Find local dishwasher installation experts near you

Replace inlet hose on fisher and paykel single dish drawer model DD60scx9. Have bought new hose

Take out old dish drawer and install the new one. Help me carry the old one outside. Based in Waterloo,free parking on surrounding roads. Must be Friday afternoon between 2pm-5pm.

Bosch F/standing dishwasher to replace Fisher & Paykel Double Dishdrawer currently installed. Item is on site

Experienced dishdrawer installer to install brand new fisher and paykel dishdrawer dishwasher into existing cabinetry, including affixing to cabinetry via drawer removal method. Plumbing connection and power already available, previous dishwasher already removed. Dishwasher has been unpacked and prepared for installation. May need service access hole in cabinetry enlarged with hole saw.

Water is not flowing into the dish drawer Fisher and Paykel single drawer dishwasher

I need an experienced installer to: • Uninstall and remove an existing standard dishwasher • Install a new dishwasher drawer system (DishDrawer style) • Secure the dishwasher drawers correctly (as per manufacturer requirements) • Connect water supply, drain, and power • Test the dishwasher to confirm proper operation Important details: • Kitchen has wooden flooring, so floor protection / sliding protectors must be used to avoid damage • The new unit must be properly anchored and secured (not just slid into place) • Installer must be familiar with dishwasher drawer installations (e.g. Fisher & Paykel–style units or similar) What I’m looking for: • Someone with experience installing dishwashers (particularly drawer systems) • Own tools required • Care taken to protect flooring and cabinetry

The dish washer has error f51 and the lower door is not closing easily. I understood from some search that the actuator cover might not be fixed well. I attached images for the cover on both sides to see the difference. But it is just a guess for the problem

My Fisher & Paykel DishDrawer dishwasher is repeatedly doing 3 beeps and won’t start a cycle. There was water in the bottom tray which I have fully dried, but the flood float switch is still stuck and the machine won’t reset. The drawer sits silent until I press START, then it gives 3 beeps continuously. I need someone experienced with DishDrawers to: • Pull the drawer out properly • Access the bottom tray • Manually reset/free the float switch • Dry underneath the float and switch area • Check for any small leak that may have caused the flood mode • Ensure the drain pump runs again and the machine starts a cycle normally No parts should be needed unless you identify an actual fault — this is most likely just a stuck float/flood error. Prefer someone who has worked on Fisher & Paykel DishDrawers before. Thanks!

Top dishdrawer is not draining, have been advised likely a simple fix but not game to do it myself

After using my dishwasher, the water will not drain. I cleaned the filter parts but that does not seem to work.

Dishwasher is not switching on

Looking for a qualified appliance repairer or experienced handyman in Canberra to inspect a small leak in a Fisher & Paykel DishDrawer dishwasher. Leak is minor but noticeable – would like someone to diagnose the cause and quote to fix it. Flexible with timing, but sooner is better. Location: Canberra (Barton) Budget: $100 (for quote)

Installation of Fisher and Paykel dishdraw dishwasher

Opening size: 750 mm (H) × 780 mm (W) × 550 mm (D) Appliance size: 410 mm (H) × 599 mm (W) × 573 mm (D) Scope of work (supply + install): Supply and install filler panels to reduce the opening from 780 mm wide to ~600 mm (either one 181 mm filler or two ~90 mm fillers, full height 750 mm). Panels to be melamine/laminate/MDF in a finish as close as possible to the existing cabinetry. Cut a 60 mm service hole in the right side panel (towards the back, ~150 mm up from base) for hoses and power cord. (Optional, preferred): Recess the rear bottom panel by ~40 mm (about 600 mm wide × 60 mm high cut-out) so dishwasher can slide in flush with cabinetry. Ensure neat finish and secure installation ready for plumber to connect appliance. Please include supply of panels, fixings, and any trim pieces in your quote.

My Fisher & Paykel DishDrawer dishwasher has stopped mid-cycle and is constantly beeping with a red light. The rinse light is stuck on and the motor keeps trying to drain. From what I understand, it may be a flood sensor / water leak issue where water has collected in the base pan and needs to be cleared/dried, or there could be a small leak that needs fixing. Looking for someone experienced with Fisher & Paykel DishDrawers to: Check and clear the base pan (if that’s the issue) Diagnose the cause (leak, seal, hose, etc.) Get the dishwasher running normally again Must bring your own tools. Ideally available ASAP or Monday at the end latest.

Top drawer is stuck and won’t move. No error code (older model).

Need someone to remove and install a new fisher and paykl Dishdrawer

Our Fisher & Paykel dish drawer (single) works just fine IF you wedge a folded piece of cardboard under it. We’d like someone who knows and understands these dish drawers to fix it so that it works without the cardboard wedge.

I have a 10+ year old Fisher & Paykel double-drawer dishwasher. The bottom drawer works fine, but the top drawer has stopped working completely. It used to work intermittently (sometimes yes, sometimes no), so I suspect it’s a wiring issue. Looking for a technician to: Diagnose the issue onsite Advise on repair cost or if it’s worth repairing

Dishwasher not pumping out all water