Find a reliable appliance technician in Adelaide

Please help install a new washing machine - LG Wash tower (stacked washer/dryer) - 130kg, 600mm (w), 1650mm (h) I bought this new machine from LG official website, however, LG does not offer installation service in Adelaide (annoying). I need someone to help Power/taps available already, so no further power/plumbing works required.

I need a technician to repair my dryer. It’s not drying the cloths properly.

We have an IKEA brand integrated dishwasher that has broken. We have ordered a replacement that is delivered on Thursday May 1. We need the new dishwasher installed, including front cabinetry part. Replacement machine is a Bosch. Spec sheet in pictures.

I have a yiros machine i want to convert to lpg

Install and setup four riolink cameras, nvr and door bell (all hardwired). Including attaching them to the external walls. Includes an Ethernet connection.

The water filter leaking ， need tightening, waste water hose also leaking, need tightening

Our Miele microwave stopped heating and then on a certain setting it started smoking. We believe it may need a part replaced, we would like you to be experienced with Miele microwaves to advise the issue, replace the part or tell us it’s a goner.

A part of the washing machine hose is stucked to the tap and its very had to loosen

Remove old clothes dryer from laundry wall, hang new clothes dryer

Recently bought an armotech f100 functional trainer. On the left side of the machine the cable system is faulty. This is because as the system goes above the weight stack it clashes with the aperture as it re-enters on the contraction of the movement. Looking for someone who can possibly rebuild this section of the machine so it is correct.

Lounge Gas heater which is no longer in use needs to be disconnected and gas line shut.

I have a cc camera connected to an outlet inside the house. Need help to install it outside and run the camera wire through the nbn pipe to keep adapter connected inside. Camera model Tp Link tapo c200

I am currently waiting for an electrician to confirm if power can be installed at the back of the shelves before proceeding with this job. I am unsure whether the existing shelving unit can be reused, or if new shelving should be built. The current space consists of 2 shelving units. The lower shelving unit is approx. 1465mm high and 945mm wide, and sits about 150mm above the floor, with a skirting board below. Above this is another shelf unit that is to remain. It has 2 open shelves and is level with the above counter cupboards on the right The changes needed are: - The skirting board has to be removed where the freezer will sit - The sides and back of the opening should go all the way to the floor. - The floor under the freezer should be floor boards – I don't know whether this is currently the case or if it is just concrete - There will be approx 300m width additional space to the side of the freezer where I would want open shelving - see diagram

Need a combustion heater Flue kit installed. Needs to go next to where a previous gas heater was based and has access to the ceiling and roof (see images). Have full kit ready to be installed and combustion heater in place. Gap between ceiling and roof line approximately 50cm. Tiled roof but any tile alterations (trimming etc) will be done. All kit ready to go. Just need someone who’s done this before.

We recently moved into a new home with a four-burner Euromaid gas stovetop, but three burners won’t ignite at all, and the fourth is extremely difficult to light. We suspect the ignition and spark components need replacing. We’re happy to source the necessary parts but need an experienced gas appliance technician or handyman to: • Diagnose the issue • Install new ignition/spark components (if needed) • Ensure all burners ignite and stay alight Looking for someone with experience in gas stove repairs. Please provide availability and a quote.

Gillies Plains Job: Will need two security cameras installed. At front & Back door. This is for an elderly pensioner, so assistance in connecting to his wifi, download the app on his phone & set up for him. The two cameras are the Genbolt Model name GB217H Battery & Solar Run No cables required Early Morning ASAP please

I'm looking to change the Samsung washing machine's front door seal. I already have the seal with me I just need it to be replaced on the washing machine (picture of the seal attached) Also I want a broken wire fixed of the motor of rain water tank (see picture) Samsung washing machine's model Ww85k54e0uw/sa 8.5 kg

My washing machine leaks every use from the grey connection to the tap and leaks heavily onto the power below and creates a puddle in the cabinet. I cannot reach to tell if it’s just a tightening issue or needs a new connection part or tape so I need that looked at to stop the overflow

Need a handyman to swap over 6 WiFi access points with new access points. The existing access points slide off and you undo 2 screws to remove mounting plate... Then install new mounting plate in the same spot with 2 or 3 screws.. And slide in new access points... What you need is a ladder... And a Drill... Our preference is to do this starting after 5 pm on a weekday or weekend... No wiring work. Involved... Maximum 2 hours work..

Looking for a professional to install 4 wireless security cameras and a video doorbell at my home. Requirements: Must be fixed securely to the wall by a professional with the necessary tools. House Type: Steel frame construction townhouse (please advise if this impacts the installation). Details: Cameras and doorbell are wireless, Eufy brand; installation involves mounting them and ensuring they are operational. Please provide a quote and your availability.