Find a reliable appliance technician in West Adelaide

Need help cleaning mould from rubber seal in a front load washing machine

Connect an exhaust pipe to the Baumatic GUH90 to extract air outdoors. The property is 5 years old, walls are brick veneer, howver since there is a Rinaii instant gas adjecent to the wall oposite kitchen cupboards, the works would need to be done through roof eave.

I think the Bias Spring 68 - 424346 | Fisher & Paykel definitely needs replacing but maybe the balancing struts might (suspension) need replacing as well.

Hi, I need a licensed electrician to install a new electric under-bench oven at my home in Ridleyton. To make this a quick and straightforward job for you, I have already completed the unboxing and removal work. Current Status: • The old Miele oven has already been uninstalled and pulled out of the cavity. • I believe the previous setup was a direct hardwired connection. • The new replacement is an ALDI Stirling 80L Built-In Oven, which I believe comes pre-fitted with a 15-amp power plug. What I think needs to be done: 1. Convert the existing hardwired wall connection inside the cavity into a 15-amp surface socket (power point). 2. Test the line/isolation switch. 3. Slide the new Stirling oven into the vacant under-bench space and secure it to the cabinetry frame. 4. Test the unit to ensure it powers on correctly. 5. Issue an electronic Certificate of Compliance (eCoC) as required by SA regulations.

I have Electric oven that needs a new thermal overtemp fuse that needs to be fixed i have attached a photo that shows you what fuse to get and the price

The oven at the property is not heating up. The fan is running and the red indicator light comes on, but there is no heat at all. The oven is a Chef fan-forced model, EOC624S*49. Looking for a qualified technician to inspect and repair it.

The hot water tap that connects to the washing machine has always leaked. We’ve tried changing the tap but it still seems to seep water at quite a steady rate. We need someone to diagnose and fix the issue.

Nordictrack treadmill service

Need to install a washing machine and wall mount a dryer

Need help installing a dishwasher. There’s no cut between the cabinets and a hole will need to be made to bypass the cable and pipes

I need a 45cm dishwasher installed in the cabinet which is circled. The plumbing will have to extended from under the sink through the cabinets and the drainage pipe would have to be done the same way. We will provide the dishwasher.

My gas fitting doesn’t fit where I want to place the gas bottle so I need a longer one supply and installed

My samsung washing machine is leaking, would like someone experienced to take a look and hopefully repair it

Replace the original galvanized steel gas pipework

We need to have someone handy with tools go on-site to change out a frame section of an electric bed. Have a video instruction on how to complete this job. Tools needed are a screwdriver and a spanner. This is a simple unbolt-and-rebolt job; the timeframe should be 1 hour to complete.

Photo attached. Kitchen renovation needing the gas pipe cut back and capped. Will require some excavation of the brick wall (double brick with cavity) Then capping with 15mm bpress gas cap + testing the gas line with just a couple photos of holding pressure. Don't need the wall patched. I'm a plumber just in Melbourne and can't get to it in time for the cabinet maker. Would appreciate the help on this one. It's in Hilton an empty house.

Require a license professional to safely disconnect and remove Rennai 2001 Flued gas heater from living room.

Disconnection of built in 60cm oven (8 years old) - it doesn’t have a wall plug, it is wired in and goes to a cabling loom. Install new 60cm oven in place (also hardwired) New oven is Westinghouse WVE6516SD.

I have a new 10kg washing machine that needs levelling as it's moving when spinning. Someone that is fit as it's super heavy to pull in/out of the space it's in.

Fix washing line It’s already set up just needs some extra work I’ll pay for the bolts that need to be fixed on top of the 50