Hire a trusted appliance repair service in Collingwood VIC

We got a fridge's power plug jammed in a door and it snapped off.. we have both pieces and just need them reconnected so the fridge works again. Similarly, a pair of fairy lights with same issue, power supply has been disconnected from rest of the unit and needs to be reconnected. Thanks so much

Door handle screw come loose and handle needs re-tightening

Hello! We have a draw dishwasher in our Studio that has stopped draining entirely, a 5cm layer of water is currently sitting at the bottom of it - we would like it fixed asap! It is a Fisher & Paykel, unsure exact model but looks to be a Double Dish Drawer Series 9? Please see attached photo - thank you in advance :)

Steam wand is not working, all the other mechanisms on the machine appear to be working as normal. Was last serviced 6 months ago.

My tumble dryer has stopped tumbling. I think something got caught and maybe the belt is broken but I’m unsure. It still goes, just doesn’t tumble. It’s a Simpson 6 kg ezi loader.

Hi, I have an LG fridge (about 3 years old) that has no power at all - no lights, no display, nothing. I suspect the main control / power PCB has failed. The board marking I found is MEZ66684903 Rev.02. I'm in Melbourne and looking for a quote to supply & replace the main PCB. Thanks.

Oven is turning on and heating to warm but not to hot. Grill is working fine.

Hello, the latch on our bosch dryer has worn. We have the replacement part, but we havent got the screw driver tool to remove the old and replace it with the new part. Please see all photos to illustrate the issue. We just need someone to swap if over for us. We are in Collingwood Victoria. We have a parking permit for you as well.

Hobart Undercounter Dishwasher (515) on a cycle that won’t end. Previously it would not fill with water. We filled it manually and it started.

Please fix my fisher & Paykel dishwasher that went crazy after the electricity went off in the apartment. It shows almost all the lights flashing and doesn't wash anything, hard reboot didn't help. The model is DD60SI9, Product 81211- B. Thank you.

I dropped a seagate drive. Despite it being covered in tae to protect it its still now making the beeping noise that shows that the needle thing inside is stuck. I've fixed these myself by opening them up and putting the needle back to the outside of the disk but i have misplaced my tools and as such would like someone who has done this before with the right screwdrivers ( t8 and the star one I believe) who can open it up and put the needle back. Person must have teh right tool set and have done it before. Cheers

There is a leak coming from somewhere in the bottom of my washing machine that releases water when it is on a cycle. Cannot find the source of the leak. It is a Kogan frontloading washing machine

Service Electrolux washing machine that's out of warranty. We suspect rubber seal needs replacing. Model number: Electrolux ewf7525dqwa 7.5kg front load washer, Quick 15 option.

Our standing freezer has dropped in temperature to -1°C and isn’t working properly. I need someone experienced to fix the issue as soon as possible. • Location: Collingwood • Budget: $200 (including repair) • Important: I am not willing to pay for inspection only. Payment will only be made if the issue is fixed. • Freezer: Standing model (not chest freezer). If you’re confident you can repair this within the budget, please reach out ASAP.

- Have three paper dryers (ilfolab 1250RC and ilfolab 5250RC that need help fixing). - Has a heater element for dryer and some sort of motor for rollers. - Two not turning on and another turns on and heater works but not the rollers

Bosch series 6 heat pump dryer, is turning on and spinning but no heat. It’s also prematurely stopping the cycle. It spins for about 2-3 mins and then says finished.

My dishwasher isn’t working correctly, I would like someone to take a look at it to check what’s going on/ if anything is wrong. If further repairs are required, payment will be added.

Our standing display freezer for ice cream is not working properly – the temperature is sitting around -7°C, and ice creams are starting to melt. We need someone experienced with commercial freezers to come and take a look ASAP – preferably today. Details: • Freezer type: Standing glass-door display freezer • Problem: Not holding temperature properly (currently at -7°C) • Location: Collingwood, VIC • Availability: I’m at the shop until 3:30 PM today Please bring your tools and be ready to assess and fix if possible. Photo of the freezer attached. Let me know your earliest availability.

Fix Bosch dishwasher with error code E31 Error code means Water protection scheme is activated

commercial oven Unox need to be fixed