Find professional local plasterers in Sydney

Hi, I’m looking for an experienced handyman to install a 900 x 600mm arched LED mirror on a plasterboard wall in my bedroom in Forest Lodge. Scope of work: Check and scan the wall for electrical wiring and plumbing before drilling. Supply and use appropriate plasterboard fixings/anchors suitable for an LED mirror Install the mirror securely, level, and aligned Bring your own tools and wall scanner/stud finder The mirror is designed for bathroom use (IP44 rated) and will be mounted vertically. Please let me know if you have experience installing mirrors and LED mirrors. Happy to share photos of the wall and mirror if needed.

I have 4 pieces of artwork I need hung. 2x sets of two. So they will need to be measured and hung symmetrically etc the walls are plasterboard so will need correct equipment to secure them.

I had a floating tv unit mounted and they put 2 holes in the gyprock wall, one behind the tv to run the tv cable down to the other hole, they weren't able to run the cable down due to insulation, needed a flexible cable rod or something

Hi there, I’m looking for a handyman to help with a couple of jobs in my apartment. Job 1 – Roller Blinds I attempted to install zero-gravity roller blinds but couldn’t drill far enough into the concrete wall (due to lintel) to securely mount the brackets. Blinds are already on site and measured — they just need proper installation and adjustment (installed right now but not a great job) Job 2 – Ceiling Repair & Painting We recently had ceiling fans installed and there are some holes / damage in the ceiling drywall that need repairing. • Patch and sand ceiling drywall • Paint the repaired area (paint supplied) Notes: • You’ll need your own tools (hammer drill, masonry bits, patching tools, etc.) • Paint will be supplied • Apartment is on 3rd floor - no lift Ideally looking for someone experienced with blind installation and minor plastering/painting. Happy to answer any questions

I’m looking for an experienced plasterer / carpenter / partition installer to build a fixed internal metal-stud plasterboard partition wall to enclose a study area in my apartment. Scope of work • Construct a straight internal partition wall using light-gauge steel (metal) studs and tracks • Approx. 2.7m high x 1.2m wide • Plasterboard both sides • Flush, paint-ready finish (set, sanded, square edges) • No door, no window, no electrical work required • Wall securely fixed to floor, ceiling, and adjacent wall • Clean, professional finish suitable for a living area (no painting required, I have claddings) Materials • Please include materials in your quote • Standard internal metal studs & tracks • Plasterboard thickness as per Australian residential standards (happy to follow your recommendation) • All fixings, corner beads, compounds, and consumables included Site details • Apartment in Zetland • Non-load-bearing internal wall • Ceiling height approx. 2.7m • Easy internal and lift access/ loading dock Timing • Flexible start date before xmas • Prefer completion in one visit if feasible What I’m looking for • Experience with metal-stud plasterboard partitions • Photos or examples of similar work preferred • Neat workmanship and attention to detail

Need a labourer to help with putting up gyprock. Just someone that can pass tools, boards etc to a builder - 2 days

Two small jobs in one: 1) Remove bottom 15cm of 275cm brick wall (loose as seen in pictures) and apply new render. No painting needed. 2) Apply new plaster to 120cm x 90cm area in bedroom where it fell off. Area includes on ceiling light and one edge as pictured. No painting needed Note: budget and scope is both jobs, do not want to separate. Preference is for job to be done after January 8th.

I have a victorian terrace that has had some water damage through brick wall under stairs. This has happened over last 3 years. Now want it replastered with water seal and painted please.

Need to mound a 42 inch on a gyprock wall, I have purchased the Wall mount from bunnings

I had two built-in in robes removed (eg one in each bedroom). The installer used liquid nails on some elements which took off the wall render where it was affixed. To install at parts of the robe they have also trimmed out the skirting board to make elements fit flush to the internal wall. It would be great to get a quote from you to 1) make good the rendering 2) paint the walls from behind the cupboards to match the new wall paint (I'm happy to supply this) 3) remove the skirting behind these areas where new robes will be coming in) 4) plaster or make good where the skirting is removed to create an even wall surface / no gaps between the walls/ flooring 5) infill a small portion of the skirting on the short wall where the new robe is going in. The removed robe was deeper and the skirting has been cut out at the front so will end prematurely. Would be great to fill this in 6) treat the skirting so it looks like a uniform finish I can send photos etc if the area. I'm not sure where you're located but I'm in Newtown, happy to do a site visit for a quote. My only constraint is I have the new robes arriving on Friday so I would really like to get this done in the next couple of weeks as my house is quite small so I keen to get the robes in and use the storage!!

I have a damaged gyprock wall around a service shaft in a bathroom that needs to be repaired. Using aqua check as it’s in a bathroom

Need 85 inch tv mounted to plasterboard wall tomorrow at 1pm

Small Hole needs patching in wall.

Hi, I’ve just demolished an internal wall and now need a gyprocker or plasterer to: • Patch and repair wall and ceiling gaps • Re-sheet and flush joins • Sand and prepare for painting There are some areas with exposed brick and framing that need neat finishing. I can send through photos for reference. Please let me know your availability, quote, and if you can come by this week for an inspection. Location: hillsdale

We need to have a 2.1m half wall plaster repaired at the edges and raised by about 5 cm, so it lines up with our kitchen cabinets for the upcoming stone benchtop installation

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

ofter pulling a 3M sticker off the wall I removed the layers of paint - roughly 1 x 2 inches and two small pin holes need filling and painting

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

I have an original plaster cornice that is starting to come loose. the cornice is intact, however needs to be fixed back into place. I want to keep the cornice as its original and matching the rest of the house. House is in Surry Hills 2010, Im not sure what sort of trade I need to do this, maybe a plasterer? Would love this done this week before it comes down or breaks under the flexion thanks so much. Photos attached.

Job: Cut approx 1m (or less) Channel in Brick Wall + Install Conduit + Render Back to Smooth Finish Hey everyone Always had a good Airtasker experience Just had my TV hung on the wall I’d love an approx 1 metre vertical chase (channel) cut into an internal wall (brick) to run TV cables (sealed power/AV leads) from the floor up to a wall-mounted TV. Scope of Work: • Cut a neat 1m channel into brick wall (approx. 20–25mm wide, 20–25mm deep). • Supply and install PVC conduit for the wires • Secure conduit with saddles/clips inside channel. • Patch and render back over channel so the wall is flush and ready for paint. Happy to do the painting myself :-) • Finish should match existing wall as close as possible please (smooth render, not a lumpy patch job). I’m happy to handle final painting, I just need it rendered smooth and ready. Job Location : Surry Hills