Find professional local plasterers in Inner West Sydney

Contractor required to supply and install gyprock panelling for rear wall of garage. Dimensions: 1950 ht x 2600 width. We have removed existing gyprock to provide access for brickwork repairs. Now we need it replaced. Edges of old gyprock shall be removed. Neat interface on the four sides expected with smooth finish ready for painting by others. Sanding of paper not required. Skirting board not required. Contractor to supply all materials. Clear access will be provided. Prefer early morning start.

2 small cutouts in gyprock wall. We have the initial cut outs. Just need to replace, fill, sand and paint

We have cut a couple of walls in a small bedroom which is 3mx4m and out in a few raked pockets. Need the new parts gyprocked, will need furring channel on one part as ceiling rafters are not even. I would also like to remove existing cornice and square set. The photos were taken whilst builder was still here so now it’s finished. I put in small budget as I don’t know how much this work will cost and would like quotes.

I’ve already run all the Cat6 cables through the ceiling to the exact AP locations. I need someone to mount two Ubiquiti access points on a gyprock ceiling (approx 600g each). Proper ceiling-rated anchors or fixing into timber will be required — the included plastic plugs aren’t suitable. I also need one external Ubiquiti access point mounted on a masonry wall. The cable is already in the ceiling above that location and can drop straight down behind the unit. No cabling work required — just mounting and securing the three APs. photos show the two ceilings and one external wall

Hi! We’re moving out of our home on 9 March. Before then we’ll need help to remove all the screws in the walls we used to install paintings etc and patch up plaster (double brick federation home). Qty: Room 1: 1 painting Room 2: 3 paintings Room 3: 5 paintings Room 4: 2 paintings Room 5: 1 painting

Gyprock plaster to seal old chimney hole

A small hole needs to be fixed internally in a bedroom and painted (not the whole room) worst case I can paint Silicone around kitchen bench … silicone supplied

Hole cut by plumber in ceiling, and small amount of sagging in adjoining sections. About 2.5 x 2.0 m in total affected. Needs repair, with provision for one downlight, and painting.

Need someone to set gyprock on day labour, will add images

Patch 3 observation holes in plaster ceiling including resetting flush light fitting.

Have 3 holes on wall to be ready to patching

Hi, I am looking for quotes to plasterboard my sunroom. It’s around 8sq/m. See attached rough diagram and photos. I will be adding timber sills and reveals so you would only be plastering up to the timber. There is one return needed on Wall 1 into the window. There is a ceiling gap that needs to be filled to join new plasterboard.

Trying to finish the small elements of the house before we break for Xmas. Had new windows replaced and as a result some of the wall needs to be re-Gyprocked then it will need to be patched and then painted. some rooms have only small amount of patching required so I can probably use filler. In the other rooms, need more extensive Gyprock. keen to get this completed this weekend if we can and opportunity toquote on bigger painting job which includes the front of our house and the sides of our house

Patch Gyprocker rectangle 1m x .6m Please look at photos The cutout is there. You will be required to put support behind to secure cutout. You will need to plaster. I can sand given the time to dry.

My electrician has to move the rangehood to the front of the box. I need help with patching the hole it will leave.

Ceiling fans have been installed but there are patches and holes that need painting. We need to plaster the holes and paint only the unpainted areas. Please provide the paint.

Repair or replace ceiling Gyprock in 1 room approx 3.8x3.8

Need gyprock for ceiling in bathroom. 165cm x 180cm (3m2) and extra little 30cmx30cm hole patched up too thank you. Much appreciated if this can be done before December. Images attached

Need a qualified plasterer to: Supply and install (1.7m x 0.7m) section of 15mm gyprock ceiling board (from previous aircon access). Tape, set and sand smooth (ready for paint, but painting not required). Build/install small manhole (example photo attached) with access panel for future aircon servicing. Ceiling height is standard and easy ladder access. Please include materials in your quotes. Photos attached.

Dyson vacuum mount on wall was fixed with 2 plaster mounts and has since fallen off wall, there is an inch or so behind 10mm plasterboard and then brickwork. Would like the holes filled, but doesn’t need to be pretty as it will be covered by Dyson mount. Remount with better plasterboard mounts or mount to brickwork behind, place slightly above or below if you need new plaster just keep it hidden with the mount.