Find trusted local electricians in Baulkham Hills & Hawkesbury

Supply and install two led downlights

We have four outdoor sconces that need replacing. I’ve included photos. Replacement light is a Philips hue sconce photo also included. Inside switch currently has three buttons. Need this replaced with a two button panel and the circuit for the outdoor lights to remain on so that the smart switching will work. I have the replacement panel and two switches.

Bedroom TV Wall * Install a recessed TV wall box (supplied by me or included in quote) suitable for: * Double power outlet * TV antenna point * Data/CAT6 point * Position box at TV mounting height. * Relocate/extend existing cables if required. * Leave ready for future wall-mounted TV installation with hidden cables.

Looking for an experienced and licensed electrician to complete the following works: Existing Wall in hall * Remove/dummy off electric board behind wall in compliance with Australian standards.. Are you a licensed electrician for the electrical work? Requirements * Licensed electrician required for all electrical work. * Please include labour, materials and disposal in quote. * Photos attached.

Need a electrician for: * Replace 5 existing bathroom fan direct switches with timer switches. I supply timer switches. * Install 1 new laundry exhaust fan on external wall, may need approx. 300 mm duct. I supply exhaust fan. All Bathroom exhaust fans are already installed. CABAC Cabac - Minute Mech Timer 3 Wire 240V 5 Amp. Please quote labour and availability.

Down lights in restroom is not working and need to change them

I am looking for a licensed electrician to install a Tesla Wall Connector (Gen 3) at my home. Requirements: * Valid Australian electrical licence. * Experience installing EV chargers, preferably Tesla Wall Connectors. * Install, test, and commission the charger according to Australian standards. * Provide any required compliance certificate/documentation. Details: * Tesla Wall Connector already purchased and available on site. * Three-phase power available. * The charger needs to be installed inside the garage. * The cable needs to pass through the wall from outside to inside, as shown in the attached photos. * Please provide a quote including labour costs and all required materials, such as cabling, conduit, ,and any other installation materials. Location: North Kellyville, NSW 2155 Please provide details of your licence, relevant experience, and availability.

Looking for an electrician to reconnect an existing solar string to an older 3kW single-phase inverter. My AI assistant (Gemini) noted that this is a simple plug-and-play task I could technically do myself, but I prefer to have an electrician handle it to ensure everything is done safely and tested properly. Scope of Work: Plug the existing, disconnected DC solar string cables (MC4 connectors) back into the bottom of the mounted 3kW inverter. Turn on the corresponding PV Array DC Isolator switch. Turn on the Solar Main Switch / AC isolator at the switchboard. Stay for 2–3 minutes to ensure the inverter passes its internal safety countdown, syncs with the grid, and wakes up successfully. Verify via a quick visual check that the unit is actively generating power. The panels are already securely on the roof, and all cabling is already run right to the unit. This is purely a localised reconnection and startup verification job. Located in West Pennant Hills.

Looking for an Electrician to install a power PowerPoint behind tv and instal the tv brackets to the wall to hang tv up. Wall is Gyprock, tv is 85inch! Brackets hold 90inch max.

1. Need 12 existing downlights to be replaced with new LED lights 2.Two Outdoor lights on front pillars (Pic attached) 3. A small Chandalier to install in bedroom (Pic attached of chandalier in box) 4. Need to put in a plug point replacing the existing J-box 5. Side passage - halogen lights to be replaced 6. Need a security camera system in stalled (2 to 3 cameras)

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Westfield Castle Towers, to inspect and secure a loose downlight. The Issue: One of the recessed ceiling downlights located directly above our main customer display table has come loose and is sagging out of its ceiling cutout. While the light still functions, it is partially detached. The Job: The task is to safely access and re-secure the downlight so it is flush with the ceiling. The scope of work includes: 1. Safely accessing the ceiling above our central display island (an appropriate ladder/steps will be required). 2. Inspecting the downlight and the surrounding plasterboard. 3. Re-securing the fitting into the ceiling (adjusting or replacing the spring clips, or reinforcing the plasterboard edge if it has deteriorated). 4. Testing the light to confirm it is secure, flush, and working correctly. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools and a suitable ladder to work safely above our display table. - Ability to work cleanly and professionally in a retail environment. Location & Timing: Location: Level 2, 6-14 Castle St, Castle Hill NSW 2154 When: URGENT - As this is located above a high-traffic customer area, we need this resolved as soon as possible. Please state your earliest availability in your offer. Please provide a quote for the complete job. Thank you.

Under tile heating mat being installed in laundry and electrical conduit needed in laundry in the hallway total two

I am replacing an old all-in-one electric stove with a separate ceramic cooktop and under-bench oven. There is an existing stove connection cable available in the kitchen, which I believe is connected to a 40 amp stove circuit. The new appliances are: 60 cm ceramic cooktop, approximately 6,000 W / 25 A, hardwired Under-bench oven with a standard 10 A plug

Replace 5 existing light fittings with oyster lights: 3 in the bedrooms and 2 in the bathrooms. I have already purchased the oyster lights and will supply them.

The garage has easily accessible manhole and the down lights are with plugs and will be replace with similar ones which I will provide.

I’m looking for a skilled electrician to help install a wall-mounted TV. The job involves securely mounting the TV on the wall and ensuring all wiring is properly managed. Must have prior experience with TV installations and the necessary tools.

Kellyville. Looking for a licensed electrician to complete a few small electrical jobs at a residential property. Tasks include: • Replace the small base and cord of a room light. The existing cord needs to be removed and replaced with a new one. Access is via the roof cavity. Roof access is easy and only about 2–3 metres from the entry point. • Replace 2 outdoor GPO wall outlets. • Replace 1 circuit breaker in the switchboard (smart circuit breaker to control HWU) All materials are already supplied (cord, GPOs and circuit breaker). Straightforward job for a qualified electrician. Please bring your own tools.

My split system air conditioner is not cooling properly. Sometimes the air feels slightly cool, but most of the time it’s not cold. The display also shows an “F0” code. Gree Model：GWH12MB-K3DNA2J/1(DRED) I’m not sure if it needs refrigerant or if there is another issue. Looking for someone experienced with AC repairs to diagnose and fix it. Location: Baulkham hills Please let me know your availability and estimated cost. Thank you.

Looking for an electrician or experienced handyman to replace a few cracked wall plates in my home. Work required: • Replace 1 x light switch wall plate • Replace 2 x double power point wall plates • Ensure all switches/outlets are secured properly and sit flush against the wall • Check everything is working correctly after installation The existing plates are cracked, so they just need swapping for new ones. Wiring should remain the same. Photos attached showing the current setup. I'm happy for you to supply the replacement plates (standard white) or I can reimburse for materials. Flexible with timing but would like it done sometime this week or next. Prefer someone with electrical experience (licensed electrician ideal) since power points are involved. Should be a quick job (likely 30–60 minutes).

We have two overhead LED lights that are connected to a power socket that no longer provides power. This happened during a recent CCTV install, and we suspect the installer disconnected power, or otherwise caused the lights to become disconnected.