Hire trusted appliance installation services in Yatala SA

Need to install a new rangehood

Hi, I need a licensed electrician to install a new electric under-bench oven at my home in Ridleyton. To make this a quick and straightforward job for you, I have already completed the unboxing and removal work. Current Status: • The old Miele oven has already been uninstalled and pulled out of the cavity. • I believe the previous setup was a direct hardwired connection. • The new replacement is an ALDI Stirling 80L Built-In Oven, which I believe comes pre-fitted with a 15-amp power plug. What I think needs to be done: 1. Convert the existing hardwired wall connection inside the cavity into a 15-amp surface socket (power point). 2. Test the line/isolation switch. 3. Slide the new Stirling oven into the vacant under-bench space and secure it to the cabinetry frame. 4. Test the unit to ensure it powers on correctly. 5. Issue an electronic Certificate of Compliance (eCoC) as required by SA regulations.

Install electric oven and built-in microwave. Also, this this is going in a spot that was previously a gas oven. There are some cables poking through the wall as seen in the photos which were from the old oven. Bosch HBA572EB3A oven Bosch BEL653MB4A built-in microwave I've also got the IKEA shelf that separates the two.

Need this install finalised. Put the intake tube up into the ceiling and lift the casing to fit and also fix any gaps in the ceiling

Like yo like rangehood replacement.

Hi, I’m looking to replace my old 60cm rangehood, as the fan is no longer working. I’m looking for supply and installation of a suitable new rangehood. Please see the attached photos of the existing rangehood and setup. Just a note: the fan is not working. If it can be repaired, that would be fine. Otherwise, I’m looking for a suitable replacement and installation.

Need a licensed appliance technician to install a replacement 240V AquaStop inlet hose on a Bosch Serie 6. Part is already purchased. Invoice required

See photo attached for installation details

Current rangehood: - Existing unit is a 60cm Westinghouse slide-out rangehood. - Existing unit has failed and needs replacing. Job required: - Remove existing rangehood. - Install new 60cm slide-out rangehood (I will supply the new unit). - Existing ducting will be reused if compatible. - An access hole may need to be cut in the upper shelf/false panel inside the cupboard to access rear mounting screws. - Dispose of old rangehood if possible (please advise if extra cost applies). Unknowns: - I am not yet sure whether the existing unit is plug-in or hard-wired. - I am not yet sure of the duct size (120mm or 150mm). - The installer may need to inspect on site before confirming compatibility. Please let me know: - Your experience with rangehood replacements. - Whether you can handle both installation and any required cabinet access hole. - Whether a licensed electrician would be required if the existing unit turns out to be hard-wired. Budget is flexible depending on site inspection and whether electrical work is required.

We need someone to remove the washing machine door seal and install the new one that we have. LG WV51409W Model

A Seko new electrical oven

Diagnose and repair domestic refrigerators and freezers. Conduct refrigeration fault finding and testing. service refrigeration systems where required. Inspect, refurbish, and prepare appliances for Cleaning and resale. Load and unload refrigerators and other appliances safely. Move and handle appliances within the workshop and warehouse. Assist with deliveries and collections when required. Maintain a clean and safe work environment.

We have an electric oven and gas cooktop that we want to change to a new electric oven and cook top and range hood. The sizes are the same. Will need someone qualified to close the gas connection and replace it with electric.

Disconnection of built in 60cm oven (8 years old) - it doesn’t have a wall plug, it is wired in and goes to a cabling loom. Install new 60cm oven in place (also hardwired) New oven is Westinghouse WVE6516SD.

The canopy rangehood is in place but has not flued through the ceiling and out the roof. The has roof is terracotta tiles.

Step 1 move electrical point if needed. Step 2 make cut in gyprock ceiling Step 3 install rangehood with vent into the roof

Replace an existing 60 cm slide out rangehood with Miele 60 cm slide out rangehood (model# DAS 2620). Some modifications to the existing cabinets on top of the rangehood may be needed to fit the new Mielie rangehood

Disconnect old electric stove & install new one Description: Looking for a qualified electrician to safely disconnect and remove my existing electric stove, and install a new one in its place. Scope of wor Disconnect and remove old electric stove Install and connect new electric stove Ensure everything is working safely and compliant Dispose of old unit

Install vent cover over th stove

Need a 10 year old gas log heater removed from fireplace and install a Rinnai gas heater that has been removed from previous home