Find a reliable appliance technician in New Farm

Assess Washine Machine Error Message and Fix

26/118 Oxlade Dr New Farm , Brisbane, QLD, AU, 4005 - Gas stove ignition is not working

You will see from the photos that the shelving in the the one cupboard needs to be removed. The lower shelf and kickboard would also have to be removed. you would then have to insert a vertical piece of wood to complete the cavity and trim down the existing double door to fit. The dishwasher will be 60cms wide.

Need a service and fridge seal

Need to remove a part of the existing kitchen bench to be able to insert a dishwasher. The bench top is laminate. Cupboards are laminated board

Front load washer. Door handle locking latch has come lose & is not catching.

washing machine has just been used and there is water coming out all over the floor. It was only recently installed by good guys so should be an easy fix - they have perhaps just not connected it properly?

I have a water leak in my two-story house. It’s coming from under the ceiling near the heater. Every 6 minutes I hear a pumping sound, like the system is refilling even when no taps are on. Ceiling damage is starting, and I’m worried it could get worse. I need a licensed plumber urgently to inspect, find the leak, and repair it. Video available if required.

Install two new hose link hose reels onto masonry walls. One is a replacement and one is a new placement so will need tools for masonry.

After moving in, washing machine is not connected properly. I need a plumber with supplies to connect it properly and possibly put seals on pipes that are open and leak water when I use the machine. It will be a 5 minute fix for someone who knows what they’re doing

Replace gasket seal on Bosch maxx 1000, WFO2060 front loading washing machine.

ILVE oven the handle has come off on one side of the door, the nut it screws into has fallen into door, need to get it out to reconnect the handle

Hi! I’m looking for a qualified plumber to connect a hair-wash basin and washing machine to my existing under-sink hot water system (currently connected to a hand-wash sink). - Connect drainage for the basin and washing machine - Split hot and cold water lines to run to the new basin

Hi. I need someone to wall mount my dryer, a Simpson model 39P400M-V1, 4kg capacity. I am requesting friday 22nd august, for between 7am and 12pm. I will supply SIMPSON DRYER WALL MOUNT BRACKET KIT 39P400M,39P500M,39S500M,39S600M. See pictures for the dryer and where it will be mounted. I can help but you will need to supply all tools. Thank you Alex

Have a Samsung fridge and need to switch the door to the other side

Deliver a drain from Geebung to New Farm. It is a stainless steel drain. Size: 2.2m long 0.1m wide. The shop opens at 6:30am.

Cracked the corner of the cooktop am hoping someone can make it look unnoticeable

Bosch Serie 4 won’t turn on. Makes clicking sounds but screen doesn’t light up.

Deliver a drain from New Farm to Geebung. It is a stainless steel drain. Size: 2.2m long 0.1m wide.

3 year old kitchen with integrated dishwasher, the cabinetry for the dishwasher is not aligning. I think it needs to be taken out and re-installed.