Hire a trusted gas stove repair and installation service in South East Melbourne

I have two Bosch gas cooktops, both having a wok ignition head in fault. The first one is Bosch PCR9A5B90A/01. It sparks well but the old ignition head ceramic has cracked. The second one is Bosch PCR915B91A/40. The centre wok burner has no ignition spark, while the other four burners spark normally. I already got both the replacement parts from the official store. Need a gas-fitter to put the new ones on.

Plumber needed to disconnect gas cooktop, seal gas supply.

I am planning to replace the old gas cooktop, rangehood and dishwasher. I would like a quote for installation of all three of them with removal of old appliances before I made an order.

Remove and cap off gas cooktop as we are upgrading to induction. Compliance certificate to be included in quote please. Drawers under cooktop can be removed for accessibility.

Need to replace 55cm gas cooktop with 90cm induction cooktop. Caesarstone benchtop needs to cut to fit. Gas disconnecting and capping plus provide safety certificate. Electrical connection and installation plus certificate. My house is a single story weatherboard type house and cooktop and main switchboard located same side of the house 12m apart. Electrical connection upgrade may needed. Please see photos attached. Thanks

Hi The large burner flame goes off and smell of gas after.

Install a gas cooktop and remove cupboard above cooktop for compliance.

Need to change gas stove top 600mm

Need a gas cooker disconnected.

We've purchased a new stove and want to replace our old stove. Need someone to cut the stone and install the new stove

Details : Require "only labour" to disconnect and remove existing cooker and install a freestanding 600mm cooker with gas cooktop and electric oven, which I will supply.The job includes: - 1) Install the supplied freestanding - gas cooktop and electric oven . Note: gas connection exists but electric line has to be run through from the board) 2) Levelling and securing the appliance 3) Testing all burners for correct operation 4) Test the electric oven 5) Checking for gas leaks upon completion Location Mount WAVERLEY, Victoria. Please quote for "labour only"

Details : Require "only labour" to disconnect and remove existing cooker and install a freestanding 600mm gas cooker with gas cooktop and gas oven, which I will supply.The job includes: - 1) Install the supplied freestanding gas cooktop and oven to existing gas outlet (natural gas ) 2) Levelling and securing the appliance 3) Testing all burners and oven for correct operation 4) Checking for gas leaks upon completion Location Mount WAVERLEY, Victoria. Please quote for "labour only" Regards

A 5-burner, 900mm gas cooktop is making a 'tic'tic' sound continuously when the electric ignition is turned on. A repair of this issue and servicing of the unit is required

I have a gas cooktop where 3 out of 4 burners work perfectly. However, one specific burner is not sparking/igniting automatically. Note: If I use a manual BBQ lighter/match, the gas flows fine and the burner lights up safely, so the gas line is working. It seems to be just the individual ceramic igniter pin or wire for that specific burner that needs fixing or replacing. Looking for an experienced appliance repair technician to come diagnose and fix/replace the faulty igniter part.

Replace the existing gas cooktop with the new one.

Need new 60cm cooktop to be installed. Gas pipe redirected behind plaster

Hi everyone, I am looking for a licensed plumber or gas fitter to permanently disconnect and cap the gas line to my broken cooktop so I can safely have an electric induction unit installed later. My current setup is a standard 60cm gas cooktop sitting directly above a Westinghouse electric wall oven. The gas is currently turned off at the main valve and the benchtop is laminate. I need you to safely disconnect the broken gas cooktop and permanently cap the gas pipe behind the oven. You will also need to test the line to ensure there are absolutely no leaks and issue a VBA Gas Compliance Certificate, which is mandatory for me to proceed with the electrical stage. Please leave the decommissioned cooktop sitting in the benchtop cutout once disconnected. My electrician will remove and dispose of it later to ensure dust and debris do not fall into the exposed oven casing in the meantime. You do not need to do any physical removal or electrical work. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week. Cheers, Sean

I need a compliance check for gas + fixes needed if required. Quote is for compliance check and fixes will be separately managed as needed

Need to remove gas cooktop, seal the gas pipeline and install electric cooktop if require installing new socket

One of the burners on my gas stove is not working with the ignition button - the built-in igniter doesn't ignite correctly and keeps sparking non-stop when I turn the switch on. The brand of the stove top is Bosch. Located in Springvale