Find professional local plasterers in Sydney

White setting outside ceiling and wall. $400-$500 depending on experience.

Plaster a 5m x 2m wall. Believe it is stone and is quite uneven. Also open to putting plasterboard over - whatever is easiest. Unsure what this will cost for time and materials so please advise.

Meed a gyprock wall floor to ceiling

Need a small box built to cover an exposed pipe. The box will have two 90° corners, a vertical bulkhead to run around, and needs to join the bottom of the bulkhead. Photos of the piping are provided. The other part is a gap in the bulkhead that was an access point needs covering ready for painting. Approx. size for gap in bulkhead: 600–500mm. It’s not the one in the picture. Forgot to get a picture of this. Requirements: • Material: MDF preferred (gyprock may be needed for bulkhead section) • Smooth, paint-ready finish • Screw/fill and sand holes Skills needed: Carpenter / Drywaller with experience in small boxing or feature walls. Happy to pay for materials separately upon receipt.

approx. 360 x 420 cm new ceiling required

Insert three small pieces of gyprock that were cut for air conditioner installation. Repair gyprock pieces, sand and paint wall.

There is a gyprock wall, need to patch and paint a cut out of 50 mm x 50mm. Need to be done today before 5 pm. Paint available on site. The card reader will be moved, hence we need to patch

Looking for a builder/plasterer to repair part of the ceiling after a pelmet was removed. Ideally a seamless finish with the remainder of the roof. Also looking to have something similar done in another room, but that just needs levelling or redoing.

We’re moving out of a rental after 8 years and are looking for an experienced painter and wall patcher / plasterer to help get the walls back to a good, presentable condition. There are various marks, small holes, dents, and scuffs across the house from general wear and tear, hanging items, and a dog (some scratching on doors). This is very much an end-of-lease tidy-up, not a full repaint. The job is for 8 hours total, focusing on getting as much done as possible in that time rather than aiming for perfection. Property details: • 3-bedroom house • House will be completely empty • Walls + some doors need attention What’s included / not included: • ✅ Paint will be supplied (matched and ready) • ✅ Drop sheets provided • ❌ You’ll need to bring your own tools (brushes, rollers, buckets, sanding tools, etc.) • I will patch what I can the day before so it has time to dry Timing: • Monday 2nd February • Ideally 9:00am – 5:00pm (or as close as possible) Important notes: • This job is based on time, not a fixed outcome • We understand that repairs and painting don’t always go perfectly from A → B • Photos of example damage will be attached to give a clear idea of the work involved Looking for someone reliable, efficient, and experienced with end-of-lease repairs.

Hi there 👋 We’re looking for an experienced painter / plasterer to repair a small section of wall in our home in Redfern, NSW. Scope of work: • First-fix the wall (minor repair / prep) • Plaster the area properly • Sand smooth once dry • Paint the repaired section to match existing wall It’s a small job, not a full room. We estimate around 3–4 hours total for someone who knows what they’re doing. What we’re looking for: • Someone experienced with plastering and painting • Neat, professional finish • Own tools preferred • Bonus if you can colour-match or blend paint nicely Budget: 💰 $350 total Happy to review offers and photos of past work. Location: 📍 Redfern, NSW Let us know your availability and experience. Thanks!

Need a labourer to help with putting up gyprock. Just someone that can pass tools, boards etc to a builder - 2 days

Experienced plasterer required for Garage ceiling and walls that have just been gyprocked. Needs to be plastered and base coat done to prepare for painting. Square set finish sufficient. Estimate a day's work

Need to mound a 42 inch on a gyprock wall, I have purchased the Wall mount from bunnings

I had two built-in in robes removed (eg one in each bedroom). The installer used liquid nails on some elements which took off the wall render where it was affixed. To install at parts of the robe they have also trimmed out the skirting board to make elements fit flush to the internal wall. It would be great to get a quote from you to 1) make good the rendering 2) paint the walls from behind the cupboards to match the new wall paint (I'm happy to supply this) 3) remove the skirting behind these areas where new robes will be coming in) 4) plaster or make good where the skirting is removed to create an even wall surface / no gaps between the walls/ flooring 5) infill a small portion of the skirting on the short wall where the new robe is going in. The removed robe was deeper and the skirting has been cut out at the front so will end prematurely. Would be great to fill this in 6) treat the skirting so it looks like a uniform finish I can send photos etc if the area. I'm not sure where you're located but I'm in Newtown, happy to do a site visit for a quote. My only constraint is I have the new robes arriving on Friday so I would really like to get this done in the next couple of weeks as my house is quite small so I keen to get the robes in and use the storage!!

I have a damaged gyprock wall around a service shaft in a bathroom that needs to be repaired. Using aqua check as it’s in a bathroom

Need 85 inch tv mounted to plasterboard wall tomorrow at 1pm

Small Hole needs patching in wall.

Hi, I’ve just demolished an internal wall and now need a gyprocker or plasterer to: • Patch and repair wall and ceiling gaps • Re-sheet and flush joins • Sand and prepare for painting There are some areas with exposed brick and framing that need neat finishing. I can send through photos for reference. Please let me know your availability, quote, and if you can come by this week for an inspection. Location: hillsdale

We need to have a 2.1m half wall plaster repaired at the edges and raised by about 5 cm, so it lines up with our kitchen cabinets for the upcoming stone benchtop installation

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.