Find a reliable appliance technician in Adelaide

1. Disconnect gas and remove gas stove . 2. Disconnect gas and remove gas oven 3. Install induction cooker and connect to electricity 4. Install electric oven and connect to electricity

Seal is mouldy I don’t have the correct tools to get the front panel off. Replacement part is on site.

Hi Everyone, I have a free-range house rabbit that will access outside through an Omlet Eglu rabbit run/Zippi tunnel system. I have half set it up, but need someone to finish. The task would involve putting together the wire part and then connecting it all though a doggie door. I’ve yet to order the tunnels, but have the basics to get started. I will need mosquito wire put on around the wire part too, to stop any Myxomatosis risk. Search Omlet Eglu For more info. Make an offer!

Dishwasher isn’t draining properly after each wash

The washing machine is displaying error E-35 -10

uniden dashview 40r 3 in 1 front inside and rear into prado landcruiser 2 year old not the new prado

I brought a new washing machine, however, the discharge pipe and water pipe is too short. I need and extension required or a longer pipe. Shoet by 40cm or 50cm. Must be installed water tight. Please supply materials. See photos

The old one has to be removed, and then install the new cooktop, the size are the same(60cm). I can keep the old one after the installment if you don’t want to take it. Thank you

We run a fleet of automatic coffee machines. Our staff member is away. We simply need someone to attend site and stick a tube or wire down the drain pipe to loosen any debris. Really easy and straight forward job.

We are looking for someone with experience to help stack our dryer on top of our washing machine. The space is tight (see photos) but we have measured the dryer and it will fit. We do not have a stacking kit and/or rubber mat. You may also need to create a larger hole in the wood for where the electrical cords and washing machine hoses go - I am unsure if the extra cord for the dryer will fit through. Please see photos for reference. Please don’t hesitate to contact for any questions 😊 thanks!

Looking for someone with experience on fixing a leaking tap to washing machine Previous handyman has changed hose to washing machine and has used plumping tape, but could not resolve the issues.

Disconnect my oven ready to move to next home

Need smith machine built/put together. Google search suggests it’s a 2-3hr task. Details of machine below. https://www.lifespanfitness.com.au/products/cortex-sm-20-6-in-1-power-rack-with-smith-cable-machine

Install 8 CCTV camera in an office. Office has false ceiling (removable ceiling tiles) I will supply cameras (Hik Vision HiLooK) + NVR Box I will supply floor plan with approximate camera locations You will need to provide - Lan Cables (Cat 6) - Your services to install cameras and run cable for each camera to Comms Room and terminate at NVR Box - Total cable length needed will be around 100 to 120 metres (at the very maximum) - Must have skills to cut LAN cable to desired length and crimp LAN cables Maximum half day's work (you may work to your own schedule)

I have a new washing machine that needs the bolts removed, noise cancelling pads put on and hoses connected.

Bought a new freestanding dishwasher for installation pls.

Please help install a new washing machine - LG Wash tower (stacked washer/dryer) - 130kg, 600mm (w), 1650mm (h) I bought this new machine from LG official website, however, LG does not offer installation service in Adelaide (annoying). I need someone to help Power/taps available already, so no further power/plumbing works required.

Need a combustion heater Flue kit installed. Needs to go next to where a previous gas heater was based and has access to the ceiling and roof (see images). Have full kit ready to be installed and combustion heater in place. Gap between ceiling and roof line approximately 50cm. Tiled roof but any tile alterations (trimming etc) will be done. All kit ready to go. Just need someone who’s done this before.

We recently moved into a new home with a four-burner Euromaid gas stovetop, but three burners won’t ignite at all, and the fourth is extremely difficult to light. We suspect the ignition and spark components need replacing. We’re happy to source the necessary parts but need an experienced gas appliance technician or handyman to: • Diagnose the issue • Install new ignition/spark components (if needed) • Ensure all burners ignite and stay alight Looking for someone with experience in gas stove repairs. Please provide availability and a quote.