Find experienced local carpenters in Barden Ridge

Carpenter/Handyman Needed to Build Fundraiser Message Wall We are seeking someone to build a freestanding “Wall of Support” for the Ridgeway Sunset Concert fundraiser at Barden Ridge Oval on Saturday 5 September. The wall will allow guests to write messages of love and encouragement for Hayden, a young local boy who became critically unwell after a virus triggered a rare neurological condition affecting his brain stem and spinal cord. Hayden now uses a wheelchair, has a tracheostomy and requires ventilator support. Funds raised will help his family make the home adjustments needed to bring him home safely. Wall requirements: • Approximately 2.4 m wide × 1.8 m high • Made in two transportable sections • White painted finish • Strong rear feet and supports for outdoor use • Easy to assemble and dismantle • Completed before 5 September smooth satin-painted or vinyl-covered wall looking to attach 50 clear a6 pockets so guests can place messages inside We will provide the design reference and can discuss materials, delivery and installation. This is a paid task, although our fundraiser budget is limited, so we would greatly appreciate a reasonable community-minded quote. We are also happy to acknowledge your support at the event and on social media. Please send through your experience, availability and quote.

Timber handrail along the timber stairs to pergola requires replacing. The length of a handrail is around 3m and has 1 angle required at the top of the stair where rail goes horizontal. The old rail needs to be dismantled and disconnected from vertical timber supports . The vertical supports are not damaged, just the handrail. Apologies for the night photo. I need to do better image tomorrow morning.

I need edging strips routed to fit table edge strips to be cut to fit table and glued to table and fixed The outer edge strips need to be routed out and then cut to the miter angles to fit the table. The edge strips are the stop things from falling off the table as the table is going on a boat.

I need this edge strip cut to the angles and routed into the table base the last image has a pencil line just to have it routed out to fit on the table frame

Am needing acoustic slats installed vertically to an existing wall. They are attached to a black material so can either be installed with adhesive or using black screws into the existing frame work. No battens needed. Panels would require some cutting to fit, and would need two cut outs to fit around two power points. The wall is roughly 2400 high x3380 length. The panels are 2700x600 Panels will be here ready to go.