Find a reliable appliance technician in North Brisbane

I need someone to install a dishwasher, washing machine and a drier in our warehouse.

Oven trips mains when selecting cooking mode on dial Oven ights come on, any other selection causes trip 90cm Electric Multifunction Oven EO900MX2

Hi I have a vending Massage chair The plug needs to be screwed into the back properly and plug tightened so it brings power to the machine . I can do myself just need someone that can actually give it a long term solution thanks . Nudgee location.

Replace old range hood and install new one

Take out old motor on Canopy Rangehood and replace it with a new motor (supplied)

to remove faulty massage motors and reinstall them (3 motors)

I have a dishwasher that is shorting out. It is shorting power to the house. Need someone to come and check it. Dishwasher is 2 to 3 years old.

Licensed Gas Fitter Needed: Disconnect Old Stove, Modify Pipework & Connect New 90cm Range Cooker Description of work: Looking for a fully licensed and insured Gas Fitter to swap out a freestanding kitchen stove in Fitzgibbon. The Job Involves: 1. Disconnecting and safely removing the old 90cm gas stove. 2. Modifying the existing floor-mounted copper gas line. The current regulator and yellow isolation valve sit too high up off the floor boards and will obstruct the new oven. Need the pipework cut and altered so the connections sit ultra-low/flush to the wall, allowing the new oven to slide completely back into the cabinet cavity. 3. Connecting the new 90cm dual-fuel cooker (cooktop is gas, ovens are electric) using an approved flexible hose. 4. Testing the system for leaks and issuing a QLD Gas Compliance Certificate. Photos of the current floor-mounted gas connection, and photo of the proposed new gas stove are attached. Flexible on timing to align with delivery. Please state your gas license number when making an offer.

Washing machine Bosch Serie 8 has error code 18, the seal for the filter needs replacing

Old door seal is ripped and water leaks when doing a washing cycle. I have ordered the new replacement part for it. I thought it would be straightforward but think there’s a bit involved to it so would rather get someone who knows what they’re doing to fix it flexible on price so please just make an offer. I Have included model in pictures

Hi, I have recently moved and for some reason my washing machine doesn’t appear to be getting cold water now. . Not sure it was put in correctly by removalist. I believe the cold water tap is on. Just need someone savvy who knows washing machines to play with the tap and check back of machine to see if can get cold water going. If major issue I’ll get an official repair person. Hoping a very quick job.

The work needed is: -Relocate current toilet and sink -Install and connect a toilet and sink in the new room. -water connection for a washing machine -Connect laundry sink We have a house on stumps so it should be easy access. I have attached a picture of underneath the house to give you an idea of what you would be working with. The small red dot is approximately where the sink is and the large is roughly where the toilet waste is. I have also attached a rough plan of the area to be done.

I'm looking for someone to take away our old washer, install our new washer, and take away all the packaging etc.

I need someone to drill neat holes through laundry cabinetry so washing machine inlet and drainage hoses can pass through properly. Job is in Chermside West. You’ll need to bring your own tools, including suitable hole saw/drill bits for cabinetry. Looking for someone who can make the holes cleanly and in the right position without damaging the cabinetry. Task includes: Assess where holes need to go Drill holes for washing machine hoses Keep finish neat and tidy Clean up any sawdust/mess afterwards Please include your availability and experience with similar cabinetry or laundry installation work.

Washing machine repair needed (Bosch Serie 8) Location: Chermside West QLD Issues: - Door cannot be opened - Machine cannot spin or drain properly - Possibly water stuck inside Looking for someone experienced with Bosch washing machines. Please include inspection and repair quote.

My dishwasher is showing an error message which is indicating a drainage problem. I assume there is a blockage.

I'm looking for someone to come and install my washing machine. I tried to figure it out myself but I'm confused 😅. It just needs to be connected to the water supply. There's also some water coming from under the washing machine somewhere, I'd really appreciate it if someone could take a quick look under there and help figure out what's going on/fix it. Please bring any tools needed. Would prefer it done as soon as possible. Thank you! :)

Dryer needs lifting on top of Washing machine, into stacking kit which is installed