Find a professional local carpenter in West Sussex

We have a large fitted wardrobe which currently isnt fit for purpose and has lots of dead space. We're looking for a simple solution to maximize the space, would like Ia mix of IKEA and custom fit.

Two nearby properties in Brighton slash Rottingdean. Ideally, same day if possible 1. Fit four hinged solid oak shutter panels approx 2.1 meters high by 36 centimeters wide. Fitting in front of a glass terrace door, wall is not solid masonry, storage space behind. Existing door handle may clash, so please advise on recessing the shutter or using a lower-profile handle. Prioritize shutters closing flat to block light. 2. Separate small job at nearby property in Rottingdean. Check repair or adjust shed door so it closes and latches properly. Thank you!

The hallway outside my flat is always on and at night the light comes in the flat through the glass of my door. We want to prevent this. The solution would be to cover the glass of the door, by putting there a couple of wood or laminated material with the appropriate measurements so the light can't pass. Not sure if I am explaining myself well sorry... :D

I need someone who can fix a poor, rather bodged job fitting the doorknob to my kitchen door. Because they didn’t line up the holes they drilled with the fittings and fixtures, one doorknob has never properly worked.

Put cardboard box on worktop and this appeared

We are looking for an experienced decorator/plasterer to apply a thin skim coat of wood filler to the exterior timber facade of our shop in Chichester. Scope of work: All visible plywood/timber panels shown in the photos require a thin coat of wood filler. Existing joints and screw holes have already been filled. The objective is to achieve a smooth, uniform surface ready for sanding and painting. Wood filler material will be supplied by us. Tradesperson must bring their own hand tools (filling knives, trowels, hawk, mixing equipment if required, sanding blocks, etc.). No painting required. No materials required other than labour and tools. Important: This is not a thick plaster coat. Only a thin skim of wood filler across all timber surfaces. Care must be taken around glazing, frames and finished surfaces. Please provide examples of similar preparation/filling work completed previously. Estimated facade area: approximately 35–40 m² of timber surface requiring skim coating.

ripping out built in cabinets (boiler located in one of them so that one will need to stay) and built in desk in a small nook room. we want to turn the small room into a walk in wardrobe, so possibly fitting a couple of rails to the emptied walls if we get rails of the right dimension in time, but if not then just the ripping of a couple of built in cabinets and a desk!

Downstair toilet decoration with wood panelling and wallpaper. All materials available

Need to fix a integerated door or replace it

We have two that need building

I have a undersink cabinet which is a standard size, it’s slightly too big for my area because of a pillar, need someone who can trim the edges to make it fit somehow , thanks.

I need 3 x plywood panels which are braced at the back. These are for paintings. The front painting surface needs to be reasonably smooth.

See the picture. Those to be collected and thrawn away

To change kitchen cabinet pannels (4), 3 corner posts and plinth. They will need to be cut to measure I have started changing the doors, see imagine for items in light green that will need to be changed

I need a cabinet built and help with a shelf that I built. The cabinet I ripped a screw out making the whole bigger so just need help repairing this

Hi Pawel, Best to park on meadway road and enter via the rear garages

remove old and Install new Kitchen sink waste Stainer

I need a cabinet built and put up on a bedroom wall

Retiling and carpentry build access point and then sealant around bathroom areas

Custom built furniture install in camper van it’s an L4 / H3 which had had custom furniture made. Before the furniture installed I need the diesel heater and electrics, plumbing fitted. Furniture not ready until so November so plenty of time for preparation - cost negotiable