Find a local brick fencing contractor in NSW

Knock down brick fence at Merrylands. Option to take or leave bricks

Repair cracks in rendered fence and then paint. Materials to be supplied by tasker except for paint.

Brick fence 15m. Proposed development as attached

Brick fence got knocked down by car, needs to put the bricks back on and repaint. Drain needs to be fixed too.

Re design existing front brick fence, fill in hole cut new entry include slats on top and a slat door all rendered also small side wall exterior bricked up - about 300 or so bricks all up - I included example photo of what I want finished fence to look like

Rendering. Renderer. Brick. Fence. Burwood. Blend old with new fence.

Need to remove about 1.5 metres of brick fence either side of the driveway to make the entrance wider. It is a low fence about 750mm high and the ends if the wall will need to finished the same as they are now. The bricks removed will need to be saved for later used. Not sure on cost so open to more realistic offers.

Hi, I am looking for quotes from qualified tradesperson(s) to supply and install a front masonry fence as per my approved landscaping plan. Scope of Work: Build a 1.2m high rendered masonry front fence with vertical elements (Surfmist finish). Fence should align with the front boundary. Work to comply with council/developer guidelines. Please find the attached, approved design guidelines. The property is at Menangle Park. Thank you

Prime and render this brick fence wall and then paint on top. Needing this done ASAP

Need someone to demolish and remove two brick nib walls that are part of a fence. Some brick cutting might be required. Brick walls already cracked and broken. Refer images.

Small brick fence repair

Put brick fence back together

Remove old timber fence and small plants and build a traditional brick/wrought iron fence. A proper quote on inspection of the property required. the fence is 3.5 wide x 1.5 deep.

We have cut through our brick front fence to create a new entryway. We need two brick pillars created on each side of the new entryway and a tidy up of the bricks that were cut through.

Rendering. Renderer. Brick. Fence. Burwood

Front brick fence was knocked over by a truck. Need to repair back to original state. Possibly require replacing some bricks, remove and remortar bricks back into wall. Need to ensure sturdy and supported work as brick fence backs onto water pipes and mains. Swap out letterbox (poster supply) too, cavity already in place.

Description: I am looking for an experienced tradesperson or team to demolish, rebuild, and render a brick fence. The current wall is 8 metres wide and 2 metres high, and it is cracked and leaning, so it needs to be fully removed and replaced. Scope of Work: • Safely demolish and remove the existing brick fence • Dispose of all debris • Lay new concrete foundation with steel mash and Rebuild a new brick wall (approx. 8m wide x 2m high）with propler drainage • Render the surface after construction is completed (smooth finish preferred – please advise if other options available) • Supply all materials (please include in your quote) • Ensure the new wall is strong, straight, and compliant with local standards Preferred Timing: Inspection available Monday or Wednesday Work can begin shortly after inspectionp Other Notes: • Must have previous experience with brickwork and rendering • Please include photos of past similar jobs if possible • Licensed and insured tradespeople preferred • Open to fair and reasonable quotes

I need a slab and brick fence built to house bins out the front of my house Ruskin lane just off tennyson st about 10m in total +/- Would like the builder to source maybe recycled bricks (open to other suggestions) and all materials Needs slab for bins also Market rates for materials and labour

Would like to have a brick aluminium front fencing for 17m length as shown in the picture. Need to do the job immediately

hello all, my brick fence has fallen down and i need it back up !