Find a professional bricklayer near you

I need a bricked retaining wall completed it is 18m L shaped wall with 6 courses to it bricks are supplied and mortar would be supplied both ends of the L need be curved All you would need to bring is your cement mixer and tools

qualifed bricklayer with experience to change/repair one brick on a heritage fence using colour-matched lime morter . Brick to be supplied.

We are ripping out the plants pictured below the bay window and need to fill in the area left bare with red brick (basically in line with the existing red brick path but extending it to fill this area in and go out by a further brick length). Your quote is for Labor only we will pay for the red bricks.

I need a few bricks laid under existing fence. Concrete footing base in place. Need it done asap

We have a small bricklaying job / at most 25 bricks to be laid. Bricking up external hole in a wall after an airconditioner is removed and replace a line of 3-4 wall bricks under an eave. We have the bricks.

Hey i'm looking to get some brick retaining walls built. I'm in Tallebudgera Valley. best to come and quote

Letterbox has collapsed. All bricks are here and most undamaged. Need a proffesional rebuild or at least neatened up and i will install something new. Pictures of how it should look and how it currently looks due to being backed into with a ute.

Looking for someone to close a door opening with brick. Bricks and material will be provided by me.

Prepare a 3-4 brick high retaining wall for a pathway (2110x1600) All bricks provided, clean and ready to go BYO mortar, tools, etc.

A concrete block wall got hit with a forklift, and the mortar of the top few fews was damaged. The blocks can be reused - they just need to be Re-mortared. Looks like a four hour job? Materials supplied.

I need a bricklayer to repair a broken fence. The fence was damaged by a vehicle backing into it, and about 20 bricks have come down. It's pretty old, a single layer of bricks, and looks untidy. I'm just after the fence being repaired, don't care about painting it (I can do that myself)

I have a broken brick near the bottom of my front door- see photos. It needs to be replaced. The step tile above is now loose too.

Need a 1.5x2m section of a brick wall cut down. The wall is 9cm thick.

Bricklayer needed – raise small garden bed wall (~30 bricks) Looking for an experienced bricklayer to raise the height of the existing brick garden-bed wall shown in the photo. Scope: * Raise the finished top of the wall to one brick course above the current highest point at the deck end * Build the new top level across the wall. Because the existing wall steps down, this will require approximately 1 course at the high end, increasing to 3–4 courses at the lower end * Approximately 30 bricks total * At the deck end, cut the end brick diagonally (approx. 45°) to create a smooth sloping edge rather than a square corner/toe-catching edge * Mortar and finish joints neatly to suit the existing brickwork * Clean up on completion I will supply the bricks. Please supply mortar and any other minor materials/tools required. Easy access to the area. Located in Fitzroy. Please have previous bricklaying experience and appropriate tools, including ability to make a clean diagonal brick cut.

Need a bricklayer to brick up a column Roughly 300mm x 300mm x 2.7mheight - match existing coloumn above - common bricks - bricks supplied (available on site) - must be a professional bricklayer with tools

I am looking for an experienced bricklayer to construct 4 brick pillars for a new fence and gate. Pillar dimensions • 4 pillars total • Approximately 350mm x 350mm • Approximately 1.8m high • The pillars will support fence sections between them to enclose a front porch area (see photo) • One or more pillars will also be supporting a gate, so they need to be constructed appropriately for the loads involved Work required The job includes: • Carefully lifting/removing the existing paving where the pillars will be located • Preparing suitable footings/bases for the pillars • Providing and installing any required bricks, concrete, reinforcement, steel, mortar and other construction materials • Constructing all 5 pillars to approximately 1.8m high • Ensuring the pillars are properly plumb, level, aligned and suitable to support the fence and gate • Leaving the finished brickwork ready for a separate contractor to render • Cleaning up the work area I have approximately 48 red bricks (305x160x90) & 21 red bricks (305x75x90 already on site which if suitable can be used. (see photos) Contractor to supply all other materials required. A skip bin will be provided on site for construction waste.

Looking for who can drill four holes in a solid brick wall?112 mm

Remove 11 breeze blocks from brick fence without damaging the breeze blocks as they will be reused for another project. Leave other remaining bricks smooth and remove any joining concrete. Remove joining concrete from 13 breeze blocks (11 + 2 already removed) so they are ready for reuse.

Had a hot water unit removed. Need the hole in the wall bricked in. Remove half bricks and re-brick hole. Also the small crawl space underneath bricked in. Happy to use the bricks around the holes. Plenty there.