Find a reliable appliance technician in Cammeray

Water is not getting drained

I need someone to help mounting a Westinghouse 4.5kg Reverse Vented Tumble Dryer to my wall in my laundry above the washing machine

Install a new ceramic cooktop to replace existing one.

Not sure if possible but need this to be repaired.

I need someone to install a duct for my Rangehood to the outside. I have the stainless steel ducting etc ready for install. There will be class cutting involved as it will be ducted through a glass plane. Welcome to inspect onsite for a better quote.

Replace the electronic cooktop.(60cm). The existing cooktop is hard-wired. The replacement process requires disconnecting the current electrical cable and connecting the new cooktop’s cable to the existing supply. No additional modifications are necessary beyond the cable replacement. This must be done by a licensed electrician.

Hello, my Bosch Serie 6 Stainless steel built-under SPU63M05AU dishwasher is about 10 years old. It has been displaying error code E14 (Water inlet issue?) for a while now after running a washing cycle (but still works) and now displays error code E09 (heating issue?). How much would it be to fix it? Thanks :)

I have a Fisher & Paykel washing machine WH7560J3 The machine turns on but the buttons do not respond. The dial works but the response is a bit delayed

Hinges and glass panel has come off from conventional Smeg oven

Need handy person to glue this panel back on the legs of an integrated dishwasher

Hi - my new Bosch washing machine wasn’t connected by a professional and now travels when in a spin cycle. Need help!!

I put my bed together and it’s lowkey super unstable, hoping someone can fix it for me thanks ! Also quick job fixing the drawer of my vanity if I don’t get to it first

I have a matador gas conversion kit but fitting it is too complex for me.

NB: This job is to investigate options, evaluate etc, installation would be seperate based on those options. Looking for someone to investigate feasibility & suitable path for a rangehood ductwork retrofit (assumed 200mm compliant flex ducting would be necessary) - ideally with an external motor for noise & performance. We are renting, but this current one is a joke, it does nothing, and makes all the noise in the world, and everything ends up inside the house. Need someone to be able to evaluate whats behind the walls / roof cavity, clearance and pathway (see the photos for proposed pathway) The challenge is the kitchen is in the middle of the lower floor (2015 build, 2 story concrete slab) - the existing pathway of 100mm ductwork is a joke (and non-compliance) - it drops from 200mm immediately down to 100m PVC at the existing rangehood, yes standard PVC, you read that right 😳.....then a run of at least 10-12 metres up, across, down, across to outside..no surprise it does barely anything) Need to evaluate what room there is for a more direct path below the second floor slab etc - so need the right inspection devices and/or can open a port inspect then patch.

Clothes Dryer blows cold air. Needs a repair. Simpson SVD656HQWA 6.5Kg

Washing Dryer blows cold air. Needs a quick repair. Simpson SVD656HQWA 6.5Kg

I have a Westinghouse vacuum. I think there is a blockage in the system somewhere that is causing the motor to make a loud high pitched whining noise. Can you perhaps repair the fault ?

My dyer door isn’t locking when closing and can’t run a load. Dryer is a second hand asko heat pump model. I have a video if needed but unable to post as part of this ad. Any assistance would be appreciated!

It’s an F24 fault to do with temperature gauge (from my googling) temperature relay issue. It’s a Miele and it says error F24.

Affix dryer to wall at eye level in parking space below apartment