Find a reliable appliance technician in Mudgeeraba

We have a Haier front loader washing machine. There is a nick in the rubber seal causing occasional leaks. I have purchased a replacement OEM rubber seal from Haier and have purchased the special tool to take off the wire clamps that hold the rubber. However I have not had time to do the job. So the job is to replace the rubber seal using the new seal I have already purchased.

Install external 240v electric water pump to power garden hose / tap. Refer to pictures, may need additional fittings? Must have own tools etc

Install Bosch 60cm electric rangehood and cooktop. Cabnitery and ducting is already existing. Also existing rangehood is already removed. This is replacing the existing appliances. All electrics and isolator switches already exist. Must bring own tools etc

Mower won’t start. Hired someone else to fix it who has now ghosted me so need someone to complete this job asap so I can use my mower. Apparently Need to replace the Gasket to go in carburettor.

Washing machine Gasket broken. Need to change a new one. Thank you

Need a hot plate / kitchen stove wired up as replacing old one

disconnect existing electric cooktop and connect new electric cooktop

Leaking twin gas regulator needs replacing

Bosch induction cook top issue. The issue is that the R hand side 2 plates are flashing with an error (1 and a backward 9) flashing intermittently. L hand side works fine. The lady from Bosch said it was an issue with the board on that side.

The Reebok ZR12 treadmill turns on and goes through its start up stage for about 15 seconds, you hear the click, and it turns off with error 6 showing. If you press the start button as soon as you turn the machine on from the main switch, it will go into the 5 second count down (on main screen)and when it gets to the zero, it clicks off and shows firstly, error code 2 and then switches to error code 6. The click does not come from the electrical motor (the larger motor with the belt attached to it), it sounds like it comes from the smaller motor near the control board. I have been told that it mite be the lower controller board is very likely the issue.

I have a brand new Red Arc AC/DC charger. It was charging yesterday off the solar blanket but today it got to 1.1% and stopped charging. I think it might be something to do with the earthing?

Error 4 message on whirlpool adp6000ix. Potential drain pump repair.

Hi there I have a set of 8 swann security cameras I need installed around my house.

I have an Infresco BBQ. The gas burners for the grill are not working well. May need service or just replacement.

Please dispose of old oven and dishwasher on ground level. They are still hooked up to power/water.

I need my unbalanced washing machine fixed or balanced do it works again

Convert my freezer into an ice bath

I would like to Install dryer on the wall in my laundry

Hello, we have a white piece of laminate (I think) that covers the silver dishwasher. We'd like it reattached.

Looking for someone to do the plumbing for a gas cookstop install. An electrician has already sorted the power for the igniters.