Find professional local plasterers in Sydney

two areas of 9 m2 each . T fix gyprock pieces around edges of full sheets, plaster all and sand all. Gyprock sheet material at premises.

Have x 2 bathrooms that require venetian Plaster to walls and ceilings, approx x 4 fell height walls and ceiling in one bathroom and x 8 walls (half height) and ceiling in another bathroom

Looking for someone to: - remove the gyprock partition and architrave as pictured (waste can be left on site) - patch the rear wall as required where the partition was, and sand ready for painting (do not need to paint) - patch the ceiling where the exhaust fan is and sand ready for painting (do not need to paint) - install new floor tiles where the partition was. Spare matching tiles supplied. This part of the room is not waterproofed. Waste can be left outside as a skip bin for other work will be ordered in a few weeks. Many thanks.

Supply and fix studs to brick wall. Supply and hang 10mm plaster around light fittings and smooth joints. Approx. 6 x 2400mm sheets needed. Only RHS of diagonal light to be done. Approx 6m x 3m minus completed section LHS of diagonal light

We need an experienced mirror/glass installer to cut and install 3 large mirrors at our physiotherapy clinic. Each mirror already has the Z-clip attached, but we do not have the wall-mount brackets, so you will need to supply and install the matching brackets. Mirror details: • 3 × mirrors — 3015mm × 709mm, approx. 5mm thick • Mirrors already onsite (no pickup needed) • Installed using Z clips – top clip load-bearing, lower clips to keep mirror flat • Manufacturer measurements for clip heights and spacing provided Installation surfaces: • 1 × brick section • 2 × gyprock sections Installer must supply correct fixings for both. Scope of work: • Supply matching Z-clip wall brackets • Measure and cut mirrors if required • Install brackets at correct heights • Hang all mirrors flush, level, and secure • Ensure minimal bowing using additional clips Manufacturer notes: • Mirrors sit 5mm off the floor • Clips #2 and #4 are non-load-bearing (prevent bowing) • Diagrams of clip positions available Location: Strength and Pilates Physiotherapy G 103 Foveaux Street, Surry Hills (ground floor) Requirements: • Experience installing large gym/studio mirrors • Own tools, brackets, fixings, adhesive if needed • Ability to cut mirror cleanly • Professional finish essential

Need 85 inch tv mounted to plasterboard wall tomorrow at 1pm

Hello Please provide a quote to complete the work, include materials within your price. We are in Mascot, NSW 2020. Thank you! ——————— Just had a sliding door installed and need help restoring the recess on both sides and floor. Render/plaster finish, with beading edge for the corner. Gaps in floor needs to be filled and smooth finish, ready to paint. H - 2.10m W - 1.80m

The removal of a burn mark on the kitchen bench and would like the surface restored back to its original color.

Small Hole needs patching in wall.

1*1.2 meter wall plaster work.

Secure ceiling plaster and fill gap

Hi, I’ve just demolished an internal wall and now need a gyprocker or plasterer to: • Patch and repair wall and ceiling gaps • Re-sheet and flush joins • Sand and prepare for painting There are some areas with exposed brick and framing that need neat finishing. I can send through photos for reference. Please let me know your availability, quote, and if you can come by this week for an inspection. Location: hillsdale

We need to have a 2.1m half wall plaster repaired at the edges and raised by about 5 cm, so it lines up with our kitchen cabinets for the upcoming stone benchtop installation

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

ofter pulling a 3M sticker off the wall I removed the layers of paint - roughly 1 x 2 inches and two small pin holes need filling and painting

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

I have an original plaster cornice that is starting to come loose. the cornice is intact, however needs to be fixed back into place. I want to keep the cornice as its original and matching the rest of the house. House is in Surry Hills 2010, Im not sure what sort of trade I need to do this, maybe a plasterer? Would love this done this week before it comes down or breaks under the flexion thanks so much. Photos attached.

Job: Cut approx 1m (or less) Channel in Brick Wall + Install Conduit + Render Back to Smooth Finish Hey everyone Always had a good Airtasker experience Just had my TV hung on the wall I’d love an approx 1 metre vertical chase (channel) cut into an internal wall (brick) to run TV cables (sealed power/AV leads) from the floor up to a wall-mounted TV. Scope of Work: • Cut a neat 1m channel into brick wall (approx. 20–25mm wide, 20–25mm deep). • Supply and install PVC conduit for the wires • Secure conduit with saddles/clips inside channel. • Patch and render back over channel so the wall is flush and ready for paint. Happy to do the painting myself :-) • Finish should match existing wall as close as possible please (smooth render, not a lumpy patch job). I’m happy to handle final painting, I just need it rendered smooth and ready. Job Location : Surry Hills

I need someone to repair the drywall in my apartment. I would’ve done it myself but honestly do not have time to make any mistakes so getting it done professionally is better. Please let me know if you can repair this and paint it for me over the weekend (6th and 7th Sept). Parking is available at the site

​I need a skilled and experienced professional to repair some peeling paint . The issue is in bathroom ceiling and it appears to be caused by a small leak Probably need to ​craping off the damaged and peeling paint. ​Repairing the bubbling drywall to create a smooth, even surface. ​Priming the area. ​Repainting the section to match the rest of the wall/ceiling. Paint not provided