Hire trusted appliance installation services in QLD

Flat pack build in Hope Island for electric fireplace as in previous notes

Looking for an experienced rangehood/ventilation installer to complete the installation of our Schweigen Isodrive 950 (ST) rangehood system in Highland Park. The rangehood is already fitted inside the kitchen cabinet. Need to: * Run the 200mm ducting from the rangehood into the roof cavity * Run ducting through the roof cavity to an external wall * Make the penetration through the external wall * Install the Schweigen Isodrive 950 motor externally on the wall * Connect, secure and seal the complete ducting system There is easy access to the roof cavity/trusses. The Schweigen kit already includes the motor, 4m × 200mm ducting, 200mm galvanised pipe, clamps and wall-mounting bracket. Please quote if you have experience installing rangehood/exhaust ducting.

I need the wiring done for an induction stovetop swap out for existing stovetop. I just need the wiring swapped to the right terminals. I can finish the install.

We had a new rangehood installed in our kitchen - it is a ducted Falmec rangehood that sits in the cabinet. The installer installed it not flush to the cabinet. We can see some gunk between the gap so think it is stopping it sitting flush. We got him to come back out but it still isn’t resolved. Seeing if someone is available to come out and drop it down, wipe off the gunk and reinstall it flush please. It’s brand new, unused. Thank you.

Looking for someone experienced to install a new rangehood in our kitchen. There was previously a rangehood installed, but we removed and disposed of it because it was very old and dirty. The existing installation point is still there. We need someone to: - Check the existing setup/ducting - Install and secure the new rangehood - Connect it to the existing ventilation/ducting where possible - Let us know if any additional parts or work are required Budget is indicative, open to reasonable offers.

Need dryer belt that I ordered installed into Simpson dryer. Should be 15min but has been giving me trouble trying it myself. Idler may be bad. If you have spare idler please bring. Will pay a little bit extra for it.

Looking for a qualified electrician/appliance installer to disconnect and remove an old cooktop, then install a new Devanti 60cm Electric Ceramic Cooktop with Touch Control. Scope of work: Disconnect and remove the existing cooktop from the benchtop cutout Leave the removed unit on-site, I will dispose of it myself Install the new Devanti 60cm Electric Ceramic Cooktop (Touch Control model) Connect to existing electrical wiring/circuit Fit into existing benchtop cutout Test all touch controls and heating zones for correct operation Ensure unit is secure, sealed, and level

Replacing it an old induction stovetop with a new one.Should be a simple like for like replacement

Licensed electrician required. Existing cooktop already removed from benchtop, replacement Beko BCT601IGN supplied, same cut-out, existing dedicated C25 hob circuit. Disconnect old unit, connect/configure new induction cooktop, test and certify. No benchtop work required

Electrician to install an induction stove top in existing location. Old stove top has died and needs replacement. 60x60 Electrolux brand new

My washing machine rubber seal needs replacement I have the part just need someone to do the installation.

I have a new oven and induction cooktop to be installed. The old appliances have been removed so just new an Electrcian to connect the existing wiring to the new appliances. I work from home so can very flexible if you want to do this between other small jobs or if you are passing through the Nundah area to or from other jobs. I can send more pictures of the electrical drawings in case you will need additional supplies to complete the job. If you have questions, please reach out.

Licensed Electrician Needed – Cooktop Installation Looking for a licensed electrician to install a new electric cooktop at my home.

Hi, I’m looking for someone to install, including ducting for a new rangehood. The rangehood is a Smeg Victoria chimney-style rangehood, and there is currently no existing ducting to the outside, so a new ducted exhaust will need to be installed through eave. It’s a low set one story house. Tasker to provide ducting for room and external vent. There is a manhole for access. Electrical has been completed- they have installed a movable electrical outlet. The rangehood has already been purchased and onsite

Take out old motor on Canopy Rangehood and replace it with a new motor (supplied)

We need our old 60cm ceramic hardwired stove top disconnected, removed and replaced with the new one.

Looking for a licensed electrician to remove my old electric stove and install a new electric stove. I have already purchased the new stove and it is on-site. Tasks include: - Disconnect and remove existing electric stove - Install and connect new electric stove - Test to ensure it is working safely and correctly - Provide electrical compliance documentation if required

I need an oven and cook top installed into my new kitchen

Have purchased the element. Installation only required

Electrician required to install replacement wall oven. Size of oven is 600! Current oven will need to be disposed of.