachments: - Shed and property ground plan with proposed trench path (Path No. 2) - Image of garage switchboard (Switchboard No. 3) Please note: I only require a quote for the labour cost. You are welcome to provide an estimate for the materials if needed, but I will cover all material costs separately. Materials will either be supplied by me directly or purchased based on your advice, with a separate receipt provided for any reimbursed items.

Split system in upstairs bedroom frequently showing “F0” error and ceasing to blow cold air.

All light fittings supplied. 3 x ceiling fan replacement (with built-in LED light). Current ceiling fans are old and noisy. 5 X Replace existing oyster ceiling light fittings with new LED ceiling light fittings. 2 X Relocate existing DGPO and TV point from floor level to behind TV at approx 1800mm height.

Light switch cable has break somewhere in line so looking to re wire down lights through to new light switch and make current switch a double switch. Worth it only for someone already in the area

Looking for a professional to install a brand-new AC system for a bedroom (2.5m x 2.5m). Details: Type of Installation: Wall-mounted (Back-to-Back) AC Specifications: 2.5kW unit Building: Single-story, brick wall, tile roof Distance: Approx. 20m between the switchboard and installation point The price must include all costs, including certification.