Hire a trusted gas stove repair and installation service in Melbourne

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – in my apartment located in Melbourne CBD. • New cooktop is already onsite and already fitted in.

Smeg gas stovetop / cooktop needs servicing - large burner flame runs too big. Apartment building. Price is just a placeholder - open to all fair offers and will pick the best offer with the best experience.

A lot of water spilt onto my gas stove yesterday morning and since then it hasn’t turned on. Was hoping it would have dried out overnight but sadly didn’t so would appreciate the help of a trained technician to come and fix it !

Hi there I have an existing 54cm gas upright which needs to be removed as the gas supply has been cut to my apartment. I shall organise a plumber to decommission. I need a cost effective solution to fill the gap once the oven goes. I was thinking a cupboard.. I don’t want to over capitalise but want it to look right.

Gas stove burner wont stay lit

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – WHG640SC in my apartment located in Melbourne CBD. Details: • Location: Melbourne CBD (easy access, lift available) • New cooktop is already onsite It needs to be done on 03 December late afternoon Thanks!

Two of the burners on my SMEG cooktop are not working. The large one has gas coming out and lights up but doesn’t stay on and the smallest one has an issue with the corresponding knob not being able to be turned in order to release gas.

After a licensed plumber or tradesperson to do a gas stovetop repair. Will explain task in more detail upon connection with Tasker.

Need an over and cook top (single unit) disconnected from the gas.

Qualified person to remove Miele gas stove top and replace with stainless steel Smeg stove top (already purchased) Old stove top cracked so needs replacing

Smeg stove: one gas stove top burner ignites and there’s a flame that flames 70% of this one burner, but fails to remain on when hand is removed from ignite button. Burner has been cleaned although the problem is still there.

The stove brand is B&S. There are 2 burners is not working and need to be fixed.

Need fitted kitchen altered so as to be able to fit bigger gas stove

One of the burners on the stove isn’t staying lit. Flames will come on and it will ignite but as soon as you stop pressing the ignite it will stop.

We habe a Westinghouse WFEP917DSD—a 90 cm dualfuel (gas cooktop + electric oven). The two right hand burners dont stay lit once you stop pushing in the knob. I assume its a thermocouple / flame detector issue... Need someone to come fault find and repair. Would prefer OEM parts to be used. Thanks!

Our Andi gas stove and oven require repair for some functions. Gas stove: the bottom two knobs don’t turn (have tried pliers and grease). Also, the pilot doesn’t work to ignite - we’re using a lighter for the three sections where we can turn on the gas. Oven: most of the functions work, except for the first two (turning the knob anti clockwise). See photos attached. Qualified professionals only thanks.

I have had some kitchen renos and need. Gas stove reconnected. Also need new sink properly installed. Its in place but tap isnt secure and needs to be connected to water and drain etc.

I’m in Moonee Ponds and I need a new oven/stove connected and the old one disposed of by a qualified electrician.

The cooktop is a 4 burner Smeg - only one is not sparking and cannot be used. The task is for the repair of the defective burner. Flexible with the time and date but I need it done sooner than later. Melbourne CBD close to Queen Victoria Market.

I have an electric 4 burner stove top and needs to be replaced with 4 burner gas top. Gas line is available underneath. Plumber will need to get gas fitting pipe approx 1.5 mtrs to connect the burner to gas outlet. The cut out is fit to size and the gas burner should slot it (already checked)