Find a reliable appliance technician in Baulkham Hills & Hawkesbury

Fisher&Paykel washing machine, the door seal needs to be replaced. Install only

Hi, I’m looking for a licensed gas fitter/plumber to connect my natural gas BBQ in my backyard. As you can see from the attached photos, the existing gas meter/hot water gas connection is very close to where the BBQ will be located, so I’m hoping this will be a straightforward installation with only a short gas line required. The job would include: * Assessing the existing gas connection. * Supplying and installing the required gas pipe and isolation valve (if needed). * Connecting the BBQ to the natural gas supply. * Pressure testing the installation and ensuring it complies with Australian Standards. * Providing a compliance certificate if required. I’m looking for a fixed price of around $500. If you believe the job will cost more after reviewing the photos, please explain why and provide your best fixed-price quote. Only licensed gas fitters, please. Thanks,

Esatto Dryer EHPD80 spinning function of barrel not working. Dryer turns on and heat function works.

Require supply and replacement of shower tap washer Repair of oven door

Disconnect existing electric cooktop and connect new cooktop in same position.

Washing machine has e-23 code coming up. Always stops.

Dismantle outdoor dishwasher from cabinet.

I can turn on / off using remote . However, - can’t control the flame power - fan is not working

I need someone to cut & alter the edges of the opening in my kitchen bench (stone) to allow for installation of a new cooktop that requires slightly bigger size cutout. Approx. 5mm to 10mm extra space required across depth and width for allowing standard 60cm cooktop from major brands to be installed easily.

Need a hole cut through the side panel of my laundry cabinet so the washing machine/dryer drainage hose can pass through to the waste pipe. # Cut a neat hole in the laminated cabinet panel # ring suitable hole saw/tools # Ensure a clean finish with no damage to cabinetry # Photos attached for reference Looking for a handyman, carpenter, or cabinet maker. Flexible timing. Location: KELLYVILLE

Gas stove , my nephew installed it but I have fear it might leak or not installed properly!! Its a 15 min job so dont send quotes costing hundreds

Need to replace 60cm induction cooktop and oven underneath. I have ordered new ones. Need electrian to install both.

Replacing gas cooktop 60cm

I am replacing an old all-in-one electric stove with a separate ceramic cooktop and under-bench oven. There is an existing stove connection cable available in the kitchen, which I believe is connected to a 40 amp stove circuit. The new appliances are: 60 cm ceramic cooktop, approximately 6,000 W / 25 A, hardwired Under-bench oven with a standard 10 A plug

We need to replace the kitchen rangehood. We have bought a new one to be installed.

I need my existing kitchen oven housing cabinet increased by 10cm. I have an existing 90cm x 50cm x 57 oven which is being replaced with a new one that is 90x 57 x 57 so I need the housing adjusted. There is a 20cm drawer below so this can be used (10cm) to increase the housing to fit the new oven in. Therefore need sufficient skills to increase size using this drawer space including making the remaining 10cm gap good - probably by using the existing drawer cover and cutting in half and fitting (ie no long a drawer as it isn’t used anyway).

Persistent gas smell coming from inside a Bosch freestanding gas stove I checked the external gas connections with soapy water and could not find any visible leaks. The smell seems to be coming from inside the appliance rather than the external pipe connection Would like a licensed gas fitter / gas appliance technician to inspect the stove and internal gas connections for possible leak or valve issue.