Find a professional bricklayer in West Brisbane

I’m looking for someone to build two brick steps, approximately 1.6m wide, leading down into a concrete courtyard. This includes: Remove the existing brick steps and metal handrail if possible. Prepare and neatly build two steps secured using bricks, with pavers finished on top. Job to match within reason to the concept shown in pic 1. Dimension includes: 1600 from wall to end 280 high from ground to top of paver on doorwell. Steps 350 deep Pic 2 shows the current state of the entrance. I will supply the bricks, mortar, pavers and other required materials. You will need to provide your own tools. Dogs on property but will be secured during works. Please advise your experience with brickwork and questions.

Need 2x 32mm holes patched in brickwork. Colour match the brickwork. Similar to the photo with the red circle, but currently behind the 2x blank plates. Need holes behind plates patched as well as screw holes holding the plates on. Internal wall single skin brick

The veneer brick wall is cracked vertically for about 2.5m. The old mortar surrounding the crack must be removed from between bricks and replaced. There are about 6 cracked bricks that also need to be replaced. There is clear access to the wall. Site inspection required. Please advise date and time

Replacement brickwork after window and door removal. Less than 3m.

Re-instate besser brick wall. Please provide materials required. Bricks have been stacked to the side. Photo reference shows how it look originally.

There is a garage wall which needs to be rebuilt and we need to have a support for it as it’s like structural wall.

Need a low brick garden edge built. Approx 60 bricks, 3 courses, curve at each end and approx 4.5 m long. Bricks already on site and lay direct on existing surface. Experienced handyman or bricklayer needed.

Brickwork as part of a small renovation

We’ve just closed in a sliding door and needing to get a brick layer to lay bricks in between our wooden feature and the window. I have bricks as per picture. Bricks will obviously have to be cut to fit the person doing the job. Must provide everything other than the bricks.

need to add two blocks size 400x400 on top of an existing block fence pillar and render it to match the existing render, the existing pillar is 1.4m high which I need to make it 1.8m high

Looking for who can drill four holes in a solid brick wall?112 mm

Space need to be filled up with brick - 2.1m width ( sliding door space, 2.1m height) reduces to 1.5m - 2.4m width ( sliding door space, 2.2m height ) reduces to 1.8m - 2.4m width x 2.2m height reduces to 0.9mx1.2m - 2.1m width ( window space, 0.6m heights) reduced to 0.6m - 0.9m width x 1.2m height reduces to 0.6x0.6 - 2.

The end birck from our side door step has come loose and detached from the other bricks. Need someone to cement it back onto the other bricks.

We replaced a window with French doors. But we now need help to add back in a row of bricks below the sill of the door. Both for aesthetic reasons and to stop water penetration. The area to brick is 2.43m wide and 7.3cm deep. Ideally would like bricks on an angle to shed water, like in the picture of our existing window.

Need a bricklayer to build a South African Braai. Bricks are on site ready to go. To build in two stages, before and after

I currently have two areas of brick where the mortar is cracked and needs repointing. Also have a previous air conditioner area that was filled with brick - that may need replacing due to poor previous work. Holes in brickwork to be filled as well. Looking for a seamless, non noticeable finish for these repairs. If replacement bricks are required - I’m happy to pay for matching bricks separately. One of the mortar cracks is on the second story (below driveway)

Brick fence x 2- besser bricks and breeze blocks. Approx 1.2 - 1.5 high. Lenght - section 1 approx 1.5, section 2 approx 2.6m The hedges in section 2 will be trimmed back to allow space for construction.

Please see attached current photo with garden bed… then how we would like it to look, without garden bed.

Need a neck layer to close an opening with bricks and close 10 small 240mm by 170 mm holes . Door is 700 by 1850

Need brickwork extended about 1.5m X ,2.5m high , single skin face finish both sides . Non load bearing wall , bricks supplied .